Ground Zero GZ BASS KIT 12.300X-II Manual

Ground Zero Subwoofer GZ BASS KIT 12.300X-II

Læs gratis den danske manual til Ground Zero GZ BASS KIT 12.300X-II (4 sider) i kategorien Subwoofer. Denne vejledning er vurderet som hjælpsom af 7 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 4 anmeldelser. Har du et spørgsmål om Ground Zero GZ BASS KIT 12.300X-II, eller vil du spørge andre brugere om produktet?

Side 1/4
GZ BASS KIT 12.300X-II
Owner´s manual
(AWV4.1)
Features
Efficient Aero ventilation port
30 cm / 12” subwoofer
IMPP cone with 3D-honeycomb structure
GZ design push terminal
Mono class A/B amplifier
Stereo RCA input
Stereo high- - level input with auto on function
Adjustable input sensitivity
Adjustable low pass filter
Adjustable bass boost control
Wired remote control for LPF mode
(GZTA Bassremote available separately)
Owner´s manual enclosed
General installation note
As a precaution, it is recommended to disconnect the vehicles battery before mounting the amplifier. (Note: For new
vehicles, disconnecting the battery might cause various errors in your vehicle´s electric system that can be cleared only
by authorized personnel of your vehicle´s manufacturer!)
The power supply wire (+12 V) has to be protected within max. 20 cm / 8” by a main fuse holder with a fuse value
matching the recommendation for your amplifier or internal fuse value
(Note: If there is more than one amplifier connected using this power wire, the main fuse value must be equal to the
sum of the recommended fuses of all connected devices. However, make sure the diameter of your power wire will be
sufficient for the required current!)
If necessary, replace a defective fuse by a fuse with identical quality and value
Never drill a hole to the vehicle´s gas tank or brake lines, to wirings or any other important vehicle parts!
Never pass wires over sharp edges or vehicle parts to avoid any kind of damage
Keep the wiring away from the antenna and electronic devices contributing to radio reception
Lay the power supply wiring always separated from speaker wiring to avoid disturbance
The amplifier contains a temperature protection circuit that turns the device off in case of overheating. After a certain
cooling time, it will turn on automatically. To avoid heat build up, sufficient air supply for cooling must be provided. -
Never cover the surface of the amplifier´s heatsink entirely
The amplifier should not be mounted onto a vibrating part or surface such as a subwoofer enclosure. This might lead
to malfunction due to loosened electrical parts inside the amplifier.
This amplifier has got a high- -level input option, however if a pre amplified output (RCA) is available (from head unit), it
is strongly recommended to make use of it.
GZ BASS KIT 12.300X- II
Connections and controls
1
1
1
1 1
Speaker ter
Speaker ter
Speaker ter
Speaker terSpeaker terminal
minal
minal
minalminal
To connect the speaker wire (of the subwoofer)
2
2
2
2 2
Power
Power
Power
PowerPower termin
termin
termin
termin terminal
al
al
alal
GND Ground connection
REM Remote connection (not necessary when high-level input is used)
BATT +12 Volt connection
3
3
3
3 3
Fuse
Fuse
Fuse
FuseFuse
Replace a defective fuse by a fuse with identical quality and value (30A)
4
4
4
4 4
High
High
High
HighHigh input
input
input
inputinput
-l
-l
-l
-l-level
evel
evel
evel evel
T - t ) o connect your head unit (if not equipped with a low level RCA ou put
Connect this input to the speaker outputs of your head unit. The amplifier automatically
turns on (Auto On). The remote needs not to be connected
IMPORTANT!
IMPORTANT!
IMPORTANT!
IMPORTANT!IMPORTANT!
Do no
Do no
Do no
Do noDo not use
t use
t use
t uset use the
the
the
the the
h
h
h
hh -
-
-
--
igh
igh
igh
ighigh level input a
level input a
level input a
level input alevel input and the
nd the
nd the
nd the nd the RCA
RCA
RCA
RCARCA
input
input
input
input input simult
simult
simult
simultsimultaneou
aneou
aneou
aneouaneously.
sly.
sly.
sly.sly.
T
T
T
TT
his
his
his
his his may lead to
may lead to
may lead to
may lead tomay lead to
serious
serious
serious
serious serious damage
damage
damage
damage damage igh
igh
igh
ighigh
of
of
of
ofof
the ampl
the ampl
the ampl
the amplthe amplifie
ifie
ifie
ifieifier.
r.
r.
r. r. RCA o
RCA o
RCA o
RCA oRCA or
r
r
rr
Use either the
Use either the
Use either the
Use either the Use either the
the
the
the
thethe
h
h
h
hh -l
-l
-l
-l-level
evel
evel
evelevel input
input
input
input input, onl
, onl
, onl
, onl, only
y
y
yy
5
5
5
5 5
RCA
RCA
RCA
RCARCA
input
input
input
inputinput
T - o connect the low level input signal (RCA)
IMPORTANT!
IMPORTANT!
IMPORTANT!
IMPORTANT!IMPORTANT!
Do no
Do no
Do no
Do noDo not use
t use
t use
t uset use the
the
the
the the
h
h
h
hh -
-
-
--
igh
igh
igh
ighigh level input a
level input a
level input a
level input alevel input and the
nd the
nd the
nd the nd the RCA
RCA
RCA
RCARCA
input
input
input
input input simult
simult
simult
simultsimultaneou
aneou
aneou
aneouaneously.
sly.
sly.
sly.sly.
T
T
T
TT
his
his
his
his his may lead to
may lead to
may lead to
may lead tomay lead to
serious
serious
serious
serious serious damage
damage
damage
damage damage igh
igh
igh
ighigh
of
of
of
ofof
the ampl
the ampl
the ampl
the amplthe amplifie
ifie
ifie
ifieifier.
r.
r.
r. r. RCA o
RCA o
RCA o
RCA oRCA or
r
r
rr
Use either the
Use either the
Use either the
Use either the Use either the
the
the
the
thethe
h
h
h
hh -l
-l
-l
-l-level
evel
evel
evelevel input
input
input
input input, onl
, onl
, onl
, onl, only
y
y
yy
6
6
6
6 6
RCA
RCA
RCA
RCARCA
output
output
output
outputoutput
To connect an additional amplifier (RCA)
7
7
7
7 7
Gain
Gain
Gain
GainGain (
(
(
( ( )
)
)
) )
level
level
level
levellevel control
control
control
controlcontrol
To adjust the input sensitivity
8
8
8
8 8
Mode s
Mode s
Mode s
Mode sMode switc
witc
witc
witcwitch
h
h
hh
To select the crossover mode
LPF Low frequencies (below selected crossover point) will be reproduced
FULL Full range reproduction
9
9
9
9 9
Low
Low
Low
Low Low p
p
p
pp
ass
ass
ass
ass ass con
con
con
concontrol
trol
trol
troltrol
To set the crossover frequency. Set the filter switch to position. Adjust the the LOW
variable LPF frequency to the desired frequency using the controller
10
10
10
1010
Bass Boost control
Bass Boost control
Bass Boost control
Bass Boost controlBass Boost control
To adjust dBthe low bass increase (Bass Boost) at 45 Hz ( – 6 0 )
11
11
11
1111
St
St
St
StSt
atus
atus
atus
atusatus
indication
indication
indication
indicationindication
GREEN Amplifier is in operation mode
RED Amplifier is in protection mode
12
12
12
1212
Remote
Remote
Remote
RemoteRemote con
con
con
con control
trol
trol
troltrol
connector
connector
connector
connectorconnector
To connect the separately available remote control GZTA Bassremote


Produkt Specifikationer

Mærke: Ground Zero
Kategori: Subwoofer
Model: GZ BASS KIT 12.300X-II

Har du brug for hjælp?

Hvis du har brug for hjælp til Ground Zero GZ BASS KIT 12.300X-II stil et spørgsmål nedenfor, og andre brugere vil svare dig