Extron VCM 200 EU Manual

Extron Ikke kategoriseret VCM 200 EU

Læs gratis den danske manual til Extron VCM 200 EU (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 35 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 18 anmeldelser. Har du et spørgsmål om Extron VCM 200 EU, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

VCM 200 EU • Installation Guide

This guide provides instructions for an experienced installer to install an

Extron VCM 200 EU device.

The VCM 200 EU is a remote volume/mute controller with a 10k ohm

potentiometer and button. It is designed to work solely with any Extron

amplifier product with a remote volume control port, such as the MPA 152

Plus or MPA 401 Mini Power Amplifiers. The VCM200EU is backwards

compatible, able to control existing amplifiers and preamplifiers as well as

new amplifiers and preamplifiers.

NOTE: Models of the VCM 200 EU with an E number before E30472 are not compatible with

newer amplifier models. The E number is located next to the device serial number.

The VCM 200 EU device mounts into a single sized European junction box with 60 mm centers

(not supplied). It has a matching trim plate for the finished installation.

For product specifications visit www.extron.com.

NOTE: Check that the installation meets the local and national regulatory requirements,

including building, electrical, and safety codes, and UL and accessibility requirements.

Installation

VCM 200 EU Model —

1. Install a junction box into a Euro channel

or into a wall.

2. Run the cables from the location of the audio

source, such as an MPA.

3. Where needed, in order to make the

device ush with the channel or wall,

place the supplied metal spacer plate

between the adapter plate and the junction

box.

4. Using the supplied screws, fasten the metal

adapter plate (and spacer plate if used) to the

junction box (see the image at right).

The VCM 200 EU is now ready for cabling.

Cabling

Press the VCM 200 into the trim plate and connect

the cables to the rear of the device. Wire as shown.

10V = Pin 1 is 10 VDC reference voltage.

VOL/MUTE = Pin 2 is volume and mute control with

DC voltage. The range is 0 to 10 V, where

0 V is mute and 10 V is maximum volume.

GND = Pin 3 is ground.

To complete installation, snap the device and trim plate

combination into the secured adapter plate, taking care

not to trap any cables.

VOL UME

MUT E

VCM 200 EU

Euro Channel

Junction Box

Trim Plate

Adapter Plate

VCM 200 EU

VOLU ME

MUT E

Source

Rear Panel

VCM

Rear Panel

Red

Black

Ground

10V

VOL/MUTE

1 2 3

GND

VOL

10V

Produkt Specifikationer

Mærke:	Extron
Kategori:	Ikke kategoriseret
Model:	VCM 200 EU
Bredde:	55 mm
Dybde:	18 mm
Højde:	55 mm
Produktfarve:	Hvid
Certificering:	CE, C-tick, FCC Class A, ICES, VCCI, c-UL, UL
Indgangsspænding:	10 V