Curtis CD290 Manual

Curtis CD-afspiller CD290

Læs gratis den danske manual til Curtis CD290 (4 sider) i kategorien CD-afspiller. Denne vejledning er vurderet som hjælpsom af 18 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 9.5 anmeldelser. Har du et spørgsmål om Curtis CD290, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/4
— 1 —
INSTRUCTION MANUAL
PORTABLE COMPACT DISC PLAYER
WITH 45 SECONDS ANTI-SHOCK SYSTEM
AND PLL AM/FM STEREO RADIO
— 6 — — 7 —
CD 290
DIGITAL ANTI-SHOCK OPERATION
The digital ELECTRONIC SHOCK PROTECTION function uses semiconductor
memory to prevent the second from skipping when the unit is subjected to shocks
and vibration during play.
When the PLAY/PAUSE button is pressed and the power turns on, the digital
Electronic Shock Protection function turns on automatically.
The display will show and the function is initialized, when shows in the
display, the data buffer is full.
It will give approximately 45 seconds of protection against interruption of sound output,
if the player is subjected to shocks of more than 45 seconds duration, some
interruption of sound output will occur, this is normal and to be expected, the sound
will resume once the player has stabilized from the shock.
To turn this function off, press ASP button once, the ESP indicator will disappear.
MAINTENANCE
Cleaning the Lens
If the lens becomes dusty, clean it with camera lens blower. Be careful not to scratch the
surface of the lens.
Cleaning the Cabinet
From time to time, clean the cabinet with a soft dry cloth. For more stubborn stains, slightly
moisten the cloth with water or a mild detergent solution. Never use benzene, alcohol or
other solvents as they may damage the finish of the cabinet.
SPECIFICATIONS
RADIO
Frequency range : AM 531 - 1611kHz
FM 88 - 108MHz
CD
Output Power : 20MW (32 )
Freq. Response : 100 ~ 20000 Hz
Power : DC 4.5V external and size “AA” batteries 1.5V x 2, UM-3,
HP-7, R6
Dimensions : 130mm(W) x 138mm(D) x 30mm(H)
** For improvement purposes, specification and design are subject to change without
notice. **
TROUBLE SHOOTING GUIDE
Cleaning the Disc
When a disc becomes dirty, clean it with a cleaning cloth. Wipe the disc from the center out.
Note - Do not use solvents such as benzine, thinner, commercially available cleaners or
anti-static spray intended for analogue discs.
** Should you experience difficulties in the use of this player please refer to the
following chart before contacting your dealer or the place of purchase.
— 2 — — 3 — — 4 — — 5 —
LOCATION OF CONTROLS
1. SKIP / SEARCH DOWN / TUN DN
BUTTON
2. SKIP / SEARCH UP / TUN UP BUTTON
3. PROGRAM / MEMORY BUTTON
4. MODE/STEREO/MONO BUTTON
5. BAND BUTTON
6. MEMORY UP BUTTON
7. DC JACK
8. PLAY / PAUSE BUTTON
9. STOP / OFF BUTTON
10. MEMORY DOWN BUTTON
11. OPEN SWITCH
12. HEADPHONE JACK
13. VOLUME CONTROL
14. B.B.S. SWITCH (BASS BOOS SWITCH)
15. HOLD SWITCH
CAUTION
USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES
OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION
EXPOSURE.
THIS SHOULD NOT BE ADJUSTED OR REPAIRED BY ANYONE EXCEPT QUALIFIED
SERVICE PERSONNEL.
IMPORTANT : Since movement of the CD mechanism and the sensitive circuitry may cause
interference to the radio tuner nearby, switch this unit off while operating
other radio devices.
— ENGLISH 2 —
PREPARATIONS BEFORE USING
Battery Installation
1. Open Battery Compartment cover.
2. Insert 2 batteries (LR6, “AA” size, or equivalent)
in the correct polarity as indicated.
(Heavy duty batteries are recommended.)
3. Close the cover properly.
AC Power Adaptor
1. Plug the DC output of the adaptor to the DC Jack.
2. Connect the adaptor (4.5V/600mA) to a power outlet.
Make sure the voltage is compatible.
Hold Switch
Set the Hold Switch to “ON” position, all the buttons will be locked. Before operation,
be sure to set the switch to “OFF” position, for normal operation.
RADIO RECEPTION
1. Insert the plug of your headphone into the PHONE JACK.
2. Press the BAND BUTTON for the AM or FM radio band as shown on the LCD Panel. The
frequency reading will be displayed.
3. Press the TUN DN BUTTON or TUN UP BUTTON briefly to tune in the desired radio
station manually.
4. Keep the TUN DN BUTTON or TUN UP BUTTON depressed for more than 1 second
and then release will activate the auto-tuning function of the digital tuner.
When a radio station of sufficient strength is found, auto-tuning will stop automatically
and the radio station will be tuned in. The Frequency Reading of the radio station will be
displayed on the LCD Panel . When a FM stereo program is being received, the STEREO
INDICATOR will appear.
5. Press MODE/STEREO/MONO BUTTON cyclically to select FM MONO MODE or
STEREO MODE.
6. Adjust the VOLUME CONTROL to obtain the desired sound level.
7. Slide the BASS BOOST SWITCH to 'ON' for enhanced bass effect of the radio program.
8. When you wish to turn the Digital Tuner 'OFF', press the STOP BUTTON.
Storing and Recalling Radio Stations in Preset Memory
The digital tuner has a capacity of 10 random preset stations for AM and 20 random preset
stations for FM bands which allow you to store and recall your favourite AM or FM radio
stations at the touch of a button.
A. To Store a Station
1. Tune in the station you want to store in preset memory by manual or auto
tuning.
2. Press the PROG / MEM BUTTON and the PROG INDICATOR will flash in the
LCD panel.(Press again for cancel)
3. Press MEM UP or MEM DN BUTTON to select channel no. #1 to #10 for AM and
#1 to #20 for FM, press the PROG / MEM BUTTON again to store the current
radio station into the preset memory.
4. Repeat steps 1 to 3 to store a radio station into the rest of the Preset Memories.
B. To Recall a Station
1. Press the BAND BUTTON for the AM or FM radio band.
2. Press MEM UP or MEM DN buttons to recall preset stations.
NOTES - The headphone cord works as a FM antenna. To insure maximum FM
tuner sensitivity, always keep the headphone cord fully extended. Do not
wind or fold the headphone cord while listening to the radio.
- When tuning in AM reception, be sure to place the unit in a horizontal
position. For maximum AM sensitivity, keep turning the unit slowly while
keeping it horizontal until the best reception is obtained.
DISC PLAYING
This CD player is designed to play the 8cm and 12cm compact disc without using
adaptor.
Getting Start
1. Insert the headphone/earphone plug to PHONE JACK.
2. Push the open switch to right side, and then the door open, put a disc into the
CD compartment with label side upward.
3. Push the disc gently around the centre area until it clicks so that the disc fits
into the pivot.
(To remove the disc : Pick up the disc, holding the edge, while pressing the
pivot gently.)
4. Close the door and press the Play/Pause Button once.
5. The Display will show the total number of tracks of the disc, then begin to
play the first track.
General Operation
Play/Pause Buttons — Press once to start playback in the original order.
Press again to stop the disc play temporarily.
Stop Button — Press once to stop playback.
Press again to turn off power
Skip / Search Buttons — Press once to skip to next track or back
to previous track .
— Press continuiously to search forward
or backward .
Various Playing Modes
MODE Button — There are 3 kind of function :
A. Repeat Play
During PLAY mode
• Press the MODE button once to play single track repeatedly.
• The repeat indicator
1
will appear in the display.
During PLAY mode
• Press the MODE button twice to play the entire disc repeatedly.
• The repeat indicator will appear in the display.
NOTE -To cancel REPEAT simply press the MODE button until the repeat indicator
disappears.
B. Intro Scan
In STOP mode
• Press the MODE button three times.
• The INTRO indicator will appear in the display.
• Press the PLAY button to play the first 10 seconds of each track on the disc.
NOTE -To cancel INTRO SCAN simply press the MODE button until the INTRO
indicator disappears.
C. Random Play
In STOP mode
• Press the MODE button four times.
• The SHUF indicator will appear in the display.
• Press the PLAY button, all the tracks on a disc to be played in a random sequence.
NOTE -To cancel RANDOM PLAY simply press the MODE button until the SHUF
indicator disappears.
Program Play
1. Press the PROG button when the unit is in the stop mode until PROG show on the
display.
* The PROG indicator flashing appears on the display.
2. Press or to select the desired track.
3. Press the PROG button to enter the track into memory. The program numbers
which will be increment one step.
4. Repeat step 2 and 3 to program the order of more tracks can be programmed into
memory.
5. Press to start the program play.
6. To erase the program, open the door or turn off the power.
T
U
N
.
U
P
+
_
+
_
M
O
D
E
P
R
OG
M
E
M
.
S
T
.
/
M
O
.
B
A
N
D
!
"
#
$
%
&
'


!
"
#

Produkt Specifikationer

Mærke: Curtis
Kategori: CD-afspiller
Model: CD290

Har du brug for hjælp?

Hvis du har brug for hjælp til Curtis CD290 stil et spørgsmål nedenfor, og andre brugere vil svare dig


CD-afspiller Curtis Manualer

Curtis

Curtis CD149 Manual

19 Juni 2025
Curtis

Curtis CDMP364 Manual

19 Juni 2025
Curtis

Curtis CD145 Manual

18 Juni 2025
Curtis

Curtis CD194 Manual

18 Juni 2025
Curtis

Curtis CD182 Manual

18 Juni 2025
Curtis

Curtis CD255 Manual

18 Juni 2025
Curtis

Curtis CD249 Manual

18 Juni 2025
Curtis

Curtis CD150 Manual

18 Juni 2025
Curtis

Curtis CD185 Manual

17 Juni 2025
Curtis

Curtis CD360 Manual

17 Juni 2025

CD-afspiller Manualer

Nyeste CD-afspiller Manualer

Denon DJ

Denon DJ DN-S3500 Manual

6 August 2025
Denon DJ

Denon DJ DN-S1000 Manual

6 August 2025
Denon DJ

Denon DJ DN-2000FLTD Manual

6 August 2025
Denon DJ

Denon DJ DN-D9000 Manual

6 August 2025
Denon DJ

Denon DJ DN-1000F Manual

5 August 2025
Denon DJ

Denon DJ DN-S5000 Manual

5 August 2025
Denon DJ

Denon DJ DN-2200F Manual

5 August 2025
Denon DJ

Denon DJ DN-D4500 Manual

5 August 2025
Denon DJ

Denon DJ DN-2500F Manual

5 August 2025
Denon DJ

Denon DJ DN-2600F Manual

5 August 2025