GVI Security videoPLUS AID-112N Manual

GVI Security Overvågningskamera videoPLUS AID-112N

Læs gratis den danske manual til GVI Security videoPLUS AID-112N (6 sider) i kategorien Overvågningskamera. Denne vejledning er vurderet som hjælpsom af 32 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 16.5 anmeldelser. Har du et spørgsmål om GVI Security videoPLUS AID-112N, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/6

AID–112N / AOD-112N

1/3” CCD Dome Camera

(AID-112N: indoor / AOD-112N: outdoor)

QUICK START GUIDE

GVI Security

Safety Warning

Retain and follow all safety and operating instructions. Observe all warnings on products. Unplug the product

from the electrical outlet and discontinue use under the following conditions: The power cord or plug is

damaged; the product is exposed to liquid; the product is dropped or an object falls on the product; the

product is noticeably overheated. Read this manual carefully before installing the unit. Please read this manual

first for correct installation and operation.

Never install the camera on a ceiling that cannot hold its weight. The product may fall down and cause

damages. Never install the camera near electric or magnetic fields. Install the camera away from TVs, radio

transmitters, magnets, electric motors, transformers, and audio speakers since the magnetic fields distort the

video image. Never install or use the camera in areas exposed to water, oil, or gas. The water, oil, or gas may

result in operation failure, electric shock, or fire. Do not use this unit near water (e.g., near a bath tub, wash

bowl, kitchen sink, laundry tub, wet basement, swimming pool, unprotected outdoor installation, or any area

which is classified as a wet location). Never face the camera toward the sun. Direct sunlight may cause fatal

damage to sensors and internal circuits. Touching a wet power cord with hands or touching the power cord

with wet hands may result in electric shock.

Do not service any product yourself. Opening or removing covers that are marked with warning symbols or

labels may expose you to electric shock. Service needed on components inside these compartments should be

done by an authorized service provider. Replace any batteries with the equivalent battery type. Failure to do

so may cause damage or bodily injury. There is a danger of explosion if batteries are incorrectly replaced.

Dispose of all used batteries according to the manufacturer’s instructions.

Install the system in an environment where the ambient temperature does not exceed the maximum rated

ambient temperature of the rack mount system. Ensure there are no obstructions to the case ventilation.

Blocking any of the built-in airflow may cause overheating. The product must be connected to a circuit with an

adequate rating to prevent an over-current condition on the circuit. Slots in the product are provided for

ventilation and should never be blocked or covered since these protect it from overheating. The openings

should never be blocked by placing the product on a flexible surface. The product should not be placed in a

built-in apparatus unless the apparatus has been designed to accommodate the product, proper ventilation is

provided for the product, and the product instructions have been followed.

Operate the product only from the type of power source indicated on the product’s electrical ratings label. If

you have questions about the type of power source to use, contact your authorized service provider. The

power outlet for the power cord should be easily accessible and located as close to the equipment operator

as possible. When you need to disconnect power to the equipment, unplug the power cord from the electrical

outlet. When disconnecting a power cord/cable from an outlet, pull on the connector. Never pull on the cable

itself to disconnect from the power source. Handle all equipment with care when disconnecting from the

product or the power source. Equipment may be hot. The power cord must be properly rated for the

product and for the voltage/current marked on the product’s electrical ratings label. The voltage/current rating

of the cord should be greater than the voltage/current rating marked on the product. Do not overload an

electrical outlet, power strip, or convenience receptacle. Use care when moving products to other countries

with different voltage standards. Substitution for the power supply may result in destruction of the product or

personal injury.

Unplug the product from the wall outlet prior to cleaning. Do not use liquid cleaners or aerosol cleaners. Use

a damp cloth for cleaning. Never insert a foreign object into the product’s openings or ventilation slots. The

product should be placed away from radiators, heat registers, stoves, or other pieces of equipment (including

amplifiers) that produce heat. Allow sufficient air circulation around the product and power supply during use

to ensure adequate cooling of the device. Prevent direct exposure to radiant heat sources. Contact the

provider if replacement parts are required. Use only the parts, upgrades, and options sent from the provider.

GVI Security makes no warranty of any kind with regard to this material, including but not limited to the documentation, function, and performance

of these programs and their suitability for any purpose. GVI Security shall not be liable for any errors contained herein for incidental or

consequential damages in connection with the use of this material. This document contains proprietary information protected by copyright. No part

of this document may be reproduced without prior consent of GVI Security, 2801 Trade Center Dr., Suite 120, Carrollton, TX 75007.

Produkt Specifikationer

Mærke:	GVI Security
Kategori:	Overvågningskamera
Model:	videoPLUS AID-112N

Har du brug for hjælp?

Hvis du har brug for hjælp til GVI Security videoPLUS AID-112N stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Overvågningskamera GVI Security Manualer

GVI Security autoIP NID-2151 Manual

2 September 2024

GVI Security videoPLUS AID-112N Manual

2 September 2024

GVI Security autoIP NRD-213M Manual

2 September 2024

GVI Security videoPLUS AOU-112N Manual

2 September 2024

GVI Security GV-VF539XDR Manual

2 September 2024

GVI Security videoPLUS AID-211N Manual

2 September 2024

GVI Security videoPLUS AHU-2161S Manual

2 September 2024

GVI Security autoIP NID-213M Manual

2 September 2024

GVI Security videoPLUS AID-3161S Manual

2 September 2024

GVI Security autoIP GV-NC-201VA Manual

2 September 2024

Overvågningskamera Manualer

Nyeste Overvågningskamera Manualer

Speco Technologies O4LB2 Manual

9 Oktober 2025

Vaddio ZoomSHOT 20 SE AVBMP Manual

9 Oktober 2025

Speco Technologies O8VB3 Manual

9 Oktober 2025

Caliber HWC202PT Manual

9 Oktober 2025

Speco Technologies N8NSP6TB Manual

8 Oktober 2025

Speco Technologies O5D1G Manual

8 Oktober 2025

Speco Technologies O4TDD1M Manual

8 Oktober 2025

Speco Technologies ZIPT471 Manual

8 Oktober 2025

Caliber HWC 404 Manual

8 Oktober 2025

Speco Technologies O4BLP2M Manual

8 Oktober 2025