Extron Quantum Ultra Manual

Extron Ikke kategoriseret Quantum Ultra

Læs gratis den danske manual til Extron Quantum Ultra (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 51 personer og har en gennemsnitlig bedømmelse på 3.5 stjerner ud af 26 anmeldelser. Har du et spørgsmål om Extron Quantum Ultra, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

Product Category

IMPORTANT:

Go to www.extron.com for the complete

user guide,

installation instructions,

and

specifications bef

ore connecting the

oduct to the po

wer source.

Replacing the Quantum Ultra® Power Supplies

The Quantum Ultra has a primary and a redundant power supply unit (PSU) to ensure continued,

uninterrupted operation if a power supply should fail. However, if a power supply does fail, you should replace it as soon as

possible. The power supplies are hot-swappable, that is, one can be replaced while the unit is operating with the other PSU

supplying power.

NOTE: For full installation, configuration, and operation details, see the , available at Quantum Ultra User Guide

www.extron.com.

Replacing the Primary Power Supply

This section describes the procedure for replacing the primary power supply. If the redundant power supply needs to be replaced,

some additional steps are required (see on page 4).

Replacing the Redundant Power Supply

To replace the Quantum Ultra primary power supply:

1. Using a screwdriver or other tool, loosen the two thumbscrews on the power supply and the two thumbscrews on the

protective cover panel (see gure 1, 1).

ATTENTION:

• Thumbscrews should be tightened with a tool after both initial installation and subsequent access to the panel.

• Les vis doivent être serrées avec un outil adapté après la première installation et l’accès postérieur au panneau.

NOTE: The thumbscrews cannot be removed completely from the plates.

Figure 1. Unfastening the Power Supply

2. Remove the cover panel (2).

3. Rotate the primary power supply lever to the right (3) until it is in a horizontal position, parallel to the top and bottom of the

unit.

NOTE: If you are removing the , rotate lever (see figure 1, redundant power supply its 4) to the right instead of the

primary supply lever (3).

Replacing the Quantum Ultra Power Supplies (Continued)

4. As you rotate the lever, the power supply slides to the right. If necessary, continue sliding the PSU to the right as far as

possible (see gure 2, 1).

Figure 2. Rotating the Latch and Sliding the Primary Power Supply to the Right and Out

5. Lift the power supply up slightly and slide it toward you, out of the chassis (2).

Produkt Specifikationer

Mærke:	Extron
Kategori:	Ikke kategoriseret
Model:	Quantum Ultra

Har du brug for hjælp?

Hvis du har brug for hjælp til Extron Quantum Ultra stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Extron Manualer

Extron DTP3 IN2004 Manual

14 Juni 2025

Extron CPM 103 Manual

11 Marts 2025

Extron IN1608 XI Manual

10 Januar 2025

Extron ZipClip 100 Manual

3 Januar 2025

Extron HC 402 Manual

3 Januar 2025

Extron ShareLink Pro 2500 Manual

3 Januar 2025

Extron FOX3 SR 301 Manual

3 Januar 2025

Extron TMK 110 D Manual

3 Januar 2025

Extron SMB 210 Manual

3 Januar 2025

Extron FOX3 T 201 Manual

3 Januar 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Planet XGPN-100 Manual

15 Juni 2025

Proficook PC-EKA 1283 Manual

15 Juni 2025

OmniMount OBSP8 Manual

15 Juni 2025

Levenhuk FS10 Manual

15 Juni 2025

Vestil PM4-2148-LP Manual

15 Juni 2025

ElectriQ STRV-W1-B Manual

15 Juni 2025

Adler AD 4521 Manual

15 Juni 2025

AMX HydraPort HPX-AV102 Manual

15 Juni 2025

Hughes & Kettner Red Box Mk II Manual

15 Juni 2025

Hughes & Kettner Quantum QC 412 Manual

15 Juni 2025