Extron SMP 401 Manual

Extron Ikke kategoriseret SMP 401

Læs gratis den danske manual til Extron SMP 401 (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 29 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 15 anmeldelser. Har du et spørgsmål om Extron SMP 401, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

SMK F SF 10C Plus Kit • Setup Guide

This guide provides instructions for an experienced installer to install the Extron SMK F SF 10C Plus

oor mount kit for the SF 10C SUB subwoofer. The SMK F SF 10C Plus kit consists of four long legs

for mounting the speaker vertically, and four short legs for mounting the speaker horizontally. Each

kit includes 12 screws and locking nuts, and 24 washers.

NOTE: See the or for detailed instructions regarding the SF 10C SUB subwoofer.SF 10C SUB User Guide SF 10C SUB Setup Guide

ATTENTION:

• The SF 10C SUB must have rebreaks installed in the wall, above and below it, when it is protruding through a wall, to meet UL

requirements.

• Le SF 10C SUB doit disposer de systèmes coupe-feu installés au mur, au-dessus et au-dessous de l’unité, lorsqu’elle est placée

en saillie du mur, an de satisfaire les exigences de l’UL.

• The subwoofer must be securely fastened to the stud or other stationary surface when mounted in one of the vertical positions.

• Le caisson de grave doit être solidement xé au montant ou à une autre surface stationnaire lorsqu’il est monté dans l’une des

positions verticales.

NOTES:

• Remember that the sound from the unit is directed out the port. Therefore, the port needs to be pointed into the listening space.

• To ensure that the Extron grille ts fully into any masking wall or other partition, the center of the port tube must be at least

5-3/16 inches (132 mm) from the edge of the wall.

• The grille does not t if you install the legs on the subwoofer with the port tube down. Consider fabricating a small platform to lift

the subwoofer (see on the next page), or otherwise design your own way to dress your installation to give it a nished ﬁgure 2

look.

• Steps 3, 4, 5, and 8 are necessary only if you are installing the subwoofer in an adjoining space.

Installing Long Legs for Vertical Installation

The subwoofer can be set vertically on a oor using the included long legs as follows:

1. Determine where the subwoofer is to be placed and its orientation (port tube on top or port tube on the bottom).

2. Remove the grommets from the holes in the installation bracket.

3. Fasten two legs to each installation bracket using the three provided screws and locking nuts, two on one side of the foot (see

figure 1, 1) and one on the other side (2).

1221

Figure 1. Long Leg Installation

IMPORTANT:

Go to www.extron.com for the complete

user guide, installation instructions, and

specifications before connecting the

product to the power source.

SMK F SF 10C Plus Kit • Setup Guide (Continued)

4. When installing in an adjoining space far outside — On the side of the wall ( the listening space), remove enough wall material so

that the subwoofer port tube can be placed as close as possible to the wall (facing the listening space).

5. When installing in an adjoining space near inside — On the side of the wall ( the listening space), mark where the center of the

port tube faces the installation surface. The center mark must be at least 5-3/16 inches (132 mm) from the edge of the installation

surface.

6. When installing in an adjoining space — On the near side of the wall (inside the listening space), using the included grille cut-out

template, mark and cut the hole in the surface.

7. Place the subwoofer in the desired location.

8. Use the included nylon straps and included accessories, or locally-obtained perforated metal hanger straps, to secure two of the

mounting holes on the top bracket to the nearest stud or other stationary surface (see figure 2,

1). Use locally obtained hardware

suitable for the material to which the unit is being secured.

9. When installing in an adjoining space — Ensure that there are fire breaks above and below the port tube (

2) to meet UL

requirements. If necessary, fabricate them.

Listening Space

Installation Location

(Adjoining Space)

Nylon

Strap

Screw

Lock

Nut Washers (2)

Bracket

Figure 2. Securing the Floor-mounted Subwoofer and Installing Fire Breaks

Produkt Specifikationer

Mærke:	Extron
Kategori:	Ikke kategoriseret
Model:	SMP 401

Har du brug for hjælp?

Hvis du har brug for hjælp til Extron SMP 401 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Extron Manualer

Extron HC 403 Manual

16 August 2025

Extron MLC 64 RS VC D Manual

5 August 2025

Extron MGP 641 xi 5K Manual

30 Juli 2025

Extron MLC 62 RS D Manual

30 Juli 2025

Extron DTP T UWP 4K 332 D Manual

22 Juli 2025

Extron DA HD 4K PLUS Manual

21 Juli 2025

Extron IN2004 Manual

21 Juli 2025

Extron FOX3 T 311 Manual

21 Juli 2025

Extron AAP 104 Manual

20 Juli 2025

Extron DTP T DSW 4K 233 Manual

20 Juli 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Cres Cor H137WSUA5D Manual

20 August 2025

Moulinex Pulseo LM17GD Manual

20 August 2025

Tefal EasyGrill BG1303 Manual

20 August 2025

Tenda U2 Manual

20 August 2025

Tefal Ultraglide Plus FV5841 Manual

20 August 2025

Tefal I-Coach Touch QB950D Manual

20 August 2025

BEKO BDIN38551P Manual

20 August 2025

BEKO FSE52135DCRSN Manual

20 August 2025

Karma PRJ 5000 Manual

20 August 2025

Aqua-Vu Micro Stealth 4.3 Manual

20 August 2025