With each wash cycle.
Compartment
For pro gramm es with pre-wash only.
(Follow the user ins tructions !)
Electric indicator on control panel (if provided).
Check the rinse aid level
(On models w ith water s oftener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to f ill the salt into
the softener by the number of cycles the dishwasher has run.
Check the regeneration
salt le vel
Load the baskets
Select a p rogramme
Close the door ,t urn on the water tap . The machine will start working after about 10 seconds.Running the dishwasher
Swi tch off the applia nce
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few minutes (about 15 min utes) before unloading the di shwa sher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
The y will a lso dry better.Unload the appli ance, starting fro m the lower b asket.
Changing the programme
Add forgotten dishes in the
dishwasher.
Scr ap e off any large amount of leftover food. Soften remnants of burnt food in pa ns,
then l oa d the baskets. Refer to the dishwashe r loading instruct ions.
Choose the desired wash cycle by pressing the corresponding programme button
( See the section entitled Operationg instruction )“ ”
When the working cy cle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the ON/OFF button.
If the appliance is switched
off during a wash cycle.
Op en t he do or carefull y.
Hot st eam may escape
when the door is opened!
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
according to the original Power-on state ).
Switch on the applia nce Open the door,press the On/Off button to switch on the appliance.
1.O pen the doo r a little to sto p the dish washer.
2.Af ter the spray arms stop working, you can open the door com p le tely.
3.Add the forgotten dishes.
4.Close the door , the dishwasher will start running again after 10 seconds.
For detailed operating method read the corresponding content on the instructio n manual.
1. A running cycle can only be modified if it has been running for a short time. Otherwise the detergent
m ay ha ve already been released and the water alr eady drained. If this is the case, the detergent
dispenser must be refilled.
2. Open the door firstly, press the pro gramme button you will change to more than 3 seconds,the running
programme will be changed
3. Close the door . The machine will restart after about 10 seconds.
A B
