2
Important Safety Instructions
When using your video equipment, basic safety precautions should always be followed, including the following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over, pulled, or
contact hot surfaces.
3. If an extension cord is necessary, a cord with a current rating
at least equal to that of the appliance should be used. Cords
rated for less amperage than the appliance may overheat.
4. To reduce the risk of electric shock, do not disassemble this
appliance. Contact an authorized service dealer when repair
work is required. Incorrect reassembly can cause electric
shock when the appliance is used subsequently.
5. The use of an accessory attachment not recommended by
the manufacturer may cause a risk of ire, electric shock, or
injury to persons.
Pre-Installation
Installation
1. Carefully unpack screen and remove outer wrapping
from case.
2. Remove instruction cover plate (Fig. 1). Do not remove metal
shipping brace (secures roller), wrapping paper, or tape strips
until screen is installed.
3. Make sure to recheck measurement of screen location
before installation.
NOTE: Screen is not centered in box. Screen surface
is set 18⅝" from motor end.
Ironing Board
Some Senior Electrols, depending on size and type of picture
surface, contain an ironing board to latten the fabric (long strip
attached). The ironing board is part of the screen. Do not remove
or alter (Fig. 2).
Hangers (If required)
1. Make sure one hanger is approximately 25" from end
of case (motor end).
2. Make sure second hanger is approximately 11 ½" from
opposite end of case.
3. Place a third hanger on the center line of fabric.
4. Make sure hangers are placed to it into notches provided
on screens equipped with an ironing board.
5. Make sure hanger used on motor end does not interfere
with motor access door.
Figure 2
Hex Head
Screws Tape Strip
Shipping
Brace
(Not on 3"
Roller) Ironing
Board
Wall Type Hanger
Picture
Surface
Picture
Surface
Picture Surface
Ceiling Type
Hanger
Rafters
Wall or Ceiling Mount With Hangers
Wall Type Hangers with ceiling hanger adapters are
standard equipment. For wall type, use wall hanger only.
For ceiling type installation, use the wall type hanger and
ceiling adapters as shown in Fig. 3 on page 4.
Recessed Above Ceiling
Other methods of installation will no doubt
suggest themselves especially in new buildings
where it would be an easy matter to provide a
recess for the screen to conceal it when not in use.
Do Not Seal In-Allow Access.
For Exposed Installation
If the screen is to be mounted in an exposed
position, it may be covered with inished plywood,
veneer paneling, plastic wall covering or a valance.
Figure 1
Instruction Cover
Case
