3.
DADP-DGC
Shock absorber retainer
Festo SE & Co. KG
Ruiter Straße 82
73734 Esslingen
Germany
+49 711 347-0
www.festo.com
Assembly instructions
8174040
2022-11c
[8174042]
8174040
Translation of the original instructions
© 2023 all rights reserved to Festo SE & Co. KG
1 Applicable documents
All available documents for the product
èwww.festo.com/sp.
Document Product Table of contents
Operating instruction Linear drive DGC(I) –
Assembly instructions Stop KYC –
Operating instruction Intermediate-position module
DADM-DGC-25...40
–
Tab. 1: Applicable documents
2 Safety
2.1 Safety instructions
–Only use the product in its original condition without unauthorised modifica-
tions.
–Observe the tightening torques. Unless otherwise specified, the tolerance is
±20%.
2.2 Intended use
The shock absorber retainer fastens shock absorbersYSR(W)-DGC to the slide of
linear drivesDGC-...-GF/-KF/-FA or DGCI. Use the shock absorber retainer only in
combination with a counter part for the cushioning:
–Stop KYC
–Intermediate-position module DADM-DGC
3 Additional information
–Contact the regional Festo contact if you have technical problems
èwww.festo.com.
–Accessories èwww.festo.com/catalogue.
4 Product Range Overview
4.1 Scope of delivery
Shock absorber retainer (1x)
Screw (2x),
only with DADP-DGC-…-KF
Screw (2x)
4.2 Not in scope of delivery
Linear drive (1x)
DGC-...-GF
DGC-...-KF,
DGC-...-FA,
DGCI
Shock absorber (1x/2x)
YSR(W)-DGC
Intermediate-position module
DADM-DGC
5 Assembly
5.1 Preparation for DADP-DGC-18…-40
Fig.6
• Check the slide of the linear drive .5
Steel slide:
–Multi-piece slide[V]
–Screws[W], spring pins[X] and plastic cover[Y]
Aluminium slide:
–One-piece slide[Z]
5.2 Mounting shock absorber retainer
Fig. 7: Mounting on steel slide
Fig. 8: Mounting on aluminium slide
1. Place the centring sleeves in the seats[A].2
2. Place the shock absorber holder on the centring sleeves .1 2
Select the appropriate screws / :3 4
–shorter screws for multi-piece steel slide[V].3
–longer screws for one-piece aluminium slide[Z].4
Two screws are left over with DADP-DGC-…-KF.
4. Tighten the screws / . Observe the tightening torque.3 4
DADP-DGC -18-GF -25-GF -32-GF -18-KF -25-KF -32-KF
Screw – M5 x 303
Screw M5 x 30 M5 x 354
[Nm] 4 6
DADP-DGC -40-GF -40-KF -50 -63
Screw – M6 x 35 –3
Screw M6 x 35 M6 x 45 M8 x 454
[Nm] 8 10 25
