2
GB | LED Headlamp
Description
1. ON/OFF button for the COB LED (warm white)
2. COB LED (warm white)
3. LED (neutral white)
4. ON/OFF button for the LED (neutral white) + ON/OFF button for the IR sensors
5. IR sensors
6. Battery level indicator
Touchless Head Lamp Controls
1. Pressing and holding button no. 4 for at least 3 seconds activates the IR sensors.
2. Pressing button no. 4 again changes LED intensity (25 % – 50 % – 100 %).
3. Waving your hand in front of sensor no. 5 turns the LED (neutral white) on/o.
Note: The IR sensors can only be used to control the LED (neutral white). Can be acti-
vated even after the COB LED (warm white) has been turned on.
Quick Switch-o Function
This function will make switching o a headlamp with multiple lighting
modes much easier. Simply use whichever lighting mode you need and then
turn o the headlamp when you’re done with a single button press – no need
to go through all the remaining lighting modes to turn the headlamp o.
1. Turn on the headlamp.
2. Choose the lighting mode that suits you best.
3. The quick switch-o function automatically activates if the torch remains in the
same lighting mode for 10 seconds.
4. Afterwards, another press of the button automatically turns the headlamp o (skips
the other lighting modes).
Rechargeable Battery Protection
A product with this function features protective circuits that prevent both
overcharging and excessive discharging of the accumulator that could
lead to high temperatures, sparking or explosion that would irreversibly
damage or destroy the product.
Safety warnings:
• If the lamp does not turn on or the light is weak, recharge it immediately.
• The lamp’s accumulator must be kept charged. It is recommended to recharge it at
least once every 3 months even when the head lamp is not being used.
• Never cover up the head lamp’s light while it’s turned on; doing so could destroy
the lamp.
• Do not throw the head lamp or its components into a re and do not disassemble
or short-circuit them.
• If the accumulator is damaged or destroyed due to non-observance of the above
rules, complaints led within the lamp’s (accumulator’s) warranty period will not
be accepted.
