A FEATURES OF FRONT PANEL.
1. LINE stereo input jacks
Connect line-level devices such as an electric keyboard or an audio device.
Thee jacks support phone plugs. If you use only the jack, same sound is
output from both L and R speakers.
2. PHANTOM+48V switch/LED
When this switch is on, the LED lights indicang that the unit supplies
DC+48V phantom power to the XLR plugs of the [MIC/LINE] mono input
jacks. Turn this switch on when using a phantom-powered condenser mi-
Adjusts the gain applied to the input signal level. To get the best balance
between the S/N rao and the dynamic range, Adjust the gain so that the
PEAK indicator comes on just as the signal approaches its maximum level.
Control the high frequency tone of each channel. Always set this control
to the 12 o'clock posion, but you control the high frequency tone accord-
ing to the speaker, the condions of listening posion and listener's taste.
Clockwise rotaon of the control increases level.
Control the low frequency tone of each channel. Always set this control to
the 12 o'clock posion, but you control the low frequency tone according
to the speaker, the condions of listening posion and listener's taste.
Clockwise rotaon of the control increases level.
MONO: Sound input to channels 1/L or 2/R can be heard from both the
right and le speakers. If you use the 1/L or 2/R individually, set the switch
STEREO: Sound input to channel 1/L can be heard from only the left
speaker, and that input to channel 2/R can be heard from only the right speaker.
Adjusts the level of the signal sent from the channel to the FX bus.
Lights when the volume of input and/or post-equalizer sound is too high. If it is lit, turn the [GAIN] knob to
the le to lower the volume.
For adjusng the volume balance among the channels.
