GE VTD56EASVWB Manual

GE Tørretumbler VTD56EASVWB

Læs gratis den danske manual til GE VTD56EASVWB (40 sider) i kategorien Tørretumbler. Denne vejledning er vurderet som hjælpsom af 59 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 30 anmeldelser. Har du et spørgsmål om GE VTD56EASVWB, eller vil du spørge andre brugere om produktet?

Side 1/40
- Risk of Fire
Clothes dryer installation must be performed by a
qualified installer.
Install the clothes dryer according to these instructions
and local codes.
DO NOT install a clothes dryer with flexible plastic venting
materials. If flexible metal (semi-rigid or foil-type) duct is
installed, it must be UL-listed and installed in accordance
with the instructions found in “Connecting the Dryer
to House Ventlater in this manual. Flexible venting
materials are known to collapse, be easily crushed and
trap lint. These conditions will obstruct dryer airflow and
increase the risk of fire.
DO NOT install or store this appliance in any location
where it could be exposed to water or weather.
To reduce the risk of severe injury or death, follow all
installation instructions.
Save these instructions. (Installers: Be sure to leave
these instructions with the customer.)
In the Commonwealth of Massachusetts,
the following installation instructions apply:
Installation must be performed by a qualified or
licensed contractor, plumber, or gasfitter qualified
or licensed by the State.
If using a ball valve, it shall be a T-handle type.
A flexible gas connector, when used, must not
exceed 4 feet.
FOR GAS DRYERS ONLY
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT Save these instructions for local electrical
inspector’s use.
IMPORTANT
Observe all governing codes and
ordinances.
Install the clothes dryer according to the manufacturer’s
instructions and local codes.
Note to Installer Be sure to leave these instructions
with the Consumer.
Note to Consumer Keep these instructions for future
reference.
Clothes dryer installation must be performed by a qualified
installer.
This dryer must be exhausted to the outdoors.
Before the old dryer is removed from service or discarded,
remove the dryer door.
Do not allow children on or in the appliance. Close
supervision of children is necessary when the appliance
is used near children.
Proper installation is the responsibility of the installer.
Product failure due to improper installation is not
covered under the Warranty.
Install the dryer where the temperature is above 50°F for
satisfactory operation of the dryer control system.
Remove and discard existing plastic or metal foil duct
and replace with UL-listed duct.
Service information and the wiring diagram are located
in the control console.
Questions? Call GE Appliances at 800.GE.CARES (800.432.2737) or visit our Web site at: GEAppliances.com
Dryers
Installation Instructions
WARNING
Failure to follow safety warnings exactly could
result in serious injury, death, or property damage.
- DO NOT store or use gasoline or other
flammable vapors and liquids in the vicinity of
this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS:
DO NOT try to light any appliance.
DO NOT touch any electrical switch; DO NOT
use any phone in your building.
Clear the room, building, or area of any occupants.
Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
If you cannot reach your gas supplier, call the
fire department.
- Installation and service must be performed by
a qualified installer, service agency, or the gas
supplier.
- Fire or Explosion
Hazard
WARNING
31-3000305 Rev 0 06-22 GEA
Installation Instructions
2
Tilt the dryer sideways and remove the foam
shipping pads by pulling at the sides and breaking
them away from the dryer legs. Be sure to remove
all of the foam pieces around the legs.
Remove the bag containing the literature.
UNPACKING YOUR DRYER
ROUGH-IN
DIMENSIONS
4 5/8”
(11.7 cm)
Y
X
4 1/4”
(10.8 cm)
Side View
Cubic
Foot X Y
7.4 43”
(109.2 cm)
30 1/2”
(78 cm)
7.4
(*with
Coin
Box
Kit)
45 7/8”
(116.5 cm)
30 1/2”
(78 cm)
*Coin Box Kit sold separately
X
27”
(68.8 cm)
Front View
ACCESSORIES:
Order on-line at , 24 hours a day or GEApplianceparts.com
by phone at during normal business hours.877.959.8688
Part Number Accessory
PM14X10056
Dryer door opening vent brush
WX14X10007
LintEaterDryer rotary tube brush
PM08X10085
Flexible Metal Dryer Transition Duct
TBDX10090 Coin Box Kit


Produkt Specifikationer

Mærke: GE
Kategori: Tørretumbler
Model: VTD56EASVWB

Har du brug for hjælp?

Hvis du har brug for hjælp til GE VTD56EASVWB stil et spørgsmål nedenfor, og andre brugere vil svare dig




Tørretumbler GE Manualer

Tørretumbler Manualer

Nyeste Tørretumbler Manualer

Makita

Makita DCX200 Manual

13 August 2025
BEKO

BEKO BMT93EW Manual

13 August 2025
Camry

Camry CR 2269 Manual

13 August 2025
BEKO

BEKO BMTAM93EB Manual

13 August 2025
BEKO

BEKO BMT104EW Manual

13 August 2025
BEKO

BEKO BMTMW73EB Manual

13 August 2025
BEKO

BEKO BMTR38W Manual

12 August 2025
Adler

Adler AD 2280 Manual

12 August 2025
Adler

Adler AD 2285 Manual

12 August 2025
BEKO

BEKO BMTAM83EB Manual

12 August 2025