Fischer Amps Hardwired In Ear Body Pack XL Manual

Fischer Amps Øreprop Hardwired In Ear Body Pack XL

Læs gratis den danske manual til Fischer Amps Hardwired In Ear Body Pack XL (4 sider) i kategorien Øreprop. Denne vejledning er vurderet som hjælpsom af 55 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 28 anmeldelser. Har du et spørgsmål om Fischer Amps Hardwired In Ear Body Pack XL, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/4
Manual
HARD-WIRED IN EAR BODY PACK XL
Dear customer:
You have decided to buy a product. Thank you.
Please read this manual carefully prior to the first use, you will get important information for
use and safety of the unit. These safety and operating instructions should be retained for
future reference.
Should you have further questions, please do not hesitate to contact FISCHER AMPS.
Product Description:
The Body Pack XL has the same functional principle as the Fischer Amps Hardwired In Ear Monitor
Belt Pack plus an additional Mic-In to add-on a microphone signal to the stereo or mono mix received.
The integrated low-noise microphone preamp has standard features such as 48V phantom power,
PAD switch to reduce the input signal by 20 dB, and gain control from +12 dB to + 60 dB. An
additional feature for the microphone input is the parallel out which allows to loop the microphone
signal.
The Body Pack XL is powered with a 9V battery or a mains adaptor (not included).
This Body Pack is a compact in ear solution not only for orchestra musicians who want to mix their
own microphone signal to the incoming in ear signal, but it is also an excellent tool for engineers to
monitor microphone signals.
Basic information on the use of in-ear monitoring systems:
CAUTION:
Using this system at too high sound levels may cause permanent hearing defects. Adjust the
volume so that you can hear sufficiently. Ringing in the ears can indicate that the adjusted
hearing level is too high. Use headphone systems with good fit which suppress the ambient
noise well. This allows that the required listening volume can be low which is kind to your
ears.
Description of the Actuators (Front Side) :
(1)
3.5mm (1/8“) Stereo Jack: Connection of the headphone system (minimum impedance 12 ohms per
channel)
Maximum output power 40 mW per channel into 20 ohms.
Tip = left signal, Ring = right signal, Sleeve = ground
(2)
Battery Control LED: This LED controls the capacity of the battery or rechargeable battery. After
switching on with a newly inserted battery the green LED lights. With
increasing operating time and decreasing battery power (remaining
capacity approx. 20%) the LED lights orange. When the LED lights red, the
battery should be replaced.
(3)
Volume Control: Adjusts the volume of the left and right side of the headphone for channels
1 und 2. The microphone signal is adjusted with a separate volume control.
(4)
Change-over switch Stereo/ Mono-Mix Mode
Stereo Mode: The device outputs the signal fed into the left input at the left headphone
and the right signal at the right headphone.
Mono Mix Mode: Channel 1 and channel 2 are mixed and output to both sides of the
headphone.
By means of the Pan (balance) controller the ratio between both channels
can be adjusted.
(5)
Pan (Balance) Controller
In Stereo Mode: Adjusts the balance of volume of channel 1 and 2 between the left and the
right headphone system.
In Mono Mix Mode: Adjusts the volume level ratio between channel 1 and channel 2. Channels
1 and 2 are output mutually to both headphone sides. In middle position
both channel levels are equal;
at left stop only channel 1, at right stop only channel 2.
(6)
Microphone Gain: Adjusts the gain of the microphone signal from 12 dB to 60 dB.
When the PAD switch is activated, the adjusted gain is reduced by -20 dB.
(7)
LED Microphone Signal: Controls the level of the microphone signal after the microphone preamp.
When LED 0 dB lights, the working level is adjusted correctly. Peak levels
cause the LED to light red for a short period of time, however, the LED may
not constantly light red.
(8)
PAD Switch: The PAD switch reduces the adjusted gain value by -20 dB (which is
required for signals with a higher level).
(9)
LOW Cut Switch: Adds on a 70Hz Low-Cut with 18 dB/oct. after the microphone preamp; this
reduces deep bass signals.
(10)
Microphone Volume: Controls the volume of the microphone signal at the headphone output
(L/R)

Produkt Specifikationer

Mærke: Fischer Amps
Kategori: Øreprop
Model: Hardwired In Ear Body Pack XL

Har du brug for hjælp?

Hvis du har brug for hjælp til Fischer Amps Hardwired In Ear Body Pack XL stil et spørgsmål nedenfor, og andre brugere vil svare dig


Øreprop Fischer Amps Manualer

Fischer Amps

Fischer Amps Hardwired In Ear Body Pack XL Manual

17 August 2024
Fischer Amps

Fischer Amps FA-3E Manual

16 August 2024

Øreprop Manualer

Nyeste Øreprop Manualer

Trust

Trust Primo Touch 23782 Manual

3 April 2025
Trust

Trust Primo Touch 23783 Manual

3 April 2025
Philips

Philips 2000 series TAQ2000 Manual

3 April 2025
Trust

Trust Oxxie GXT 409 Manual

30 Marts 2025
Soundcore

Soundcore Liberty 4 Pro Manual

27 Marts 2025
Buxton

Buxton BTW 3800 Manual

26 Marts 2025
Philips

Philips 1000 series TAT1109 Manual

11 Marts 2025
Adidas

Adidas Z.N.E.01 Manual

21 Februar 2025
Elbe

Elbe AU-P20-MIC Manual

20 Februar 2025
Elbe

Elbe AU-R10-MIC Manual

20 Februar 2025