FireAngel SB1-R Manual

FireAngel Røgalarm SB1-R

Læs gratis den danske manual til FireAngel SB1-R (1 sider) i kategorien Røgalarm. Denne vejledning er vurderet som hjælpsom af 14 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 7.5 anmeldelser. Har du et spørgsmål om FireAngel SB1-R, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

SB1 OPTICAL SMOKE ALARM

USER MANUAL

Optical smoke alarms are suitable for detecting slow smouldering fires. Like other smoke alarms, they can be subject to nuisance alarms

from steam and should not be placed near bathrooms.

For the earliest warning, we recommend smoke alarms are fitted in all rooms where the temperature is between 0°C (32°F) and 40°C (104°F).

Prolonged exposure to temperatures outside those stated above will reduce product life.

Check with local building and fire regulations for your property, to ensure compliance.

This smoke alarm is suitable for use in mobile homes and caravans. This smoke alarm is not intended for any non-residential, commercial or

industrial application, nor for any other purpose than described.

Vanguard Centre, Coventry CV4 7EZ,

United Kingdom.

www.sprue.com

300mm

150mm

600mm

1. POSITIONING

Your smoke alarm is suitable for the

landing, hallway, bedroom, living room

and dining room.

Smoke alarms should be sited at least

300mm from light fittings and walls.

Ideally as central as possible in the room.

Smoke alarms should be positioned at

no more than 600mm vertically below the

highest point in the room.

If positioning your smoke alarm on the

wall, the top of the detection element

must be between 150mm and 300mm

below the ceiling, and at least 300mm

from any neighbouring wall.

The red operational LED on the front of the alarm should ﬂash behind the plastic surface once every 32 seconds (approx.) to show that the alarm

is active.

Do not use any other test method except the

process described in this manual.

Remove the base plate from the

alarm by twisting it anti-clockwise

and insert the battery.

Fit the baseplate to ceiling

using the screws provided.

Push and twist the alarm

clockwise onto the base plate.

2b2a

2. INSTALLATION

3. MAINTENANCE

Test the alarm every month.

Replace the alarm every 10

years

Vacuum your alarm

every 3 months.

Do not use cleaners

or solvents.

Do not paint the alarm.

Smoke alarms can react to cooking fumes or other non emergency situations. Your alarm features ‘Silence’ technology. In the event of a

known false alarm you can temporarily silence it by pressing the test button. The red operational LED on the front of the alarm will ﬂash

behind the plastic surface once every 8 seconds to show that it is in Silence mode. Your alarm will automatically return to full sensitivity

after 8 minutes. The alarm will sound continuously and the Red operational LED ﬂashes behind the plastic surface every second when the

alarm senses smoke.

NEVER IGNORE ANY ALARM. If an alarm is sounding, it is warning you of a potentially hazardous situation. Do not ignore it. Ignoring the

alarm may result in injury or death. If your smoke alarm activates and you are not absolutely certain of the source of smoke, get everyone

out of the house immediately.

In a known false alarm, the alarm can be silenced temporarily.

The alarm will silence for 8

minutes.

4. SILENCE FEATURE

TROUBLESHOOTING GUIDE

Sprue Safety Products Ltd warrants to the original purchaser that its enclosed smoke alarm be free from defects in materials and workmanship

under normal residential use and service for a period of 3 (three) years from the date of purchase (not including the replaceable battery).

Provided product is sent back to Sprue Safety Products with proof and date of purchase, Sprue Safety Products Ltd hereby warrants that

during the 3 (three) year period commencing from the date of purchase Sprue Safety Products Ltd, at its discretion, agrees to replace the unit

free of charge. The warranty on any replacement SB1 alarm, will last for the remainder of the period of the original warranty in respect of the

alarm originally purchased – that is from the date of original purchase and not from the date of receipt of the replacement product. Sprue

Safety Products Ltd reserves the right to offer an alternative product similar to that being replaced if the original model is no longer available or

in stock. This warranty applies to the original retail purchaser from the date of original retail purchase and is not transferable. Proof of purchase

is required.

This warranty does not cover damage resulting from accident, misuse, disassembly, abuse or lack of reasonable care of the product, or

applications not in accordance with the user manual. It does not cover events and conditions outside of Sprue Safety Products Ltd’s control,

such as Acts of God (ﬁre, severe weather etc.). It does not apply to retail stores, service centres or any distributors or agents. Sprue Safety

Products Ltd will not recognise any changes to this warranty by third parties.

Sprue Safety Products Ltd shall not be liable for any incidental or consequential damages caused by the breach of any expressed or implied

warranty. Except to the extent prohibited by applicable law, any implied warranty of merchantability or ﬁtness for a particular purpose is limited

in duration for 3 (three) years.

This warranty does not affect your statutory rights. Except for death or personal injury, Sprue Safety Products Ltd shall not be liable for any

loss of use, damage, cost or expense relating to this product or for any indirect, or consequential loss, damages or costs incurred by you or

any other user of this product.

DISPOSAL

Waste electrical products should not be disposed of with your other household waste. The alarm is ideally suited for disposal within the

waste electronic and electrical equipment (WEEE) recycling scheme.

Please recycle where facilities exist. Check with your local authority, retailer or contact our Technical Support team for recycling/disposal

advice as regional variations apply. The batteries should be removed before disposal of the detector. Both the batteries and the detector

should be disposed of in line with current regulations.

Do not attempt to open. Do not burn.

WARRANTY AND DISPOSAL

0359-CPR-00649

EN 4604:2 C:21 005 A + 008

Smo alke a srm device

DoP: SADOP-SB1-01

6. FAULT INDICATION

If there is a fault, the alarm will ‘chirp’ every

32 seconds followed by 2 Red operational

LED ﬂashes behind the plastic surface.

If the alarm is still within warranty,

contact Technical Support.

Your alarm requires 1 x 9V (PP3) battery. Under normal use, the battery should last approximately one year. Use of a battery other than those

recommended here may have a detrimental effect on the alarm: DC9V Gold Peak GP1604S, Raymax 6F22.

Technical Support

Online: www.ﬁreangel.co.uk/support

E-mail: technicalsupport@ﬁreangel.co.uk

Phone: 0800 141 2561 (EIRE Phone: 1-800 523 171)

Note: This user manual is also available in large text and

other formats. Please email: technicalsupport@sprue.com

or call 0800 141 2561 for further information.

GN5040R4

If your smoke alarm does

not sound during testing:

If your smoke alarm

activates when no smoke

is visible:

If your smoke alarm

sounds unusual or

‘chirps’ intermittently:

If you experience

frequent unwanted

alarms:

• Check that your battery is connected.

• If testing after ﬁrst installation, allow a few seconds for the alarm to settle.

• Push and hold the centre of the test button ﬁrmly.

• If the alarm has been silenced and is in low sensitivity mode it may not test.

Wait 15 minutes then try again.

• Replace the battery.

• Check the location of your smoke alarm.

• Clean the smoke alarm.

• Check the location of your smoke alarm.

• Clean the smoke alarm.

• Check that your smoke alarm is deﬁnitely the source of the chirping; make sure the

noise isn’t coming from another alarm.

• Check the location of your smoke alarm.

• Clean the smoke alarm.

ALARM TEST:

Press and hold the test

button for 5 seconds.

The alarm will sound.

Press and hold the test

button for 5 seconds.

5. LOW BATTERY WARNING

Replace the battery

immediately.

Always test the

alarm after replacing

the batteries.

When the alarm battery is low,

the alarm will ‘chirp’ and the

Red operational LED will ﬂash

once every 32 seconds behind

the plastic surface.

Produkt Specifikationer

Mærke:	FireAngel
Kategori:	Røgalarm
Model:	SB1-R

Har du brug for hjælp?

Hvis du har brug for hjælp til FireAngel SB1-R stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Røgalarm FireAngel Manualer

FireAngel FS1226 Manual

2 August 2025

FireAngel FS2126-T Manual

2 August 2025

FireAngel SB1-R Manual

2 August 2025

FireAngel ST-625 Manual

2 August 2025

FireAngel RLYM-1EU Manual

2 August 2025

FireAngel FA6611-R Manual

2 August 2025

FireAngel Thermoptek ST-632 Manual

2 August 2025

FireAngel NM-CO-10X Manual

11 Maj 2024

FireAngel ST-630-INT Manual

7 Januar 2024

FireAngel SW1-EUT Manual

16 Marts 2023

Røgalarm Manualer

Nyeste Røgalarm Manualer

Alecto SD530 Manual

10 November 2025

SAVS SA5MA Manual

8 November 2025

Alecto SD110 Manual

4 November 2025

Kidde 30CUA10-VCA Manual

2 November 2025

Alecto BPB21 Manual

1 November 2025

Alecto SD1010 Manual

1 November 2025

SAVS SA5MB Manual

31 Oktober 2025

Abus Comfion FURM80000 Manual

29 Oktober 2025

First Alert CO615 Manual

23 Oktober 2025

X-Sense SD11 Manual

9 Oktober 2025