Fluval CO2 Manual

Fluval Ikke kategoriseret CO2

Læs gratis den danske manual til Fluval CO2 (30 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 26 personer og har en gennemsnitlig bedømmelse på 4.1 stjerner ud af 13.5 anmeldelser. Har du et spørgsmål om Fluval CO2, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/30

PRESSURIZED CO2 KIT - 45 g

Instruction Manual

TROUSSE DE CO2 PRESSURISÉ,

45 G

Mode d’emploi

CO2-KIT ONDER DRUK – 45 g

Handleiding

KIT DE CO2 A PRESIÓN – 45 g

Manual de instrucciones

UNTER DRUCK STEHENDES

CO2-SET – 45 g

Gebrauchsanleitung

SAFETY WARNINGS

1) The

cartridge included with this kit contains pressurized

gas. Incinerate. Puncture. Do Not Do Not

Do Not heat or store at temperatures above 60 °C (140 ° F).

2) inhale or discharge Do Not

gas towards face or body. Keep out of reach of children.

3) The

cartridge is reﬁllable. reﬁll. Disposable cartridge. Only for use with aquarium.Not Do not

4) This device and its consumable

cartridges are not intended for use by persons (including children) with signiﬁcantly

impaired physical or mental capabilities, unless they have been given supervision or instruction concerning the use of the

appliance by a person responsible for their safety. Children should always be supervised to ensure that they do not play with

the appliance.

5) use for any purpose other than as described below.Do Not

Cartridge. Not for use with other compressed air devices such as seltzer bottles, tire inﬂators or air guns.

INSTALLATION INSTRUCTIONS

1) Make sure that the regulator valve is closed (turn fully clockwise) .(A)

2) Thread the regulator to the

cartridge quickly and tighten until valve pierces cylinder (snug ﬁt) . (B)

Caution: Ensure not to cross thread. Place

cartridge with the regulator valve in the bracket .(C)

3) To connect regulator to bubble counter/check valve, unscrew and remove clamping nut on side of regulator. Thread one end

of hose through the nut. Push hose onto regulator ﬁtting and screw knob back onto regulator (hand tight) . Cut hosing from (D)

regulator to bubble counter. Ensure enough hose is leftover for diffuser installation. Connect hosing to bubble counter/check

valve by loosening tube lock connector with arrow pointing in (located at the top cap) Thread hose onto bubble counter/check

valve (hand tight). Thread remaining hose end onto tube lock connector with arrow pointing out (hand tight) .(E)

4) Unscrew bubble counter/check valve, ﬁll with water and close (hand tight). Afﬁx bubble counter/check valve to exterior

aquarium glass using suction cup. For best results, install between regulator and rim of aquarium.

5) To connect bubble counter/check valve to diffuser, push loose end of hose into top portion of

Diffuser (F). Afﬁx

Diffuser to inside tank glass . Maximum (G)

diffusion is achieved by placing

diffuser at the bottom of the tank.

6) Rest or hook

cartridge to side of tank .(H)

7) Once installation is complete, slowly open regulator until you see bubbles. Adjust bubble rate to 1 bubble every 2 seconds.

For best

economy and performance, turn regulator off when aquarium is not illuminated. To facilitate subsequent

use, indicate off and desired

bubble rate positions on regulator and on/off knob with a marker. It is strongly recommended

to test pH and KH levels regularly and adjust

infusion to your speciﬁc aquarium water values.

8) Once bubble rate is adjusted, you will see the pressure # on the pressure gage. Please take down this number for future

reference. As Note:

cartridge empties, the pressure will lower and periodic adjustments to the bubble rate may be

required.

MAINTENANCE

When the pressure gage in front of the regulator indicates “0” this is an indication that the

cartridge is empty or is about to

be. Once the

cartridge becomes empty it must be removed and replaced, but before doing so, make sure that the regulator

valve is closed. The

cartridge provided with this kit is disposable and recyclable. Replacement

cartridges are available at

reputable pet retailers. To ensure proper performance of the system, we recommend replacing only with Fluval

Cartridges

(Item# 17555 - 1pack / #17556 - 3pack). To replace

cartridge, follow points 1, 2, 9 and 10 of the installation instructions.

The ceramic disc can become clogged. For proper operation, replace ceramic disc on diffuser regularly ( ).Item #17549

Congratulations on your purchase of the Fluval Pressurized CO

Kit – 45g. This complete system is designed to efﬁciently supply aquariums up to

30 US Gal. (115 L) with the necessary quantities of CO

for optimum plant growth and health. To safely enjoy the beneﬁts of this kit, it is important to

follow the Safety Warnings, Installation Instructions, and Maintenance information provided here.

THIS KIT INCLUDES:

1. High-Quality Regulator Valve

2. CO2 Cartridge - 1 x 45 g

3. Support Base

4. Ceramic CO2 Diffuser

5. 2-in-1 Bubble Counter/Check Valve

6. Hose

Produkt Specifikationer

Mærke:	Fluval
Kategori:	Ikke kategoriseret
Model:	CO2

Har du brug for hjælp?

Hvis du har brug for hjælp til Fluval CO2 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Fluval Manualer

26 December 2024

7 November 2024

30 August 2024

30 August 2024

13 Juli 2024

Fluval Bio-CO2 Pro Manual

13 Juli 2024

Fluval PF2 Manual

10 Juli 2024

Fluval CO2 Manual

10 Juli 2024

Fluval Aquasky Manual

16 Juni 2024

Fluval Sea Manual

16 Juni 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Planet Audio P100CPA Manual

15 Juni 2025

Sabrent BK-MAC2 Manual

15 Juni 2025

Planet Audio P9950CPA Manual

15 Juni 2025

Filmcity FC-CTH-01 Manual

15 Juni 2025

Cleveland 22CGT6 Manual

15 Juni 2025

Auray SVRK-4U-S Manual

15 Juni 2025

Bobrick B-2860 Manual

15 Juni 2025

Sony ODBK-103 Manual

15 Juni 2025

Planet Audio P70CPA Manual

15 Juni 2025

Gourmia GAF657 Manual

15 Juni 2025