GE ZV750SY Manual

GE Emhætte ZV750SY

Læs gratis den danske manual til GE ZV750SY (12 sider) i kategorien Emhætte. Denne vejledning er vurderet som hjælpsom af 5 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 3 anmeldelser. Har du et spørgsmål om GE ZV750SY, eller vil du spørge andre brugere om produktet?

Side 1/12
GE Monogram®
Installation
Instructions
36" Vent Hood
Model
ZV750
Before you begin—Read these instructions completely and carefully.
IMPORTANT: Save these instructions for local inspector’s use.
IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES.
NOTE TO INSTALLER: Be sure to leave these instructions with the Consumer.
NOTE TO CONSUMER: Keep these instructions with your Owner’s Manual for
future reference.
This appliance must be properly grounded. See “Electrical Supply”, page 4.
WARNING
2
If you have questions concerning the
installation of this product, call the GE Answer
Center® Consumer Information Service at
800.626.2000, 24 hours a day, 7 days a week.
If you received a damaged vent hood, you
should contact your dealer.
CAUTION!
Due to the weight and size of these vent hoods
and to reduce the risk of personal injury or
damage to the product, TWO PEOPLE ARE
REQUIRED FOR PROPER INSTALLATION.
WARNING!
To reduce the risk of fire or electric shock,
do not use this range hood with any external
solid-state speed control device. Any such
alteration from original factory wiring could
result in damage to the unit and/or create an
electrical safety hazard.
To reduce the risk of fire and to properly
exhaust air, be sure to duct air outdoors. Do
not vent exhaust air into spaces within walls or
ceilings or into attics, crawl spaces or garages.
WARNING: TO REDUCE THE RISK OF FIRE,
USE ONLY METAL DUCTWORK.
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
A. Use this unit only in the manner intended
by the manufacturer. If you have any
questions, contact the manufacturer.
B. Before servicing or cleaning unit, switch
power off at service panel and lock service
panel to prevent power from being switched
on accidentally. If the service panel cannot be
locked, fasten a tag or prominent warning
label to the panel.
For general ventilating use only. Do not use
to exhaust hazardous or explosive materials
and vapors.
Installation work and electrical wiring must be
done by qualified person(s) in accordance with
all applicable codes and standards including
fire-rated construction.
Sufficient air is needed for proper combustion
and exhausting of gases through the flue
(chimney) of fuel burning equipment to
prevent back drafting. Follow the heating
equipment manufacturers guidelines and
safety standards such as those published by the
National Fire Protection Association (NFPA),
and the American Society for Heating,
Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
Contents Design Information
Model Available ...................................................................................................................................3
Optional Accessories ...........................................................................................................................3
Product Dimensions & Clearances .................................................................................................... 3
Advance Planning ............................................................................................................................... 4
Electrical Supply ..................................................................................................................................4
Installation Preparation
Duct Fittings ........................................................................................................................................ 5
Tools and Materials Required ............................................................................................................. 6
Step 1: Remove the Packaging ............................................................................................................ 6
Installation
Step 2: Check Installation Hardware ..................................................................................................7
Step 3: Ductwork, Wiring, Hood Attachment Locations .................................................................. 7
Step 4: Install Mounting Brackets.......................................................................................................8
Step 5: Install the Hood ......................................................................................................................8
Step 6: Install Duct Bracket.................................................................................................................9
Step 7: Connect Ductwork ................................................................................................................10
Step 8: Connect Electrical .................................................................................................................10
Step 9: Install Decorative Duct Cover and Utility Bars.................................................................... 10
Step 10: Install Filters ........................................................................................................................ 11
Step 11: Finalize Installation .............................................................................................................11


Produkt Specifikationer

Mærke: GE
Kategori: Emhætte
Model: ZV750SY

Har du brug for hjælp?

Hvis du har brug for hjælp til GE ZV750SY stil et spørgsmål nedenfor, og andre brugere vil svare dig




Emhætte GE Manualer

GE

GE UVC9480SLSS Manual

30 December 2025
GE

GE JV665HBB Profile Manual

15 December 2024
GE

GE UVC9420SLSS Manual

7 December 2024
GE

GE JV337XAD Manual

19 September 2024
GE

GE UVD6301DPBB Manual

1 September 2024
GE

GE UVD6361DPBB Manual

1 September 2024

Emhætte Manualer

Nyeste Emhætte Manualer