CONGRATULATIONS ON YOUR PURCHASE
Thank you for selecting the CyberPower CSP604T/
CSP606T Surge Protector. This manual explains the
features and operation of the CSP604T/CSP606T. Please
take a few moments to read this manual.
FEATURES
1. ON/OFF Reset Control Switch and Circuit Breaker
Controls power to all outlets. The switch is also a 15 A
breaker. When an overload occurs, it will automatically
switch o. To resume operation, ensure the overload
condition is removed and reset the surge protector by
switching the unit ON.
2. Standard Grounded Outlets (6)
3. Surge Protected Data Line Connections
To protect your equipment from surge along phones/
fax/modems lines.
A. Connect the phone line from wall outlet into the
“In” port.
B. Connect the phones/fax/modems line in the
“Out” port.
SPECIFICATIONS
• Model Number: CSP604T/CSP606T
• Outlets: Standard Grounded Outlets (6)
• Surge Protection: 1,350 Joules
• Electrical Rating: 125 V/15 A/1875 W
• UL Clamping Voltage: UL 1449 3rd/400 V (H-N, H-G, N-G)
• Maximum Peak Current: 60,000 A
• 3 AC Lines Protected:
H-N: 30,000 A
H-G: 15,000 A
N-G: 15,000 A
The maximum surge possible on household wiring is
6,000 volts)
• Response Time: Less than 1 nanosecond
• Attenuation: Up to 43 dB
• Telecommunications Protection: RJ11 1 in/1 out
• Circuit Breaker: Resettable 15 Amp
• EMI/RFI Filtration: 150 kHz to 100 MHz
CAUTION
TO REDUCE THE RISK OF ELECTRIC SHOCK - Use only in
dry locations and only indoors. DO NOT plug into another
relocatable power tap. DO NOT “daisy chain” surge
protectors. DO NOT use with any aquarium equipment.
DO NOT use if properly grounded outlets are not
available. DO NOT install this device if there is less than 10
meters (30 feet) or more of wire between the electrical
outlet and electrical service panel. DO NOT use for
medical or life support equipment. This device features an
internal protection that will disconnect the surge
protective component at the end of its useful life, but it
will maintain unprotected power to the load. If this
situation is undesirable for the application, follow the
manufacturer’s instructions for replacing the device.
TROUBLESHOOTING
▪ If the ON/OFF is switched OFF, the 15 Amp circuit
breaker may have tripped. Examine your connected
equipment and remove the device that is overloading the
circuit. Then, turn the ON/OFF switch back to RESET.
TECHNICAL SUPPORT
Please contact our Tech Support Department with
installation, troubleshooting, or general product questions.
• Phone: 1-877-297-6937
• Email: tech@cpsww.com
• Hours of Operation:
Monday – Friday 7:00am – 6:00pm CST
USER MANUAL
6-Outlet Surge Protector
CSP604T/CSP606T
6-Outlet Surge Protector
CSP604T/CSP606T
12
Copyright © 2019 Cyber Power Systems (USA), Inc. All rights reserved.
1
3
2
