FLIR First Mate II HM 324XP+ Manual

FLIR Kamera First Mate II HM 324XP+

Læs gratis den danske manual til FLIR First Mate II HM 324XP+ (2 sider) i kategorien Kamera. Denne vejledning er vurderet som hjælpsom af 29 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 15 anmeldelser. Har du et spørgsmål om FLIR First Mate II HM 324XP+, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

432-0004-31-1 2 Rev 100 Jan 2013

HM-Series Quick Start Guide

Power Button – The HM-Series camera has 3 power modes: On, Off, and

Standby.

• On - Takes approximately 90 seconds (during bootup there is a

fast-flashing red LED on the eyepiece display).

• Standby - After the camera is on, pressing the Power button will

toggle the camera between On and Standby mode. (In Standby

there is a slow-flashing red LED on the eyepiece display).

• Off - Push and hold the power button for 8 sec. to turn off.

Capture Button – Some models only; take snapshots (press and

release) or video clips (press and hold) to the SD memory card.

Display Brightness – Toggle through five brightness settings.

White/Black Hot/Instalert – In White Hot mode, hotter items appear as white

or light grey. In Black Hot, hotter items appear as black or dark grey. In Instalert,

hotter items in a scene are highlighted in red.

2× Zoom –Some models only; causes the image to zoom to 2X.

Diopter Control – Adjust the diopter setting for the sharpest image in

the viewfinder.

PowerCapture2x zoom

Display

Adjustable

Diopter

Eyepiece

Lens Cap

Brightness

White hot/

Black hot/

Marine Red

432-0004-31-1 2 Rev 100 Jan 2013

HM-Series Quick Start Guide

Installing the Batteries and SD Card

The batteries must be installed and charged before using your camera.

Install your SD card.

1. Remove the small SD card door.

No tools are required.

2. Install the SD card.

3. Loosen the four captive screws securing the

battery cover.

4. Remove the battery cover by grasping the front

edge where the SD card door was removed.

5. Install the batteries as shown.

6. Snap the SD card door back into place and re-

install the battery cover—it only fits one way.

Charging the Camera

The batteries in the camera must be charged prior to their first use.

1. Connect the Hot Shoe to your camera.

2. Ensure that the plug is fully seated in the Hot

Shoe.

When charging correctly, the charging indicator

will be lit yellow and will blink green for one second

within about 35 seconds.

The charging indicator will continue to blink at

decreasing intervals until the batteries are fully

charged.

When fully charged, the charging indicator will be

lit solid green. The initial charge time is

approximately 4 hours.

www.flir.com

Grasp SD card

Battery

cover

door edges

and pull

–

Plug from power adapter

Charging

indicator

Solid

green

Produkt Specifikationer

Mærke:	FLIR
Kategori:	Kamera
Model:	First Mate II HM 324XP+

Har du brug for hjælp?

Hvis du har brug for hjælp til FLIR First Mate II HM 324XP+ stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Kamera FLIR Manualer

FLIR C5 Manual

13 September 2024

FLIR ONE Pro LT Manual

10 September 2024

FLIR T1050 Manual

26 August 2024

FLIR ONE Android Manual

26 August 2024

FLIR T1030 Manual

26 August 2024

FLIR First Mate II HM 324XP+ Manual

4 August 2024

FLIR BHM X+ Manual

3 August 2024

FLIR First Mate II HM 224 Pro Manual

30 Juli 2024

FLIR Ocean Scout 320 Manual

26 Juli 2024

FLIR Duo R Manual

25 Juli 2024

Kamera Manualer

Nyeste Kamera Manualer

IMILAB C22 Manual

9 Juni 2025

Overmax Camspot 4.8 Manual

9 Juni 2025

Overmax Camspot 4.0 PTZ Manual

8 Juni 2025

Vemer EasyEye.NOW Manual

2 April 2025

Rollei HD-30 Manual

29 Marts 2025

Rollei Security Cam 1080p Manual

29 Marts 2025

Aida HD-NDI-X20 Manual

27 Marts 2025

Hasselblad CFV II 50c Manual

27 Marts 2025

Marshall Electronics CV228 Manual

12 Marts 2025

AViPAS AV-1180 Manual

12 Marts 2025