CyberPower Essential P303UOR Manual

CyberPower Ikke kategoriseret Essential P303UOR

Læs gratis den danske manual til CyberPower Essential P303UOR (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 33 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 17 anmeldelser. Har du et spørgsmål om CyberPower Essential P303UOR, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

CAUTION

TO REDUCE THE RISK OF ELECTRIC SHOCK - Use

only in dry locations and only indoors. plug DO NOT

into another relocatable power tap. DO NOT “daisy

chain” extension cords. DO NOT use with any

aquarium equipment. use if properly DO NOT

grounded outlets are not available. DO NOT install

this device if there is less than 10 meters (30 feet) or

more of wire between the electrical outlet and

electrical service panel. DO NOT use for medical or

life support equipment. This device features an

internal protection that will disconnect the surge

protective component at the end of its useful life, but it

will maintain unprotected power to the load. If this

situation is undesirable for the application, follow the

manufacturer’s instructions for replacing the device.

The conductors used to connect the SPD to the line or

bus and to ground shall not be any longer than

necessary and shall avoid unnecessary bends. DO NOT

plug devices over 2.4A to each USB port.

TECHNICAL SUPPORT

Please contact our Tech Support Department

with installation, troubleshooting, or general

product questions.

• Phone: 1-877-297-6937

• Email: tech@cpsww.com

• Hours of Operation:

Monday – Friday 7:00am – 6:00pm CST

USER MANUAL

3-3-Outlet ExtOutlet Extension Cension Corordd

with 2 USB Pwith 2 USB Portsorts

P303UMT/P303UDBL/P303UOR

P303UMT/P303UDBL/P303UORP303UMT/P303UDBL/P303UOR

CONGRATULATIONS ON YOUR PURCHASE

Thank you for selecting the CyberPower P303UMT/

P303UDBL/P303UOR Extension Cord. This manual

explains the features and operation of the

P303UMT/P303U BL/P303UOR. Please take a few D

moments to read this manual.

EXTENSION CORD INSTRUCTIONS

1. Plug the extension cord into a standard grounded

wall receptacle by fully inserting the plug and

ensure that there are no exposed conductors.

2. Make sure the electronic equipment is turned o

before plugging into the extension cord outlets. Do

not use extension cords to connect equipment to

the extension cord.

FEATURES

1. Standard Grounded Outlets (3)

2. USB Charging Ports* (2)

Connect and charge up to two (2) USB devices.

*USB outlets cannot be used as a USB hub. This

device does not transfer data.

SPECIFICATIONS

• Model Number: P303UMT/P303U BL/P303UORD

• Outlets: Standard Grounded Outlets (3)

• Surge Protection: 350 Joules

• Electrical Rating: 125V/13A/1625W/60Hz

• USB Charging Rating: 5V/2.4A shared

• Clamping Voltage: 900V (L-N)

CONTACT INFORMATION

Cyber Power Systems (USA), Inc.

4241 12th Avenue East, Suite 400

Shakopee, MN 55379

Toll-free: 1-877-297-6937 | CyberPowerSystems.com

LIMITED LIFETIME WARRANTY AND CONNECTED

EQUIPMENT GUARANTEE

Read the following terms and conditions carefully before

using the CyberPower P306UMT/P306UBL/P306UOR (the

“product”). By using the product, you consent to be bound

by the terms and conditions of this limited lifetime warranty

and connected equipment guarantee (together referred to

as this “warranty”). IF YOU DO NOT AGREE TO THE TERMS

AND CONDITIONS OF THIS WARRANTY, YOU SHOULD

RETURN THE PRODUCT FOR A FULL REFUND PRIOR TO

USING IT.

Who is providing this warranty, and what does it cover?

Cyber Power Systems (USA), Inc. (“CyberPower”) provides

this limited lifetime warranty. It only covers the original

purchaser and ends if you no longer own the product. This

warranty covers defects in materials and workmanship in the

product under normal use and conditions. It also covers

equipment connected to the product and damaged because

of the failure of the product. This warranty covers the

product and connected equipment for as long as you own

the product.

How do you open a connected equipment claim?

1. Call us at (877) 297-6937, or write to us at:

Cyber Power Systems (USA), Inc.

4241 12th Avenue East, Suite 400

Shakopee, MN 55379,

or send us an email at claims@cpsww.com within 10 days

of the occurrence for instructions.

2. When you contact CyberPower, identify the product, the

purchase date, and the item(s) of connected equipment.

Have information on all applicable insurance or other

resources of recovery/payment that are available to the

initial customer, and request a claim number.

3. You must provide a dated purchase receipt (or other proof

of the original purchase) for the CyberPower unit and

connected equipment. You also need to provide a

description of the damage to your connected equipment.

4. Pack and ship the product to CyberPower and the item(s)

of connected equipment, a repair cost estimate for the

damage to the connected equipment, and all claim forms

that CyberPower provides to you. Show the claim number

on the shipping label, or include it with the product. You

must prepay all shipping costs. You are responsible for

packaging and shipment, and you must pay the cost of the

repair estimate.

What will CyberPower do to correct problems?

CyberPower will inspect and examine the product. If the

product is defective in material or workmanship, CyberPower

will replace it at CyberPower’s expense, or CyberPower will

refund the full purchase price you paid for the product

(purchase receipt showing price paid is required). If the

product failed to protect any equipment plugged into it, we

will also send you forms for making your claim for the

connected equipment. We will repair or replace the equipment

that was damaged because of the failure of the product or pay

you the fair market value (NOT REPLACEMENT COST), of the

equipment at of the time of the damage. We will use Orion

Blue Book, another third-party valuation guide, eBay,

Craigslist, or other source to establish that amount. Our

maximum liability is limited to $50,000 for the P306UMT/

P306U BL/P306UOR.D

Who pays for shipping?

We pay shipping when we send items to you; you pay when

you send items to us.

What are some things this Warranty does not cover?

1. THIS WARRANTY DOES NOT COVER: ANY SOFTWARE

THAT WAS DAMAGED, SOFTWARE THAT NEEDS TO BE

REPLACED DUE TO THE FAILURE OF THE PRODUCT, OR

ANY DATA THAT IS LOST AS A RESULT OF THE FAILURE.

THIS WARRANTY DOES NOT COVER THE RESTORATION

OF DATA OR RECORDS, OR THE REINSTALLATION

OF SOFTWARE.

2. This warranty does not cover: misuse, modiﬁcation,

operation or storage outside of the environmental limits of

the product or the equipment connected to it. It does not

cover damage while in transit or in storage; if there has

been improper operation or maintenance, or use with

items not designed or intended for use with the product,

such as laser printers, appliances, aquariums, medical, or

life support devices, etc.

What are the other limitations?

The sole and exclusive remedies of the initial customer are

those provided by this warranty.

1. This warranty does not apply unless the product and the

connected equipment were connected to properly wired

and grounded outlets (including compliance with electrical

and safety codes of the most current electrical code),

without the use of any adapters or other connectors.

2. The product must have been plugged directly into the

power source. The equipment connected to the product

must be directly connected in the product, not “daisy

chained” together in serial fashion with any extension

cords, another product, or device similar to the product,

surge suppressor, or power tap. Any such installation voids

the warranty.

3. The product and connected equipment must have been

used properly in a suitable environment, in conformance

with any applicable license, instruction manual, or warnings.

4. The product must have been used at all times within the

limitations on the product’s maximum rated wattage.

Where can I get more information?

Cyber Power Systems (USA), Inc.

4241 12th Avenue East, Suite 400

Shakopee, MN 55379;

Call us at (877) 297-6937;

Send us an email message at claims@cpsww.com.

PRODUCT REGISTRATION

Prompt product registration assures coverage under the

limited lifetime warranty, and also allows the opportunity of

notiﬁcations for product enhancements, upgrades, and

other announcements.

Registration is quick and easy. Go to the Product Registration

Page at CyberPowerSystems.com/registration.

CyberPowerSystems.com

All other trademarks are the property of their respective owners.

This device is manufactured using environmentally-safe

procedures in compliance with the Restriction of Hazardous

Substances (RoHS) directive.

Please join CyberPower in caring for the environment by recycling.

WARNING: This product can expose you to chemicals including styrene,

which is known to the State of California to cause cancer.

For more information, go to www.P65Warnings.ca.gov.

K01-0000851-00

CONFORMANCE APPROVALS

This device complies with Part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) this device may

not cause harmful interference, and (2) this device must

accept any interference received, including interference that

may cause undesired operation.

This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses, and

can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications.

However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which

can be determined by turning the equipment o and on, the

user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent

from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician

for help.

WARNING: Changes or modiﬁcations not expressly approved

by the party responsible for compliance could void the user's

authority to operate the equipment.

3 4

Produkt Specifikationer

Mærke:	CyberPower
Kategori:	Ikke kategoriseret
Model:	Essential P303UOR

Har du brug for hjælp?

Hvis du har brug for hjælp til CyberPower Essential P303UOR stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret CyberPower Manualer

CyberPower PDU31009 Manual

20 August 2025

CyberPower CR6U61002 Manual

20 August 2025

CyberPower SM30KPMX Manual

20 August 2025

CyberPower PDU31414 Manual

20 August 2025

CyberPower PDU41404 Manual

19 August 2025

CyberPower SM10KADFA Manual

29 Juli 2025

CyberPower SM10KASPA Manual

29 Juli 2025

CyberPower P2WU Manual

24 Juli 2025

CyberPower PDU81102 Manual

22 Juli 2025

CyberPower PDU31005 Manual

22 Juli 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Cougar GR 650 Manual

27 August 2025

Paragon PSG-161-SEG-PL-NP Manual

27 August 2025

Full Boar FBAHR-032 Manual

27 August 2025

Juice Goose RP100-15A Manual

27 August 2025

Maxview Roam 5G COMBO60 Manual

27 August 2025

Asus ZenWiFi BD4 Outdoor Manual

27 August 2025

ENTES FG-4 Manual

27 August 2025

YSI MultiLab IDS Manual

27 August 2025

True TH-23G~FGD01 Manual

27 August 2025

Dualit Architect 16018 Manual

27 August 2025