Fellowes DS-12CS Manual

Fellowes Papirmakulator DS-12CS

Læs gratis den danske manual til Fellowes DS-12CS (8 sider) i kategorien Papirmakulator. Denne vejledning er vurderet som hjælpsom af 42 personer og har en gennemsnitlig bedømmelse på 4.2 stjerner ud af 21.5 anmeldelser. Har du et spørgsmål om Fellowes DS-12CS, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

Quality Office Products Since 1917

POWERSHRED®

DS-12Cs

Please read these instructions before use.

Do not discard: keep for future reference.

Veuillez lire ces instructions avant d’utiliser l’appareil.

Ne pas jeter : conserver aﬁn de consulter les directives

ultérieurement, en cas de besoin.

Lea estas instrucciones antes del uso.

No las deseche: consérvelas como referencia futura.

KEY

CAPABILITIES

ENGLISH

Model DS-12Cs

Will shred: Paper, small paper clips, credit cards and staples

Will not shred: Continuous forms, CD/DVDs, adhesive labels, transparencies,

newspaper, cardboard, large paper clips, laminates, file folders, X-rays or plastic

other than noted above

Paper shred size:

Cross-Cut ........................................................5/32 in. x 2 in. (3.9mm x 50mm)

Maximum:

Sheets per pass .................................................................................................12*

Cards per pass .....................................................................................................1*

Paper width 9 in. (229mm) ......................................................................................

* 8.5 in. p2-x11 in., 20lb., paper at 120V/60 Hz, 5.0Amps; heavier paper, humidity or (75g)

other than rated voltage may reduce capacity. Recommended daily usage rates: 120 sheets;

10 credit cards. 12 sheets per pass.

Fellowes SafeSense® shredders are designed to be operated in home and office environments ranging

between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.

H. Control switch and LEDs

I 1. Auto-On

O 2. OFF

R 3. Reverse

4. Standby (green)

5. SafeSense

Technology

(yellow)

6. Overheat (red)

A. Shredder head

B. Paper/credit card entry

C. Pull-out bin

D. Window

E. Safety Lock

F. Disconnect power switch

1. OFF

2. ON

G. See safety instructions

IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

• Keepawayfromchildrenandpets.Keephandsawayfrompaperentry.Always

set to off or unplug when not in use.

• Keepforeignobjects–gloves,jewelry,clothing,hair,etc.–awayfromshredder

openings. If object enters top opening, switch to Reverse (R) to back out object.

• Neveruseaerosolproducts,petroleumbasedlubricantsorotherflammable

products on or near shredder. Do not use canned air on shredder.

• Donotuseifdamagedordefective.Donotdisassembleshredder.

Do not place near or over heat source or water.

• Operation,maintenance,andservicerequirementsarecoveredintheinstruction

manual. Read the entire instruction manual before operating shredders.

• ThisshredderhasaDisconnectPowerSwitch(F)thatmustbeintheON(–)

position to operate shredder. In case of emergency, move switch to OFF (O)

position. This action will stop shredder immediately.

• Avoidtouchingexposedcuttingbladesundershredderhead.

• Shreddermustbepluggedintoaproperlygroundedwalloutletorsocketofthe

voltage and amperage designated on the label. The grounded outlet or socket

must be installed near the equipment and easily accessible. Energy converters,

transformers, or extension cords should not be used with this product.

• FIREHAZARD–DoNOTshredgreetingcardswithsoundchipsorbatteries.

• Forindooruseonly.

• Unplugshredderbeforecleaningorservicing.

Warning: NOTE: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment

has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be