GE Profile JP939CHCC Manual

GE Ovn Profile JP939CHCC

Læs gratis den danske manual til GE Profile JP939CHCC (8 sider) i kategorien Ovn. Denne vejledning er vurderet som hjælpsom af 20 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 10.5 anmeldelser. Har du et spørgsmål om GE Profile JP939CHCC, eller vil du spørge andre brugere om produktet?

Side 1/8
1
TOOLS YOU WILL NEED
MATERIALS YOU WILL NEED
229C4053P529-1
31-10545-1 05-03 JR
Installation
30Electric Cooktop
Instructions
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
IMPORTANT Save these
instructions for local inspectors use.
IMPORTANT Observe all
governing codes and ordinances.
Note to Installer Be sure to leave these
instructions with the Consumer.
Note to Consumer Keep these
instructions for future reference.
Product failure due to improper installation
is not covered under the Warranty.
WARNING This appliance must
be properly grounded.
ATTENTION INSTALLER
ALL COOKTOPS MUST BE HARD WIRED
(DIRECT WIRED) INTO AN APPROVED
JUNCTION BOX. A “PLUG AND
RECEPTACLE” IS NOT PERMITTED ON
THESE PRODUCTS.
Proper installation is the responsibility
of the installer and product failure due to
improper installation is NOT covered under
warranty.
PARTS INCLUDED
Wire Nuts
Junction Box
Saber Saw
Pencil
Safety Glasses
1/8Drill Bit & Electric
or Hand Drill
Ruler or Straightedge
Phillips Head
Screwdriver
JP340, JP350, JP930, JP931, JP938, JP939
“If you have questions, call 800.GE.CARES or visit our website at:
www.GEAppliances.com”
2 Hold Down
Brackets
4 Screws Foam Tape
2
Installation Instructions
FOR YOUR SAFETY
For Personal Safety, remove house fuse
or open circuit breaker before beginning
installation. Failure to do so could result
in serious injury or death.
Be sure your cooktop is installed properly
by a qualified installer or service technician.
To eliminate the risk of burns or fire due
to reaching over heated surface elements,
cabinet storage located above the surface
units should be avoided. If cabinet storage
space is to be provided, the risk can be
reduced by installing a range hood that
projects horizontally a minimum of 5
beyond the bottom of the cabinets. Cabinet
installation above the cooktop may be no
deeper than 13.
Make sure the cabinets and wall coverings
around the cooktop can withstand the
temperatures (up to 200°F) generated
by the cooktop.
The cooktop should be easy to reach and
lighted with natural light during the day.
Always disconnect the electrical service to
the cooktop before repairing or servicing
the cooktop. This can be done by
disconnecting the fuse or circuit breaker.
Failure to do this could result in a
dangerous or fatal shock. Know where your
main disconnect switch is located. If you do
not know, have your electrician show you.
IMPORTANT SAFETY INSTRUCTIONS
ELECTRICAL REQUIREMENTS
This appliance must be supplied with the
proper voltage and frequency, and connected
to an individual, properly grounded branch
circuit, protected by a circuit breaker or a
time delay fuse as noted on rating plate.
We recommend you have the electrical wiring
and hookup of your cooktop connected by a
qualified electrician. After installation, have
the electrician show you where your main
cooktop disconnect is located.
Wiring must conform to National Electrical
Code. You can get a copy of the National
Electrical Code, ANSI/NFPA No. 70-Latest
Edition, by writing:
National Fire Protection Association
Batterymarch Park
Quincy, MA 02269
The cooktop conduit wiring is approved for
copper wire connection only, and if you have
aluminum house wiring, you must use
special UL approved connectors for joining
copper to aluminum.
You must use a two-wire, three conductor
208/240 VAC, 60 Hertz electrical system. A
white (neutral) wire is not needed for this
unit. The cooktop must be installed in a
circuit that does not exceed 125 VAC nominal
to ground.
Refer to the rating plate on your cooktop for
the KW rating for your cooktop.


Produkt Specifikationer

Mærke: GE
Kategori: Ovn
Model: Profile JP939CHCC

Har du brug for hjælp?

Hvis du har brug for hjælp til GE Profile JP939CHCC stil et spørgsmål nedenfor, og andre brugere vil svare dig