Fishman PRO-PJA-001 Manual

Fishman Guitar forstærker PRO-PJA-001

Læs gratis den danske manual til Fishman PRO-PJA-001 (2 sider) i kategorien Guitar forstærker. Denne vejledning er vurderet som hjælpsom af 31 personer og har en gennemsnitlig bedømmelse på 4.1 stjerner ud af 16 anmeldelser. Har du et spørgsmål om Fishman PRO-PJA-001, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/2
www.fishman.com
1
Read Me First!
Installation of this product is a simple procedure,
but we recommend this job only if you are an
experienced repair technician.
Preliminary
Widen the endpin hole to 15⁄32” (11.9mm) to
accommodate the endpin jack.
If using the Powerjack with new pickup, install pickup
according to its provided instructions.
Installation
Observe the following
precaution!
• Do not overheat the solder pads! Doing so
may lift the pads from the circuit board.
Solder the wire connections
1. Unscrew the shielding cap to access the preamp
circuit board.
2. Strip ¼” off the outside jacket of the pickup wire.
Tin both the inner conductor and the ground wire.
3. Thread the pickup wire through the shielding cap.
4. Thread the pickup wire through the largest of the
three strain relief holes, then solder the signal wire
from the pickup (hot wire) to the pad marked “IN”
on the preamp circuit board. Solder the ground wire
from the pickup (shield) to the adjacent pad marked
“G” on the preamp circuit board (fi gure 1).
5. Fasten the shielding cap to the jack. Be careful
not to allow the shielding cap to come in contact
with the end of the circuit board.
6. Lock the shielding cap to the fi rst large hex nut.
Endpin jack
Install the endpin jack per Switchjack Installation
Guide.
Battery bag
Install the battery bag on or near the neck block
(fi gure 2).
1. Clean the area where you will mount the bag
with an alcohol wipe or cotton swab moistened
with rubbing alcohol. Let dry.
2. Peel off the plastic fi lm from the Velcro patch and
attach the bag at the chosen location.
POWERJACK
INSTALLATION GUIDE
+G
IN R
-
Pickup Signal
to "IN"
Pickup Shield
to Ground ("G")
Battery Bag
Pickup
Powerjack
Figure 1
Figure 2
www.fi shman.com
3. Carefully separate the bag from the Velcro patch.
To set the adhesive, burnish the entire area of the
patch, especially the edges.
4. Install a 9V alkaline or lithium battery. Tuck the
battery into the bag and re-attach to the Velcro
patch. The adhesive under the Velcro patch requires
24 hours to achieve a full bond, so take care to not
stress the adhesive if you remove the battery bag
after the initial installation.
Second pickup source option
A second source such as a microphone or magnetic
soundhole pickup may be added (fi gure 3). The
output will appear on the ring connection when a
tip-ring-sleeve ¼” jack is inserted.
For specifi c wiring diagrams, refer to fi shman.com.
Specifi cations
Power Supply: 9 Volt alkaline battery
Battery Life: 2,000 hours
Maximum Output
Voltage: 4V peak to peak
Input Overload: -.7dBV
Input Impedance: 10MOhms
Output Impedance: Less than 5kOhm
System Gain: 3dB
Signal-to-Noise Ratio: 94dB
Discrete Component
Design: FET low noise class A
input stage, bipolar class
AB output stage
+G
IN R
-
Pickup Signal
to “IN”
2nd Pickup Signal
to Ring (“R”)
Pickup Shield
to Ground (“G”)
2nd Pickup Shield
to Ground (“G”)
Figure 3
514-300-114 Rev A 5-09

Produkt Specifikationer

Mærke: Fishman
Kategori: Guitar forstærker
Model: PRO-PJA-001

Har du brug for hjælp?

Hvis du har brug for hjælp til Fishman PRO-PJA-001 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Guitar forstærker Fishman Manualer

Fishman

Fishman Loudbox Mini Charge Manual

1 September 2024
Fishman

Fishman PRO-PJA-001 Manual

31 August 2024
Fishman

Fishman Platinum Pro EQ Manual

18 August 2024

Guitar forstærker Manualer

Nyeste Guitar forstærker Manualer

Marshall

Marshall JVM410H Manual

11 Januar 2025
Blackstar

Blackstar CabRig Manual

9 Januar 2025
Blackstar

Blackstar ID:CORE Stereo 10 V4 Manual

9 Januar 2025
Boss

Boss KATANA-MINI X Manual

8 Januar 2025
Hartke

Hartke HD50 Manual

29 December 2024
Mooer

Mooer Envelope Manual

29 December 2024
Mooer

Mooer Liquid Manual

29 December 2024
Orange

Orange Terror Bass Manual

27 December 2024
API Audio

API Audio Tranzformer GT Manual

25 December 2024
API Audio

API Audio Tranzformer LX Manual

25 December 2024