Dell PowerEdge 2550 Manual

Dell Server PowerEdge 2550

Læs gratis den danske manual til Dell PowerEdge 2550 (83 sider) i kategorien Server. Denne vejledning er vurderet som hjælpsom af 26 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 13.5 anmeldelser. Har du et spørgsmål om Dell PowerEdge 2550, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/83

Dell™PowerEdge™2550SystemsInstallationandTroubleshootingGuide

Preface

Introduction

Checking the Basics

Messages and Codes

Finding Software Solutions

RunningtheDell™Diagnostics

Checking the Equipment

Checking Inside the System

Installing System Board Options

Installing a Drive in the Peripheral Bay

Installing Hard-Disk Drives

Getting Help

Jumpers, Switches, and Connectors

Abbreviations and Acronyms

Figures

Tables

Notes, Notices, Cautions, and Warnings

Informationinthisdocumentissubjecttochangewithoutnotice.

©2001DellComputerCorporation.Allrightsreserved.

Reproduction in any manner whatsoever without the written permission of Dell Computer Corporation is strictly forbidden.

Trademarks used in this text: Dell, PowerEdge, Dell OpenManage, Dimension, Inspiron, Dell Precision, Optiplex, Latitude, and DellWare are trademarks of Dell Computer Corporation;

Intel is a registered trademark and MMX is a trademark of Intel Corporation; Microsoft , Windows, Windows NT, and MS-DOS are registered trademarks of Microsoft Corporation.

Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Dell Computer Corporation

disclaims any proprietary interest in trademarks and trade names other than its own.

Initial release: 9 Jan 2001



NOTE: A NOTE indicates important information that helps you make better use of your computer.

NOTICE: A NOTICE indicates either potential damage to hardware or loss of data and tells you how to avoid the problem.

CAUTION: A CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.

WARNING: A WARNING indicates a potentially hazardous situation which, if not avoided, may result in severe injury.

Back to Contents Page

Installing Hard- Disk Drives

Dell™PowerEdge™2550SystemsInstallationandTroubleshootingGuide

This section describes how to install and configure small computer system interface (SCSI) hard-disk drives in the system's internal hard-disk drive bays.

InstructionsarealsoincludedforupgradingthesystembyinstallinganoptionalSCSIbackplanedaughtercardforsplitbackplaneoperationoraDell™

PowerEdge™ExpandableRAIDController(PERC)hostadaptercard.

The hard-disk drive bays provide space for up to four 1-inch hard-disk drives. (You can also install a fifth hard-disk drive in the peripheral bay by purchasing an

upgrade kit from Dell. For installation information, see the documentation provided with the upgrade kit.)

Figure10-1 illustrates the system components associated with the SCSI hard-disk drives.

Figure 10- - 1. Hard Disk Drive Hardware



Preparing SCSI Hard- Disk Drives for Installation

SCSI Hard- Disk Drive Configuration

The SCSI drives must be configured as follows:

l Disable termination on the drives. The SCSI backplane board provides termination for the SCSI bus.

l Set the SCSI ID on all drives to 0. All SCSI ID numbers for the drives are set by the SCSI backplane board, as shown in Figure10-1.

l Configure the drives so that the drive motor waits for a start unit command from the SCSI host adapter before spinning.

Partitioning and Formatting SCSI Hard- Disk Drives

You may need to use programs other than those provided with the operating system to partition and format SCSI hard-diskdrives.See"Installingand

Configuring SCSI Drivers" in the User's Guide for information and instructions.

When you format a high-capacity SCSI hard-disk drive, be sure to allow enough time for the formatting to complete. Long formatting times for these drives are

normal.

General Information on Cabling

The four connectors on the SCSI backplane board are designated as SCSI ID 0 through SCSI ID 3 (see Figure10-1). If a fifth hard-disk drive is installed in the