Dyson CR01 Base Manual

Dyson Vaskemaskine CR01 Base

Læs nedenfor 📖 manual på dansk for Dyson CR01 Base (13 sider) i kategorien Vaskemaskine. Denne guide var nyttig for 30 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/13
DYSON CR01
DRUM BEARING REPAIR
I have written this guide assuming that the reader has no knowledge on how to dismantle
any part of the Dyson CR01. Having never worked on a CR02, I am unaware if the
construction of that model differs greatly.
I have borrowed various images from the net and thank everyone for their contribution.
Read each paragraph twice before starting that phase of dismantling.
Tools required.
a) Set of Torx bits / screwdrivers
b) Large hammer
c) Bolster.
d) Set of metric spanners / sockets
e) Digital Camera. (Always a good idea to photograph in situ before your remove)
1) Disconnect from the water and electricity supply and remove hoses. Drain as much
water from the machine as possible by removing the coin trap cover and putting the drain
pipe as low as possible.
2) Remove the top cover. Remove the two Phillips screws at the rear of the cover and slide
it backwards
3) Remove soap dispenser. The yellow catch at the rear of the dispenser allows it to be
removed.
4) Remove front controls / display.
a)This is held on with two torx screws and when removed should be slid downwards.
This will release the plastic tabs that hold it in place.
b) Disconnect the ribbon cable from where it attached to the machine body.
c)Remove the pressure sensor pipe. This just pulls off.
d) Disconnect the four power cables to the main on / off switch. The position of the
cables should be recorded for reassembly.
The entire control panel assembly should now be free
5) Remove exterior door. This is held in place with spring clips / hinges that are visible. I
found it easy to insert a flat screw driver into the hinge and push down the yellow clip.
6) Remove front panel. This is held in place with 4 torx screws and a number of plastic
tabs. Care should be taking not to break the plastic tabs. 2 screws are clearly visible on
the top of the panel and the other two are recessed into the hinge of the exterior door. If
you have not already removed the coin trap cover then this is the time do it as the front


Produkt Specifikationer

Mærke: Dyson
Kategori: Vaskemaskine
Model: CR01 Base

Har du brug for hjælp?

Hvis du har brug for hjælp til Dyson CR01 Base stil et spørgsmål nedenfor, og andre brugere vil svare dig




Vaskemaskine Dyson Manualer

Vaskemaskine Manualer

Nyeste Vaskemaskine Manualer