GE JVX5365SJSS Manual

GE Emhætte JVX5365SJSS

Læs gratis den danske manual til GE JVX5365SJSS (4 sider) i kategorien Emhætte. Denne vejledning er vurderet som hjælpsom af 52 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 26.5 anmeldelser. Har du et spørgsmål om GE JVX5365SJSS, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/4
Installation
Instructions
BEFORE YOU BEGIN
Read these instructions carefully and completely.
• IMPORTANT — Save these instructions
for local inspector’s use.
• IMPORTANT — Observe all governing
codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the consumer.
• Note to Consumer – Keep these instructions for
future reference.
• Proper installation is the responsibility of the installer
• Product failure due to improper installation is not
covered under the Warranty.
Range Hood Connection to
Wall Switch
JVX3240, JVX3300, JVX5305 and JVX5365
TOOLS NEEDED
If you have questions, call GE Appliances at 800.GE.CARES (800.432.2737).
31-11120-1 09-17 GEA
1/4” Nutdriver
Flat blade and Phillips
Head Screwdrivers
FOR YOUR SAFETY
WARNING Before beginning the installation,
switch power o at service panel and lock the
service disconnecting means to prevent power from
being switched on accidentally. When the service
disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag, to
the service panel.
WARNING TO REDUCE THE RISK
OF FIRE, ELECTRIC SHOCK OR
INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
A Installation work and electrical wiring must be
done by qualied person(s) in accordance with
all applicable codes and standards, including
re-rated construction.
B When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities.
POWER SUPPLY
IMPORTANT – (Please read carefully)
WARNING FOR PERSONAL SAFETY, THIS
APPLIANCE MUST BE PROPERLY GROUNDED.
Remove house fuse or open circuit breaker before
beginning installation.
Do not use an extension cord or adapter plug with
this appliance. Follow National Electrical Codes or
prevailing local codes and ordinances.
Electrical supply
These vent hoods must be supplied with 120V, 60Hz,
and connected to an individual, properly grounded
branch circuit, and protected by a 15 or 20 amp circuit
breaker or time delay fuse.
• Wiring must be 2 wire with ground.
• If the electrical supply does not meet the above
requirements, call a licensed electrician before
proceeding.
• Route house wiring as close to the installation
location as possible in the ceiling or wall.
• Connect the wiring to the house wiring in
accordance with local codes.
Grounding instructions
The grounding conductor must be connected to
a ground metal, permanent wiring system, or an
equipment-grounding terminal or lead on the hood.
WARNING The improper connection of the
equipment-grounding conductor can result in a risk
of electric shock. Check with a qualified electrician
or service representative if you are in doubt whether
the appliance is properly grounded.
Wire cutter/stripper
231-11120-1
Installation Instructions
CONNECTION METHOD FOR JVX3240 AND JVX3300
PARTS NEEDED
■ 2-Position and 3-Position wall switches.
■ Electrical wire to connect to wall switch in accordance
with local codes.
■ Wire nuts. Use appropriate wire nuts for size of the
electrical wire.
■ 18 gage white wire.
MOTOR
C30 DX
0
3
BLK
1
ORG
2
VLT
1
GREY
WHT
PINK
ORG
1
VLT
VLT
3
REDRED
OFF
1
WHT
2
WHT
BLK
BLK
BLK
LINE
120Vac
60Hz
HOOD INTERNAL CONTROL
WHT
2
WHT
LAMP
VLT
MOTOR
C30 DX
0
3
BLK
HOOD EXTERNAL CONTROL
ORG
1 2
VLT
1
ORG
1
VLT
RED
OFF
WHT
WHT
BLK
BLK
LINE
120Vac
60Hz
WHT
2
WHT
VLT
LAMP
EXTERNAL
CONTROL
COM S2
G
S1
SPEED2
SPEED1
CONTROL
L
LIGHT
CONTROL
LIGHT
LIGHT
L
WIRING
BOX
GREY
WHT
PINK
WIRING
BOX
312
MOTOR
This connection method allows full control of the range hood using wall switches. However, the rocker switch on the
range hood will be disconnected if this method is used for connection of range hood to wall switch.
Step 1: To establish connection of hood fan to wall
switch, locate the hood junction box and remove its cover.
Step 2: Disconnect the pink wire in the junction box
coming from the motor from the wire coming from red
3-position rocker switch on the range hood. Cap the red
wire coming from 3-position rocker using appropriate
size wire nut.
Step 3: Connect the pink wire in the junction box
coming from the motor to a 3-position wall switch. This
will allow control of high fan speed.
Step 4: Disconnect the grey wire in the junction box
coming from the motor from the wire coming black
from 3-position rocker switch on the range hood. Cap
the black wire coming from 3-position rocker using
appropriate size wire nut.
Step 5: Connect the grey wire in the junction box
coming from the motor to a 3-position wall switch. This
will allow control of low fan speed.
Step 6: Connect a black wire from hot on 3 position wall
switch for fan to the hot wire in the junction box.black
Step 7: Disconnect the orange wire in the junction box
from the wire coming from the motor and cap the white
orange wire using appropriate size wire nut.
Step 8: Connect an 18 gage white wire to the white wire
coming from the motor using appropriate size wire nut
at one end. At the other end connect the 18 gage white
wire to the neutral wire in the junction box using white
appropriate size wire nut.
Step 9: To establish connection of hood lights to wall
switch, connect a wire from hot on 2 position wall black
switch for light to the hot wire in the junction box.black
Step 10: Disconnect the violet wire in the junction box
coming from the lamps from the wire coming violet
from 2 position rocker switch on the range hood. Cap
the violet wire coming from 2 position rocker using
appropriate size wire nut.
Step 11: Connect the violet wire in the junction box
coming from the lamps to the 2 position wall switch.
Step 12: Re-install the junction box cover using the
screws.
Wiring Diagram 991.0438.344
Before getting started, check the wiring diagram number on your hood to make sure
these install instructions apply to your model

Produkt Specifikationer

Mærke: GE
Kategori: Emhætte
Model: JVX5365SJSS

Har du brug for hjælp?

Hvis du har brug for hjælp til GE JVX5365SJSS stil et spørgsmål nedenfor, og andre brugere vil svare dig


Emhætte GE Manualer

GE

GE JV565HBB Profile Manual

31 Maj 2025
GE

GE JV665HWW Profile Manual

31 Maj 2025
GE

GE JV666HSS Profile Manual

31 Maj 2025
GE

GE JV635HWW Profile Manual

29 Maj 2025
GE

GE UVC9480SLSS Manual

30 December 2025
GE

GE JV665HBB Profile Manual

15 December 2024
GE

GE UVC9420SLSS Manual

7 December 2024
GE

GE JV337XAD Manual

19 September 2024
GE

GE UVD6301DPBB Manual

1 September 2024
GE

GE UVD6361DPBB Manual

1 September 2024

Emhætte Manualer

Nyeste Emhætte Manualer

Comfee

Comfee CHW 7.6M77A3 Manual

17 Juni 2025
Smeg

Smeg KPRU24X Manual

17 Juni 2025
Smeg

Smeg KBTU48X Manual

17 Juni 2025
Smeg

Smeg KPRU36X Manual

17 Juni 2025
AEG

AEG NDE562DB Manual

17 Juni 2025
ElectriQ

ElectriQ eiQTMVISOR Manual

17 Juni 2025
Comfee

Comfee CHT 3.6B Manual

17 Juni 2025
ElectriQ

ElectriQ eiQ90CANGBL Manual

17 Juni 2025
Comfee

Comfee CHK 3.6.6J64A1B Manual

17 Juni 2025
ElectriQ

ElectriQ eiQ52CANGBL Manual

17 Juni 2025