Geba Tronic DC 3 ECO Manual


Læs gratis den danske manual til Geba Tronic DC 3 ECO (18 sider) i kategorien Garageportåbner. Denne vejledning er vurderet som hjælpsom af 20 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 10.5 anmeldelser. Har du et spørgsmål om Geba Tronic DC 3 ECO, eller vil du spørge andre brugere om produktet?

Side 1/18
Instructions for Assembly and Use
Industrial Door Control DC 3
ECO - Standard - de Luxe
industrial controls
®
industrial controls
®
Dealer:
X 0364.1 05/03
GB
DIP-Switch on the Comfort module
With the DIP-Switches several operating modes can be programmed.
The programming is done by switching the corresponding switch in „ON“ position.
When reaching the desired position, which is signaled by the blinking of the red
LED, the jumper must be turned back in „OFF“ position. The signaling of the desi-
red position will be repeated 4 x. The position shown at last is now programmed.
123 4 56
ON
OFF
7
Switch 1: Display of door position 1x flashing
Traffic light control red/green 2x flashing
Switch 2: Function/ kind of Diode/resistor with free cruise 1x flashing
safety edge Diode/resistor with reverse 2x flashing
Attention ! Opto - elektronic with free cruise 3x flashing
Jumper position on mainboard! Opto - elektronic with reverse 4x flashing
DW-Test with free cruise 5x flashing
DW-Test with reverse 6x flashing
Switch 3: permanent light impuls 3 seconds 1x flashing
255 seconds 2x flashing
Switch 4: Prewarning for door moves immediately 1x flashing
France
Attention ! door moves delayed 2x flashing
Jumperposition on mainboard! (France)
Switch 5: Automatic closing function Photo beam starts closing time 1x flashing
only Standard & de Luxe Photo beam sets time to 5 sec. 2x flashing
Switch 6: automatic closing time 15 seconds 1x flashing
only Standard & de Luxe 30 seconds 2x flashing
1 minute 3x flashing
2,50 minutes 4x flashing
4,25 minutes 5x flashing
Switch 7: Test photo beam Test outside 1x flashing
only Comfort Test inside/outside 2x flashing
module S 2 Test off 3x flashing
The bold type values are pre-set during manufacturing
In p1-he setting for France the door movement is prewarned by a permanent light impuls for
3 seconds, the traffic light RED flashes 3 seconds. The traffic light control activates during the
door movement to a permanenr RED signal.
only S2
Dear customer,
The DC 3 which you have purchased is one of our highest quality technical pro-
ducts. We have taken the greatest care in its manufacture to ensure that this
microprocessor controlled encoder reaches you in faultless condition. However in
the unusual event of suspected equipment failure please return the appliance
together with the enclosed warranty document to your dealer or direct to our
factory.
The extent of warranty exclusively refers to the free repair of malfunctions of the
appliance, which demonstrably are caused by faults in production or defective
material, inclusive of spare parts required for this purpose.
Therefore please first read the instructions of use carefully before you start
programming !!!
industrial controls
®
industrial controls
®
geba GmbH is released of its obligations regarding guarantee and product liability if - without prior
permission - the unit has been modified, or if the installation is improper or not in accordance with
our instruction manual.
The installer has to take care that the EMC-regulations are respected.
2 35
Processor board
TR 1
S1
L1 L2 L3 N PE U V W N PE 1 2 3 4 5 6 7 8 9
F1
F
D
R1
D4
27 25 23 21 19 17 15 13 11
+
26 24 22 20 18 16 14 12 10
-
56-57: push button UP-STOP-DOWN-STOP (N.O.)
54-55: push button autom. closing function (N.O.)
53: +24 Volt photo-beam
52: photo-beam
51: photo-beam
50: +15 Volt safety edge
49: Signal safety edge
48: ground safety edge
46-47: pre-limit switch (N.C.)
44-45: external push button STOP (N.C.)
38-39: push button inside Down (N.O.)
36-37: push button inside UP (N.O.)
42-43: internal-push button STOP (N.C.)
40-41: push button outside Down (N.O.)
34-35: push button outside UP (N.O.)
32-33: limit-switch DOWN (N.C.)
30-31: limit-switch UP (N.C.)
28-29: limit switch half-open (N.C.)
10: ground safety photobeam transmitter
11: +24 safety photobeam transmitter
12: ground safety photobeam transmitter
13: +24 safety photobeam transmitter
14: ground safety photobeam receiver
15: +24 safety photobeam receiver
16-17: safety photo beam outside (N.C.)
18-19: safety photo beaminside (N.C.)
20-21: security limit switch UP (N.C.)
22-23: security limit switch DOWN (N.C.)
24-25: 'Wicket Gate' - motor thermoswitch (N.C.)
26-27: safety devices (e.g.wire rope failure) (N.C.)
R2
D5
R3
D6
+ +
- -
52
50
48
46
44
42
40
-
+
-
53
51
49
47
45
43
41
+
38
36
34
32
30
28
39
37
35
33
31
29
57
55
56
54
}(N.C.)
Power supply
photo beam
ST10
ST9
ST8
ST7
ST6
ST5
ST4
ST3
ST2
ST1
ST13
ST11
ST12
ST16
ST15
ST14
Connection keypad (flat cable)
Setting
Europe-France
DOWN
UP
J1 UK
}
}
}outside
inside
inside &
outside
Set Jumper if Comfort module
is connected
Danger Area
visible
}
Connection diagramme mainboard DC 3 de Luxe
d
e
L
u
x
e
Warranty-document
On the below described product we grant a warranty of
2 years
Type: DC 3 ECO - Standard - de Luxe
Production date: ____________________________________________________
Sales date: ____________________________________________________
Dealers adress:


Produkt Specifikationer

Mærke: Geba Tronic
Kategori: Garageportåbner
Model: DC 3 ECO

Har du brug for hjælp?

Hvis du har brug for hjælp til Geba Tronic DC 3 ECO stil et spørgsmål nedenfor, og andre brugere vil svare dig