Installation
Instructions
ZPRO7000S
Professional Style
Stainless Steel Door Panel Kit
For ZBD7000GII and ZBD7005GII
TO REMOVE THE SPRING AND SPRING SUPPORT ROD
Lay the dishwasher on its back.
Secure the panel to the door by inserting the top
and bottom shoulder washers into the matching
keyhole slots. Make sure all 4 washers engage the
keyhole slots.
Press the panel against the door and push downwards
until the washers are fully engaged into the keyhole slots.
The panel should align evenly with the top and sides.
Stand the dishwasher upright.
Open dishwasher
door and drive
the supplied
#6 x 2 Phillips
screws through
the inner door
and into the
panel. Drive
one screw at
the top and then
one screw on each
side as shown.
Door springs must be
installed in the correct position.
Position Left Side Right Side
Front N/A Blue
Rear Green Green
See Spring Removal instructions below.
Pub. No. 31-30573
Part No. 206C1559P113
03-04 JR
Printed in the United States
Stainless
Steel Panel
Dishwasher
Door
Shoulder Washers
Engage Keyhole Slots
Stainless
Steel Panel
Close the door and lift the bottom of the support rod
upward and away from the slot in the door hinge.
Pull the rod downward from the guide in the
side plate.
Remove the spring and spring sleeve from the rod.
Reassemble in reverse order.
NOTES:
• The front spring sleeves and support rods are different
from the rear ones. When comparing the two support
rods, the front rods have two extra 5/32″diameter
round lugs approximately 1/3 of the way along the rod;
the rear rods do not have these lugs. The external
spring sleeve for the front spring assembly is the
longer of the two. If the front rod and front sleeve are
installed in the rear position, the door will not open all
the way and the rod is likely to come off when the door
is closed. Make sure the correct assemblies are
reinstalled in the correct positions.
• Take care not to damage the interior light trigger
operated by the right hand front support rod.
• A spring and support rod must always be present in the
right hand front position to activate the light trigger.
Light Trigger
Viewing
Hole
Hinge
Hook
Spring
Viewing
Hole Front
Spring
Push Up
to Release
Rear
Spring
Sleeve
Bracket
