CyberPower CSB604 Manual

CyberPower Ikke kategoriseret CSB604

Læs gratis den danske manual til CyberPower CSB604 (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 8 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 4.5 anmeldelser. Har du et spørgsmål om CyberPower CSB604, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

CAUTION

TO REDUCE THE RISK OF ELECTRIC SHOCK:

Use only in dry locations and only indoors.

DO NOT plug into another relocatable power tap.

DO NOT “daisy chain” surge protectors.

DO NOT use with any aquarium equipment.

DO NOT use if properly grounded outlets are not available.

DO NOT install this device if there is less than 10 meters (30 feet) of wire between

the electrical outlet and electrical service panel.

DO NOT use for medical or life support equipment. This device features an internal

protection that will disconnect the surge protective component at the end of its

useful life, but it will maintain unprotected power to the load.

FOR MORE INFORMATION

Visit CyberPowerSystems.com for more information regarding:

• Product information and certiﬁcations

• Product warranty

• Connected equipment guarantee

TECHNICAL SUPPORT

Visit: CyberPowerSystems.com/support

Toll-Free: 1-877-297-6937

All other trademarks are the property of their respective owners.

FEATURES

1. ON/OFF Reset Control Switch and Circuit Breaker

Controls power to all outlets. The switch is also a 15 A

breaker. When an overload occurs, it will automatically

switch o. To resume operation, ensure the overload

condition is removed and reset the surge protector by

switching the unit ON.

2. Six Standard Outlets

SURGE PROTECTOR INSTRUCTIONS

1. Set power switch into the “OFF” position. Plug the surge

protector into a standard grounding wall receptacle

by fully inserting the plug and ensure that there are no

exposed conductors.

2. Make sure electronic equipment is turned o before

plugging into the surge protector outlets. Do not use

extension cords to connect equipment to the surge

protector.

3. Set the power switch into the “RESET” position.

The surge protector will now be providing power

and surge protection.

4. Connected equipment can now be turned on.

TROUBLESHOOTING

If the ON/OFF is switched OFF, the 15 Amp circuit breaker may have tripped.

Examine your connected equipment and remove the device that is overloading

the circuit. Then, turn the ON/OFF switch back to RESET.

6-OUTLET

SURGE PROTECTOR

CSB604/CSB606/CSB606W

USER MANUAL

YOUR ULTIMATE ALLY IN POWER

Cyber Power Systems (USA), Inc.

4241 12th Avenue East, Suite 400 | Shakopee, MN 55379

CyberPowerSystems.com

SPECIFICATIONS

Model Number: CSB604/CSB606/CSB606W

Outlets: 6 Standard Outlets

Surge Protection: 900 Joules

Electrical Rating: 125 V / 15 A / 1875 W

UL Clamping Voltage: UL 1449 3rd / 500 V

(H-N, H-G, N-G)

3 AC Lines Protected: H-N: 15,000 A,

H-G: 15,000 A,

N-G: 15,000 A

Response Time: Less than 1 nanosecond

Attenuation: Up to 32 dB

Circuit Breaker: Resettable 15 Amp

EMI/RFI Filtration: 150 kHz to 100 MHz

i WARNING: This product can expose you to chemicals including bisphenol A (BPA)

and styrene (ABS), which is known to the State of California to cause reproductive

harm and cancer. For more information, go to www.P65Warnings.ca.gov.

CONFORMANCE APPROVALS

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) this

device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may

cause undesired operation.

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interfer-

ence to radio or television reception, which can be determined by

turning the equipment o and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from

that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

WARNING: Changes or modiﬁcations not expressly approved by the

party responsible for compliance could void the user’s authority to

operate the equipment.

Produkt Specifikationer

Mærke:	CyberPower
Kategori:	Ikke kategoriseret
Model:	CSB604
Tænd-/slukkontakt:	Ja
Produktfarve:	Sort
Fjernbetjening inkluderet:	Ingen
LED-indikatorer:	Strøm
Kabellængde:	1.219 m
Bæredygtighedscertifikater:	RoHS
Strømstik:	NEMA 5–15P
Nominel indgangsspænding:	125 V
AC udgange, antal:	6 AC stikkontakt(er)
AC stikkontakt typer:	NEMA 5–15R
Overspænding energivurdering:	900 J
Nominel udgangsstrøm:	15 A
Spændingsblokering:	400 V