Digi XBee-PRO PKG Manual

Digi Ikke kategoriseret XBee-PRO PKG

Læs gratis den danske manual til Digi XBee-PRO PKG (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 19 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 10 anmeldelser. Har du et spørgsmål om Digi XBee-PRO PKG, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Getting Guide Started 

Connect the Hardware

Connect the hardware as shown in the following images:

Note: To run a successful range test, the remote end must be an RS-232 device.

Set Up Range Test

Install X-CTU Software

X-CTU is a stand-alone tool for configuring XBee devices. It is also used to run a range test and

is included on the Hardware and Software Setup CD. X-CTU can also be found on the website

at: http://www.digi.com/xctu

To install X-CTU:

1. Insert the Hardware and Software Setup CD in the PC’s CD/DVD drive.

2. . On the Home page, click Gateway, Host, Enterprise Documentation/Software

3. . Click X-CTU

4. Click Install X-CTU.

5. When installation completes, start X-CTU by double-clicking on the X-CTU icon placed on

your desktop or by selecting: Start > Programs > Digi > X-CTU

The X-CTU software is ready to be used.

XBee-PRO® 802.15.4 PKG-R &

PKG-U RF Modems

Install USB Drivers (For the XBee-PRO USB PKG version only)

The XBee-PRO USB PKG is a “plug-and-play” device that should be detected by the PC

automatically. To interface between the modem and a PC, two drivers must be installed: a USB

driver and a virtual COM port driver that makes the USB port look and perform like a physical

COM port. After the modem is detected, a wizard for installing the USB driver is launched. The

USB driver is included on the Hardware and Software Setup CD.

To install the two USB drivers:

1. Connect the XBee-PRO USB PKG to a PC using a USB cable. The New Hardware Wizard

dialog box will load.

2. Verify that the Hardware and Software Setup CD is inserted into the CD/DVD drive.

3. . Select Install from a specific list or location (Advanced); then click Next

4. Select Search for the best driver in these locations and search removable media (CD-

ROM). Click Next. A Hardware Installation Windows Logo Testing alert box is displayed.

5. . Click Continue Anyway

6. . Click Finish

You will be prompted to install another driver, the virtual COM port driver. Repeat steps 3

through 6 to install this driver.

Perform Range Test

1. Launch the X-CTU Software: Start > Programs > Digi > X-CTU

2. Under the PC Settings tab, select the PC serial COM port that will be used. The standard

COM port for the 9-pin serial port is COM 1. The USB ports will be labeled as Digi PKG-U

Serial Port Adapters and are assigned a number based on your PC's settings.

3. Verify that the baud rate and data settings match the internal settings of the radios. The

default settings for the radios are Baud Rate: 9600, Flow Control: HARDWARE, Data Bits:

8, Parity: NONE, and Stop Bits: 1.

4. Select the Range Test tab.

5. (Optional) Check the RSSI checkbox to enable the Received Signal Strength Indicator. The

RSSI value indicates the signal strength of the last packet that the radio received.

6. Click Start to begin the range test.

7. Monitor the link quality by reading the Percent section on the Range Test tab. This section

displays the running percentage of good packets sent to the receiving radio and looped back

to the base.

8. Click Stop to end the range test.

Toll-free phone U.S.A. & Canada: (866) 765-9885

Worldwide: (801) 765-9885

Online support: http://www.digi.com/support/eservice/login.jsp

Produkt Specifikationer

Mærke:	Digi
Kategori:	Ikke kategoriseret
Model:	XBee-PRO PKG

Har du brug for hjælp?

Hvis du har brug for hjælp til Digi XBee-PRO PKG stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Digi Manualer

Digi DA-70866 Manual

21 Februar 2025

Digi DN-30210 Manual

1 September 2024

Digi DA-70330-1 Manual

1 September 2024

Digi DA-70861 Manual

1 September 2024

Digi DN-70565 Manual

1 September 2024

Digi DA-70890 Manual

1 September 2024

Digi DA-70242-1 Manual

1 September 2024

Digi AB-50001-1 Manual

1 September 2024

Digi ASB-6310-DX00-RMK Manual

21 August 2024

Digi ASB-630V-CX02-OUS Manual

21 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Elektrobock PT44 Manual

14 September 2025

BSS Audio FDS-366T Manual

14 September 2025

Systemair Airline R-114 Manual

14 September 2025

IFM SU2031 Manual

14 September 2025

Morel Tempo Ultra Integra 502 Manual

14 September 2025

IMC Networks 232CL9R Manual

14 September 2025

Varta Speed Charger 57955 Manual

14 September 2025

Melissa & Doug 9336 Manual

14 September 2025

Opus dataPREDATOR Manual

13 September 2025

Varta Wireless Power Bank 20000 57909 Manual

13 September 2025