2
GB | LED Plastic Flashlight
See g. 1
1 – switch
2 – LED spotlight
3 – micro USB socket
4 – USB-output 5 VDC/1 A
Technical Specications
Accumulator: Li-Ion 4 000 mAh/3.7 V
Lighting modes: 50 %, 100 %, ashing, o
LED indicators: charging – red, charged – green
Flashlight operating temperature: -5 °C to +35 °C
Flashlight charging temperature: +5 °C to +35 °C
Charging the Accumulator
The ashlight‘saccumulator must be recharged before rst
use. Use the enclosed AC/DC adapter or car adapter. Charging
afully depleted accumulator takes 12 hours. Charge the ash-
light in dry indoor areas at atemperature of +5 °C to +35 °C. If
the ashlight is not used for an extended period of time, it is
necessary to recharge the accumulator before further use. The
accumulator self-discharges and must be recharged at least
once every 3 months to prevent its voltage from dropping and
the accumulator potentially being rendered unusable.
1. Plug the adapter into the socket on the ashlight and then
into a230 VAC/50 Hz mains socket. Ared indicator will
turn on the ashlight. When the ashlight (accumulator)
is fully recharged, agreen LED will light up.
2. Disconnect the adapter from the ashlight after recharging,
after 12 hours at the latest. The accumulator can be rechar-
ged intermittently – it has no memory eect.
3. The ashlight can also be recharged in the car – 12 VDC
through the lighter socket. The procedure for plugging in
and recharging is similar as when using apower adapter.
After recharging, disconnect the car adapter.
The ashlight can be recharged using acar adapter only when
the vehicle is stationary and the engine is turned o. Do not
LED
310 lm 30 h 300 m
750 lm 15 h 470 m
1
1
2
3
4