GE DNCD450EAWC Manual

GE Tørretumbler DNCD450EAWC

Læs gratis den danske manual til GE DNCD450EAWC (2 sider) i kategorien Tørretumbler. Denne vejledning er vurderet som hjælpsom af 103 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 52 anmeldelser. Har du et spørgsmål om GE DNCD450EAWC, eller vil du spørge andre brugere om produktet?

Side 1/2
Installation instructions
Vision-Impaired
for your new
Washer/Dryer Kit
For Washer WNCD2050
and Dryer DNCD450
Before you begin—Read these instructions completely and carefully.
IMPORTANT—OBSERVE ALL GOVERNING CODES AND ORDINANCES.
Note to Installer—Be sure to leave these instructions with the Consumer.
Note to Consumer—Keep these instructions with your Owners Manual for future reference.
Removing the Old Button Overlay
1. Unplug the washer or dryer.
2. Carefully peel the old button overlay from the
control panel, using a tape-tipped putty knife if
necessary. Make sure that excess adhesive is
removed from the control panel. Keep the old
overlay handy as a reference.
Parts Included
Washer and Dryer Overlays
Braille Reference Keys (2 washer, 2 dryer)
Use and Care Audio Tape
Tools Needed
Tape-tipped putty knife (optional)
Printed in the United States
175D1807P392
Braille Reference Keys
The Braille reference keys included in the kit explain
the operation of the washer and dryer. Place the
Left
key on the left side and the
Right
key on the right
side of the control panel.
NOTE:
Make sure the protective film is removed
from the washer or dryer control panel before
applying the reference keys.
Applying the Braille Overlay
1. Plug the washer or dryer back in.
2.
For washers:
Using the old overlay as a reference,
press and hold the
White Cottons
button in the
upper left corner and the
Start
button in the upper
right corner of the control panel. After 3 seconds,
all lights on the control panel will light up.
For dryers:
Using the old overlay as a reference,
press and hold the
Air Dry
button in the lower left
and the
High
heat button in the upper right of the
control panel. After 3 seconds, all lights on the
control panel will light up.
3. Peel the paper backing from the Braille overlay.
Starting on one side of the panel, apply the Braille
overlay over the buttons, using the lights for
alignment. If the overlay does not line up properly
so all lights are visible through the overlay, peel it
off and reapply. Once the overlay is properly
aligned, press firmly around the border to secure
it in place.
4. Once the overlay is applied, press
STOP/CANCEL
to turn off the control panel lights.


Produkt Specifikationer

Mærke: GE
Kategori: Tørretumbler
Model: DNCD450EAWC

Har du brug for hjælp?

Hvis du har brug for hjælp til GE DNCD450EAWC stil et spørgsmål nedenfor, og andre brugere vil svare dig




Tørretumbler GE Manualer

Tørretumbler Manualer

Nyeste Tørretumbler Manualer

Candy

Candy BS H9N3B-S Manual

28 September 2025
Hoover

Hoover HRE H9N2TE-80 Manual

28 September 2025
Samsung

Samsung DV70M50203W Manual

28 September 2025
Amana

Amana NED5800TQ0 Manual

28 September 2025
Amana

Amana NED4655EW Manual

27 September 2025
Amana

Amana NGD4600YQ Manual

27 September 2025
Siemens

Siemens WT44E107DN Manual

26 September 2025
Electrolux

Electrolux XLND65835N Manual

25 September 2025
Electrolux

Electrolux EW9H39A Manual

24 September 2025
Electrolux

Electrolux XLND86955N Manual

24 September 2025