Gazebo Penguin 41212MR-32 Manual

Gazebo Penguin Ikke kategoriseret 41212MR-32

Læs gratis den danske manual til Gazebo Penguin 41212MR-32 (31 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 4 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 2.5 anmeldelser. Har du et spørgsmål om Gazebo Penguin 41212MR-32, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/31

ZZZ-182.41212MR.1216-21.GP.EN.doc WEB VERSION 1

41212MR-12 SAND

41212MR-32 SLATE

12 X 12 SOLARIUM

ASSEMBLY INSTRUCTIONS

DO NOT DESTROY THE BOXES UNTIL COMPLETELY ASSEMBLED

PLEASE VERIFY THE CONTENT OF EACH BOX AGAINST THE LIST OF PARTS

Two or more adults required for assembly

Base Dimensions 12’ ½” x 12’ ½”

Largest Dimensions 12’10”x12’10”

Overall Height 110’’

APPROX.

ZZZ-182.41212MR.1216-21.GP.EN.doc WEB VERSION 2

DO NOT DESTROY THE BOXES UNTIL COMPLETELY ASSEMBLED

PLEASE VERIFY THE CONTENT OF EACH BOX AGAINST THE LIST OF PARTS

12ft x 12ft / 3.66m x 3.66m Solarium

Instruction Manual

IMPORTANT: RETAIN FOR FUTURE REFERENCE, READ CAREFULLY

For assistance with assembly, installation, parts, or customer service, contact Gazebo Penguin Customer

Service Department at the numbers listed below (English & French, Mon-Fri 8:00 AM to 4:00 PM EST):

Montreal: (514) 276-3485 Elsewhere in Canada and the US: 1-800-737-7174

Consult with your local governing authority / local municipal codes regarding installation of temporary structures before

purchase or assembly. Some jurisdictions may require permits for, or otherwise regulate, installation and use.

WARNING:

 For outdoor use.

 Snow should be regularly cleared from the roof and not allowed to accumulate.

 Retain your proof of purchase for warranty purposes. Also keep the original boxes

until the installation is complete and correct.

 The unit may take more than 4 hours and 3 people are required for this assembly.

PRIOR TO ASSEMBLY:

 Please don't destroy boxes until completely assembled.

 The foundation must be level, flat, and solid, such as concrete or asphalt.

 Keep away from overhead utility lines, tree branches, and other structures.

 Check for underground pipes or wires if digging or drilling is required.

 Do not install near roof lines or other structures that could shed snow, ice, or excessive rain run-off onto the roof top.

 Assemble the structure as close to its final location as possible.

 It is recommended to wear safety gloves, safety glasses, and hard hats for installation.

 Do not hang from, climb on, or stand on the structure or roof.

 Before assembly, read instructions and check that all parts are present in the boxes. If any parts are missing, refer to warranty

information.

 A 6ft (1.8m) stepladder, Phillips screwdriver, tape measure, level, mallet, and a tarp to place parts on will be required for

assembly (not included).

 Remove top protective film from roof panels prior to assembly; DO NOT remove bottom protective film until ready to insert roof

panels, so as to identify which side is on top.

ANCHORING INSTRUCTIONS:

 Proper anchoring of the frame to the base and the wall is required for safety.

 Any structure not anchored securely has the potential to fly away during high wind causing damage and safety hazard.

 How the item is anchored, and the hardware and tools required, will vary based upon the set up location and are not provided.

 Please check with your local hardware store if for the appropriate anchors for your surface.

 Do not anchor to pavers / pavement slabs because they are not a solid foundation.

 Periodically check the anchors to ensure they remain secure

CARE AND MAINTENANCE:

 In case of a defective or damaged part, or for any other questions concerning the product, please contact the manufacturer

directly.

 Please have the parts list and part numbers on hand when ordering or requesting replacement parts.

ROOF PANELS:

 Gently clean with an environmentally-friendly soap solution and water using a sponge or washcloth.

 Do not use abrasive materials, wire brushes, chemicals, harsh cleaners, or bleach.

 Rinse using a garden hose and air dry. If removed, ensure thoroughly dry prior to storage.

 Do not use pressure washer.

STRUCTURE:

 Gently clean with an environmentally-friendly soap solution and water using a sponge or washcloth.

 Do not use abrasive materials, wire brushes, chemicals, harsh cleaners, or bleach.

 Rinse using a garden hose and air dry.

 Do not use pressure washer.

 If there are nicks, chips, and/or scratches see the part # of the paint in the parts list to obtain a matching touch-up paint.

Produkt Specifikationer

Mærke:	Gazebo Penguin
Kategori:	Ikke kategoriseret
Model:	41212MR-32

Har du brug for hjælp?

Hvis du har brug for hjælp til Gazebo Penguin 41212MR-32 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Gazebo Penguin Manualer

Gazebo Penguin 41212MR-12 Manual

12 August 2025

Gazebo Penguin 41212MR-32 Manual

12 August 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Rowenta Studio Dry 2100 CV5330 Manual

14 August 2025

American Audio DCD-PRO610 Manual

14 August 2025

Conair InfinitiPRO 1000 Manual

14 August 2025

Philips Uv Sanitizer HX6907 Manual

14 August 2025

Rowenta SuperGrill GR451B Manual

14 August 2025

Daikin ALB05RBSNADBT01 Manual

14 August 2025

Philips SWS3685S Manual

14 August 2025

Crestron C2N-IRGW-1G Manual

14 August 2025

American Audio Epsilon Manual

14 August 2025

Voltcraft VC-OBD-9770 Manual

14 August 2025