Elcold CUBE 35 Manual

Elcold Fryser CUBE 35

Læs gratis den danske manual til Elcold CUBE 35 (16 sider) i kategorien Fryser. Denne vejledning er vurderet som hjælpsom af 22 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 11.5 anmeldelser. Har du et spørgsmål om Elcold CUBE 35, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/16
Commercial
Brugervejledning User Instructions Gebrauchsanweisung G GB
Mode d‘emploi Instrukcja obslugi G GB
GB
PYC
DK D
F PL
Ðóêîâîäñòâî ïî Ýêñïëóàòàöèè
Commercial Freezer/Cooler
Operating instructions
Before you start reading this manual, please
pay attention to the last page showing
pictures and reference numbers.
Operation
To get the max. advantage from your freezer/
cooler it is important that it is placed in the
correct position. You should therefore read
this manual carefully. Keep the manual in
a place where it can always be found for
reference. Even with careful attention to
the freezer, a mishap may occur, with the
consequence that the contents of the cabinet
could be lost, therefore contents insurance is
recommended.
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety. Children should
be supervised to ensure that they do not play
with the appliance.
Placing the freezer/cooler
The freezer/cooler should not be placed
where it might be splashed by water, in
extremely high humidity or in direct sunlight,
see drawing no 1. Any of these factors may
lead to a reduction in the performance and
shorten the life span of the components.
The freezer/cooler should be placed on a
horizontal level and it must not be placed
too close to a heating appliance or pipes. The
distances from the appliance should be in
accordance with the sketch no. 1.
Electricity Supply
The electricity supply should always be in
accordance with the rating plate on the back
of the freezer, see sketch 3, here you can read
the voltage(V) and frequency (HZ). The supply
must always be in accordance with the law
and regulation of the country with regards to
electrical safety. If you are in doubt ask your
supplier.
Starting Up
In case the compressor does not start when
the freezer/cooler has been plugged in, the
reason may be that the electricity supply to
the unit is not in order. Check if there is an
electricity supply to the plug or if the fuse is
blown.
Temperature adjusting
Temperature regulation is controlled by the
thermostat, see sketch no. 4. The control is
placed in the compressor compartment.
The higher the number on the dial the lower
the temperature. With some models the
temperature is displayed on the front of the
cabinet.
N.B. with a too low temperature in the
cabinet the power consumption will increase,
therefore check that the thermostat setting is
at a sensible level.
N.B. the stock placed in the cabinet should be
at a temperature of at least -20 degrees C., as
the appliance is not sold as a freezing down
unit, but is meant only to maintain frozen
stock. Warning if the stock you want to place
in the cabinet is only - 15 degrees C.
you risk damage to other items of stock
already in place. It will not help to place
the thermostat at a higher setting. The
temperature for coolers should be around + 4
degrees C.
Loading the freezer
Note: When placing stock in the freezer be
sure, that it is at a temperature of at least -20
degrees C. The contents must never be placed
above the load line, which is marked on the
inside of the cabinet – see sketch 5, otherwise
the contents cannot be kept at the tempe-
rature required for a conservator (-18C).
With coolers the temperature in the cabinet
should be approx. +4 degrees C. If you put too
many items in at one time, the cooler will not
be able to cool them before they are required.
Therefore it is recommended that small loads
are placed in the cabinet each time.

Produkt Specifikationer

Mærke: Elcold
Kategori: Fryser
Model: CUBE 35

Har du brug for hjælp?

Hvis du har brug for hjælp til Elcold CUBE 35 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Fryser Elcold Manualer

Elcold

Elcold FOCUS 151 Manual

5 September 2024
Elcold

Elcold XLE 11 Manual

5 September 2024
Elcold

Elcold EL SS 71 Manual

5 September 2024
Elcold

Elcold Focus 106 V Manual

5 September 2024
Elcold

Elcold MOBILUX 21 Manual

5 September 2024
Elcold

Elcold EL SS 53 Manual

5 September 2024
Elcold

Elcold EL SS 22 Manual

5 September 2024
Elcold

Elcold EL 53 Manual

5 September 2024
Elcold

Elcold EL 45 Manual

5 September 2024
Elcold

Elcold XLE 51 Manual

5 September 2024

Fryser Manualer

Nyeste Fryser Manualer

Gourmia

Gourmia GAF784 Manual

14 Juni 2025
Vulcan

Vulcan 1TR85AF Manual

14 Juni 2025
Vulcan

Vulcan 4VHG50CF Manual

14 Juni 2025
Vulcan

Vulcan 4TR45AF Manual

14 Juni 2025
Fryclone

Fryclone 259SMRTPLXL Manual

14 Juni 2025
CHiQ

CHiQ CCF198BE Manual

14 Juni 2025
Master-Bilt

Master-Bilt MSF-43AN Manual

14 Juni 2025
Vulcan

Vulcan 3VK65DF Manual

14 Juni 2025
Avantco

Avantco F102 Manual

14 Juni 2025
Vulcan

Vulcan 4VK45CF Manual

14 Juni 2025