Getac VR-X10 Manual

Getac Ikke kategoriseret VR-X10

Læs gratis den danske manual til Getac VR-X10 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 49 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 25 anmeldelser. Har du et spørgsmål om Getac VR-X10, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

VR-X10

DVR System

QUICK START GUIDE

VERETOS MVS

Unpacking

VR-X10 DVR System

Terminal connector

for DC IN

Terminal connector

for GPIO x 2

D-sub to BNC cable Electrical wire x 3

Fuse tap (ignition) -5A 15A inline fuse

GPS antenna Wi-Fi/BT antenna x 2

Mounting kit (racket

and screw x 4)

Key x 2

Identifying Components

Front Panel

No. Descriptions



HDD LED

- Green light: HDD activity

Security door LED

- Green light: Door locked

- Red light: Door unlocked

Recording LED

- Blue light: Video recording in progress



Power button: Press to power on VR-X10.

Power LED

- Red light (for 10 seconds): DC power-in

- Green light: Software ready



Door lock: Use the key/software to unlock

the door.



Security door: Protects the removable

storage inside (if existing). The door is

automatically locked when closed.



CFast connector: Allows the use of a CFast

card for removable storage.



USB 3.0 connector: Allows the use of an

USB disk for removable storage. (See

“Recommended USB Disks” on the reverse

side for more information.)

Rear Panel

No. Descriptions Remarks



802.3af PoE ports (1 to 4): Connects up to four IP

cameras. Each port has a status LED.



RJ45-type audio in connectors: Connects up to

two wireless microphones.

Wireless microphone model: WM-T2400M



Video capture connector: Provides 8-channel

composite video inputs and 4-channel audio

inputs.



DC-in connector: Connects to vehicle ignition and

battery with the 3 electrical wires provided.

See “DC-in Connector Pin Assignments” on

the reverse side for wiring information.



GPIO ports: Provides additional control lines.

There are 20 GPIO pins in two groups of 10 pins.

See “GPIO Connector Pin Assignments” on

the reverse side for wiring information.



RJ45 connectors (LAN 1 and LAN 2): Provides

10/100/1000 base-T Ethernet connection.

LAN 2 supports PXE.



GPS antenna connector



Wi-Fi/BT antenna connectors (Auxiliary and

Main)



Combo audio connector: Connects a headset

microphone.



USB 3.0 connector

USB 2.0 connectors (1 to 3)

Control unit connector: Connects to the CU-D50

control unit.

CU-D50 is an optional item.

Mini-HDMI connector: Connects to a monitor

supporting HDMI interface.

Mini DisplayPort: Connects to a monitor

supporting DisplayPort interface.

5 6 1 8 8 6 8 8 0 0 0 1 R 0 0

References

Pin Assignments

DC-in Connector Pin Assignments

GPIO Connector Pin Assignments

Notes on GPIO:

Recommended USB Disks

The below USB disk models have been tested

as fully compatible with VR-X10.



SanDisk Ultra® USB 3.0 Flash Drive



Kingston DataTraveler G4

NOTE: See the figure at the right for the

USB disk size supported by VR-X10. Also, you

are advised to attach a lanyard to the USB

disk for easy removal of the disk.

More Information

See Installation Diagram for more information.

Cautions and Notices

This equipment is designed for use and

installation in a vehicle. It can be mounted

in a vehicle’s center console or trunk.

Safety Cautions



This symbol (a lightning flash in a

triangle) is intended to alert the

user to the presence of uninsulated

voltage within the product’s enclosure

that can be high enough to constitute a

risk of electric shock to human bodies.



This symbol (an exclamation mark in

a triangle) is intended to alert the

user to the presence of important operating

and maintenance information in the

document(s) accompanying the product.



To reduce the risk of electric shock, do

not remove the cabinet cover. There are

no user-serviceable parts inside. Contact

qualified service personnel if servicing is

required.



Do not expose the equipment to rain or

moisture.



Keep the equipment away from risks of

dripping or splashing liquids.



Allow adequate ventilation around the

equipment. Do not cover or block any

ventilation openings.



Use the recommended accessories only.

Battery Cautions

There is danger of explosion or fire if the

battery is handled improperly.



Replace only with the same or specified

type.



Do not disassemble or dispose of in fire.



Do not store in temperatures above 60 C.



Use specified charger for rechargeable

batteries.



Do not recharge the battery if it is not a

rechargeable type.



Do not leave the battery in a vehicle

exposed to direct sunlight for a long period

of time with doors and windows closed.



For memory backup battery: There is danger

of explosion if the battery is incorrectly

replaced. Replace only with the same or

equivalent type. Consult qualified service

personnel when replacement is required.

FCC Regulations

This device complies with Part 15 of the FCC

Rules. Operation is subject to the following

two conditions: (1) This device may not cause

harmful interference, and (2) this device must

accept any interference received, including

interference that may cause undesired

operation.

To assure continued compliance, follow the

attached installation instructions and do

not make any unauthorized modifications.

FCC Note:

This equipment has been tested and found

to comply with the limits for a class A digital

device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reason-

able protection against harmful interference

when the equipment is operated in a

commercial environment. This equipment

generates, uses, and can radiate radio

frequency energy, and if not installed and

used in accordance with the instruction

manual, may cause harmful interference to

radio communications. Operation of this

equipment in a residential area is likely to

cause harmful interference in which case

the user will be required to correct the

interference at his own expense.

Warning:

To assure continued FCC emission limit

compliance, the user must only use shielded

interface cables when connecting to external

units. Also, any unauthorized changes or

modifications to this equipment could void

the user's authority to operate this device.

50mm ~ 60mm

22mm (Max.)

11mm (Max.)

A1 A10

B1 B10

Example of a lanyard

A1 A2 A3 A4 A5 A6 A7 A8 A9 A10

GND +12V RS232 RX RS232 TX I/O Out 4 I/O Out 3 I/O In 8 I/O In 7 I/O In 6 I/O In 5

COM2

B1 B2 B3 B4 B5 B6 B7 B8 B9 B10

GND +12V RS232 RX RS232 TX I/O Out 2 I/O Out 1 I/O In 4 I/O In 3 I/O In 2 I/O In 1

COM1

1 2 3

Ignition Vehicle Battery+ Vehicle Battery-

Pins Low / High Active Input Voltage When using a digital/O device, you must ground the

device by connecting it to the metal part of the VR-X10

cabinet. This common return path is needed as the

reference point for high/low voltage measurement.

I/O In 1, 2, 5, 6 Low Active 0 V

I/O In 3, 4, 7, 8 High Active 6 V~24 V

Pins Battery Mode Output Voltage / Current

IO Out 1, 2, 3, 4 Vehicle Battery Mode Vehicle Battery Voltage / 0.75 A

VR-X10 Internal Battery Mode 6.3 V~8.4 V / 0.75 A

1 2 3

Produkt Specifikationer

Mærke:	Getac
Kategori:	Ikke kategoriseret
Model:	VR-X10

Har du brug for hjælp?

Hvis du har brug for hjælp til Getac VR-X10 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Getac Manualer

Getac Essentials Manual

5 Januar 2025

Getac VD-01 Manual

5 September 2024

Getac Veretos BC-01 Manual

1 August 2024

1 August 2024

1 August 2024

1 August 2024

1 August 2024

29 Juli 2024

29 Juli 2024

29 Juli 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Hozelock 5102 Manual

2 August 2025

ART 310 Manual

2 August 2025

Gorenje KAS53ZDCINVFT Manual

2 August 2025

Gorenje KAS35ZDCINVFT Manual

2 August 2025

Navman MY450LMT Manual

2 August 2025

Navman MiVue 745 Manual

1 August 2025

Hitachi WR22SE Manual

1 August 2025

Synology M2D20 Manual

1 August 2025

Fluke FibertLert-125 Manual

1 August 2025

Buffalo GC882 Manual

1 August 2025