GE ZV850SB Manual

GE Emhætte ZV850SB

Læs gratis den danske manual til GE ZV850SB (16 sider) i kategorien Emhætte. Denne vejledning er vurderet som hjælpsom af 41 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 21 anmeldelser. Har du et spørgsmål om GE ZV850SB, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/16

GE Monogram®

Installation

Instructions

36" Island

Vent Hood

Model

ZV850

Before you begin – Read these instructions completely and carefully.

IMPORTANT – Save these instructions for local inspector’s use.

IMPORTANT – OBSERVE ALL GOVERNING CODES AND ORDINANCES.

Note to Installer – Be sure to leave these instructions with the Consumer.

Note to Consumer – Keep these instructions with your Owner’s Manual for future reference.

WARNING: This appliance must be properly grounded. See “Electrical Supply,” page 5.

If you have a question concerning the

installation of this product, call the GE Answer

Center® Consumer Information Service at

800.626.2000, 24 hours a day, 7 days a week.

If you received a damaged vent hood, you

should immediately contact your dealer or

builder.

For Monogram local service in your area,

1.800.444.1845.

For Monogram service in Canada, call

1.888.880.3030.

For Monogram Parts and Accessories, call

1.800.626.2002.

CAUTION!

Due to the weight and size of this vent hood

and to reduce the risk of personal injury or

damage to the product, TWO PEOPLE ARE

REQUIRED FOR PROPER INSTALLATION.

Proper installation is the responsibility of

the installer. Product failure due to improper

installation is not covered under the GE

Appliance Warranty. See the Owner’s

Manual for warranty information.

WARNING:

To reduce the risk of fire or electrical

shock, do not use this hood with any external

solid-state speed control device. Any such

alteration from original factory wiring could

result in damage to the unit and/or create

an electrical safety hazard.

To reduce the risk of fire and to properly

exhaust air, be sure to duct air outdoors. Do

not vent exhaust air into spaces within walls or

ceilings or into attics, crawl spaces or garages.

WARNING: TO REDUCE THE RISK OF FIRE,

USE ONLY METAL DUCTWORK.

TO REDUCE THE RISK OF FIRE,

ELECTRICAL SHOCK OR INJURY TO

PERSONS, OBSERVE THE FOLLOWING:

A. Use this unit only in the manner intended

by the manufacturer. If you have any

questions, contact the manufacturer.

B. Before servicing or cleaning unit, switch

power off at the service panel and lock service

panel to prevent power from being switched

on accidentally. If the service panel cannot be

locked, fasten a tag or prominent warning

label to the panel.

For general ventilating use only. Do not use

to exhaust hazardous or explosive materials

or vapors.

Structural framing, installation work and

electrical wiring must be done by qualified

person(s), in accordance with all applicable

codes and standards including fire-rated

construction.

Sufficient air is needed for proper combustion

and exhausting of gases through the flue

(chimney) of fuel burning equipment to

prevent back drafting. Follow the heating

equipment manufacturer’s guidelines and

safety standards such as those published by

the National Fire Protection Association

(NFPA), and the American Society for

Heating, Refrigeration and Air Conditioning

Engineers (ASHRAE), and the local code

authorities.

Local codes vary. Installation electrical

connections and grounding must comply

with applicable codes. In the absence of

local codes, the vent should be installed in

accordance with National Electrical Code

ANSI/NFPA 70-1990 or latest edition.

Contents Model Available ............................................ 3

Required Accessory ...................................... 3

Recirculating Operation .............................. 3

Product Dimensions ..................................... 3

Using Duct Cover Accessories ..................... 4

Installation Preparation

Tools and Materials Required ..................... 5

Power Supply ................................................ 5

Duct Fittings ................................................. 6

Step 1, Advance Planning ........................ 7, 8

Installation

Step 2, Remove the Packaging .................... 9

Step 3, Check Installation Hardware .......... 9

Step 4, Mount Template ............................ 10

Step 5, Install Support Frame .................... 10

Step 6, Secure Wiring ................................ 11

Step 7, Size and Install Ductwork.............. 11

Step 8, Install Decorative Duct Covers ..... 12

Step 9, Install Hood ................................... 13

Step 10, Connect Electrical ....................... 13

Step 11, Slide Duct Cover Down,

Install Side Utility Bars ................ 14

Step 12, Install Filters ................................. 15

Step 13, Finalize Installation ..................... 15

Produkt Specifikationer

Mærke:	GE
Kategori:	Emhætte
Model:	ZV850SB

Har du brug for hjælp?

Hvis du har brug for hjælp til GE ZV850SB stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Emhætte GE Manualer

GE JV565HBB Profile Manual

31 Maj 2025

GE JV665HWW Profile Manual

31 Maj 2025

GE JV666HSS Profile Manual

31 Maj 2025

GE JV635HWW Profile Manual

29 Maj 2025

GE UVC9480SLSS Manual

30 December 2025

GE JV665HBB Profile Manual

15 December 2024

GE UVC9420SLSS Manual

7 December 2024

GE JV337XAD Manual

19 September 2024

GE UVD6301DPBB Manual

1 September 2024

GE UVD6361DPBB Manual

1 September 2024

Emhætte Manualer

Nyeste Emhætte Manualer

Comfee CHW 7.6M77A3 Manual

17 Juni 2025

17 Juni 2025

17 Juni 2025

17 Juni 2025

17 Juni 2025

ElectriQ eiQTMVISOR Manual

17 Juni 2025

Comfee CHT 3.6B Manual

17 Juni 2025

ElectriQ eiQ90CANGBL Manual

17 Juni 2025

Comfee CHK 3.6.6J64A1B Manual

17 Juni 2025

ElectriQ eiQ52CANGBL Manual

17 Juni 2025