GE Profile PTD70GBSTWS Manual

GE Tørretumbler Profile PTD70GBSTWS

Læs gratis den danske manual til GE Profile PTD70GBSTWS (68 sider) i kategorien Tørretumbler. Denne vejledning er vurderet som hjælpsom af 50 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 25.5 anmeldelser. Har du et spørgsmål om GE Profile PTD70GBSTWS, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/68
Installation
Dryer
Instructions
If you have any questions, call GE Appliances at 800.GE.CARES
(800.432.2737) or GEAppliances.com visit our Website at:
In Canada, call 800.561.3344 or visit www.GEAppliances.ca
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT – Save these instructions for
local electrical inspector’s use.
• IMPORTANT – Observe all governing
codes and ordinances.
• Install the clothes dryer according to the
manufacturer’s instructions and local codes.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions for
future reference.
• Clothes dryer installation must be performed by a
qualified installer.
• This dryer must be exhausted to the outdoors.
• Before the old dryer is removed from service or
discarded, remove the dryer door.
• Service information and the wiring diagram are
located in the control console.
• Do not allow children on or in the appliance. Close
supervision of children is necessary when the
appliance is used near children.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
• Install the dryer where the temperature is above
50°F for satisfactory operation of the dryer control
system.
• Remove and discard existing plastic or metal foil
duct and replace with UL-listed duct.
- Risk of Fire
• Clothes dryer installation must be performed by a
qualified installer.
• Install the clothes dryer according to these
instructions and local codes.
• DO NOT install a clothes dryer with flexible plastic
venting materials. If flexible metal (semi-rigid or
foil-type) duct is installed, it must be UL-listed and
installed in accordance with the instructions found
in “Connecting the Dryer to House Vent” later in
this manual. Flexible venting materials are known
to collapse, be easily crushed and trap lint. These
conditions will obstruct dryer airflow and increase
the risk of fire.
• DO NOT install or store this appliance in any
location where it could be exposed to water or
weather.
• To reduce the risk of severe injury or death, follow
all installation instructions.
• Save these instructions. (Installers: Be sure to
leave these instructions with the customer.)
WARNING
In the Commonwealth of Massachusetts,
the following installation instructions apply:
• Installation must be performed by a qualified or
licensed contractor, plumber, or gasfitter qualified
or licensed by the State.
• If using a ball valve, it shall be a T-handle type.
• A flexible gas connector, when used, must not
exceed 4 feet (1.2 m).
FOR GAS DRYERS ONLY
12-21 GEA
31-3000245-2
Installation Instructions
Tilt the dryer sideways and remove the foam shipping pads by pulling at the sides and
breaking them away from the dryer legs. Be sure to remove all of the foam pieces around
the legs.
Remove the bag containing the literature.
UNPACKING YOUR DRYER
DRYER
DIMENSIONS
2
43 7/8”
(112 cm)
27”
(68.8 cm)
Front View
ACCESSORIES:
Order on-line at , 24 hours a day or GEApplianceparts.com
by phone at during normal business hours.877.959.8688
Part Number Accessory
PM14X10056
Dryer Door Opening Vent Brush
WX14X10007
LintEater™ Dryer Rotary Tube Brush
PM08X10085
Flexible Metal Dryer Transition Duct
4 5/8”
(11.7 cm)
31”
(79 cm)
4 1/4”
(10.8 cm)
Side View
43 7/8”
(112 cm)
GE Appliances strongly recommends the use of factory
specified parts. These hoses are manufactured and tested
to meet GE Appliances specifications.
GE Appliances strongly recommends the use of new water
supply hoses. Hoses degrade over time and need to be
replaced every 5
years to reduce the risk of hose failures
and water damage.
Parts and Accessories
Order on-line at , 24 hours a day GEApplianceparts.com
or by phone at during normal business hours.877.959.8688
STEAM WATER HOSES (for steam dryer models only):
Part Number Accessory
WE25X20060
Complete Kit (hoses, Y-adapter, washers)
or
WE49X25794
Kit (Short hose, Y-adapter, washers)
and
WE1M847 Long Hose
OR SEPARATELY
WE1M847 Long Hose and
WE1M848 Short Hose

Produkt Specifikationer

Mærke: GE
Kategori: Tørretumbler
Model: Profile PTD70GBSTWS

Har du brug for hjælp?

Hvis du har brug for hjælp til GE Profile PTD70GBSTWS stil et spørgsmål nedenfor, og andre brugere vil svare dig


Tørretumbler GE Manualer

GE

GE GFP1528 Manual

21 August 2025
GE

GE PFD95GSPWGN Manual

21 August 2025
GE

GE GFR0728 Manual

21 August 2025
GE

GE SPLK30N01A Manual

20 August 2025
GE

GE Profile PFD87ESPVRS Manual

7 August 2025
GE

GE Profile PFD87GSSVWW Manual

7 August 2025
GE

GE Profile PFD87ESSVWW Manual

6 August 2025
GE

GE GTD38GASWWS Manual

6 August 2025
GE

GE GFMS175EHDG Manual

27 Juli 2025
GE

GE Profile PFA18REVW Manual

8 Juli 2025

Tørretumbler Manualer

Nyeste Tørretumbler Manualer

Amana

Amana NED5800TQ0 Manual

28 September 2025
Amana

Amana NED4655EW Manual

27 September 2025
Amana

Amana NGD4600YQ Manual

27 September 2025
Siemens

Siemens WT44E107DN Manual

26 September 2025
Electrolux

Electrolux XLND65835N Manual

25 September 2025
Electrolux

Electrolux EW9H39A Manual

24 September 2025
Electrolux

Electrolux XLND86955N Manual

24 September 2025
Samsung

Samsung DV90BB7440GB Manual

24 September 2025
Haier

Haier HWD90-BP14357TU1 Manual

24 September 2025
Electrolux

Electrolux EW6H29C Manual

24 September 2025