ROBOT SPINNER EXPERIMENT SET
B )attery comp ntartme (03
S g ( ) S g (5b) S g ( )prin 5a prin prin 5c
Battery
connectors (terminals) to allow
circuit to the positive terminal
Breadboard
breadboard is a construction
Circuit - A series of electrical
components in a closed loop that
-
Conductor - An object or material
-
Current
Electron
atom has at least one electron
LED -
remotes to camera ashes and
Motor - A machine that converts
Neutron
Negative - One of the two “poles”
Positive -
Power
-
Proton - A third subatomic parti-
-
Wire - A conductor (usually
copper wrapped in a plastic insu-
lator) used to carry electrical cur-
This kit uses spring connectors to make electrical connections instead of solder
The advantage of using spring connectors here is that you can take your circuit
apart once you’re done with it!
The bare wire must be in contact with the spring, not the insulation.
04 ON/OFF Switch03 Battery Compartment
SPINNING ROBOT BASIC WIRING DIAGRAM
-
Always read the instructions and review the diagrams thoroughly before begin-
move from the negative terminals of the battery through the negative blue wire
IF NOTHING HAPPENS: CHECK YOUR CONNECTIONS
Orange to orange and blue to
-
The artwork and design of this manual are
protected by US copyright law and may not be
used for any purpose without prior written
any of the trademark or copyright notice forms
• Rechargeable batteries are to be removed from the
• Rechargeable batteries are only to be charged under
• Short circuit the batteries or wrong connection of the
PLEASE READ ALL SAFETY WARNINGS BEFORE USE
• This kit contains functional sharp points on
• Remove all batteries when not in use to avoid accidental
loose clothing away from gears and other operating
• Short circuit the batteries or wrong connection of the
This device complies with Part 15 of the FCC
conditions: (1) this device may not cause harmful
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital
These limits are designed to provide reasonable
protection against harmful interference in a
equipment does cause harmful interference to
the user is encouraged to try to correct the
interference by one or more of the following
— Connect the equipment into an outlet on a
approved by the party responsible for compliance
could void the user's authority to operate the
• The toy is not to be connected to more than the
• The wires are not to be inserted into socket
