2
CONNECTING DI
1. Remove aerator nstalled
(Fig 1).
2. Determin t: Outside
thread Fig 1); proceed
to S rrect adapter and
washer t. Tighten manually.
NOTE: Ada ich will t most faucets.
To create a ti y need to use the gasket from
your faucet’s aer dition to the washers included
with the adapters. I e adapters do not t, consult
your local plumbing or hardware supplier for assistance in
obtaining the correctly threaded adapter.
3. Screw the diverter valve onto the faucet, turning swivel
collar to tighten. Make certain that gasket (already installed
in diverter valve) is positioned securely between the
diverter valve and the faucet (or adapter). Rotate diverter
valve stem to desired position. Swivel collar may need to
be re-tightened. Place assembly conveniently next to sink.
4. Turn on water at faucet handle then turn on diverter
handle. This causes the water to ow through the lter. To
stop water ow to lter, turn off water at faucet handle,
then turn off diverter handle.
OPERATING SPECIFICATIONS:
Pressure Range: 20-60 psi (pounds per sq. in.)
Operating Temperature: 40-85°F (4.4-29.4°C)
Max Flow Rate: .5 gallons per minute
• Filter must be protected against freezing which can cause cracking of
• Please read all instructions and precautions before installing and us Water Filter.
• Filter life varies depending on lter type, usage, and water cond
• Do not install on hot water line.
• For cold water use only.
• The system has a limited service life. Changes in taste eing ltered indicate
that the unit should be replaced.
• The contaminants or other substances removed necessarily in your water. Ask
your local water municipality for a copy of t
• After prolonged periods of non-use (suc nded that the system be ushed
thoroughly. Let water run for 5-6 min
WARNING: Do not use with water nknown quality without adequate
disinfection before or after the s
Connecting diverter to
outside threads on faucet
Remove
Existing
Aerator
Swivel
Collar
Diverter valve
Handle
Faucet
adapters
(use size
as needed)
Gasket
Adapter
Swivel
Collar
Diverter valve
Handle
Remove
Existing
Aerator
Connecting diverter to
inside threads on faucet
Gasket
Adapter
Do not use non-Crystal Quest
replacement cartridges.
Do not use non-Crystal Quest
parts or modify/tamper with unit.