Elba ETC-E2700 Manual

Elba Vandhane ETC-E2700

Læs gratis den danske manual til Elba ETC-E2700 (1 sider) i kategorien Vandhane. Denne vejledning er vurderet som hjælpsom af 33 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 17 anmeldelser. Har du et spørgsmål om Elba ETC-E2700, eller vil du spørge andre brugere om produktet?

Side 1/1
1. Install the intake (A) on the wall.
2. Put the tape(C) around the screw threaded tube, cover the rosette (B) and screw into pipeline.
3. Connect water and check if the screw has been sealed tightly.
pipeline
Before installation, please ensure that the following work
conditions are adhered to:
-Water temperature between 0 C - 90 C˚ ˚
-Water pressure between 0.05MPa 1.0MPa. Pressure reducing
valve is necessary if pressure exceeds 1.2MPa
-Avoid major pressure di erences between hot and cold water
supply
Flush pipes thoroughly before and after installation to ensure
water supply is free of any debris.
Inspect tap fitting and debugged to its best. Do not attempt to
disassemble fitting on your own.
Use thread sealant tape (PTFE) on any screw joining
connections and ensure all joints are securely tightened.
ETC-E2700
This . FIAMMA SDN. BHD. will not be held responsible for the use of superseded or voided specifications.
Fabricatoe must check for cut-out accuracy.
specification is subject to change without notice
Stainless Steel Cold Water Tap


Produkt Specifikationer

Mærke: Elba
Kategori: Vandhane
Model: ETC-E2700

Har du brug for hjælp?

Hvis du har brug for hjælp til Elba ETC-E2700 stil et spørgsmål nedenfor, og andre brugere vil svare dig