Hager 75492002 Manual

Hager Ikke kategoriseret 75492002

Læs gratis den danske manual til Hager 75492002 (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 15 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 8 anmeldelser. Har du et spørgsmål om Hager 75492002, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

The brightness and temperature sensor is suitable for brightness and

temperature measurement for the KNX building management

system.

Push the bus cable through the

nippel grommet into the terminal

compartment.

Connect the bus terminal to the

inserted cable. Pay attention to

polarity.

Press the bus terminal

completely onto the contact

pins.

Electrical equipment may only be installed and assembled by a qualified

electrician. The national regulations and safety directions must be observed

Please observe the rules and instructions in the ZVEI/ZVEH manual for

building management systems to ensure that the bus cables are laid

correctly and commissioning of the devices is carried out correctly.KNX

Interventions in and modifications to the device will invalidate the warranty.

The ETS assigns the physical address, the group addresses; the setting

of parameters is also done with the ETS.

Loading of the physical address:

Press button 1.

LED 2 lights up.

The physical address can be assigned

by the ETS.

Measurement range for brightness measurement

1 to 100 000 lux (tolerance ± 20 % resp. ± 1 Lux)

Measurement range for temperature measurement

–25 °C to + 55 °C (tolerance 5 % resp. ± 1 Grad)

(The larger tolerance applies in each case.)

Please note when selecting the installation location

•

that the brightness and temperature sensor is exposed to no or to

minimal dirt, as a dirty sensor has an adverse effect on the

brightness measurement.

•

that direct sunlight can interfere with the temperature

measurement.

Install the brightness and temperature sensor only in a

vertical position!

Consequence on non-observance

Moisture and/or dirt can get into the housing! This will result in

device malfunctions and will short circuit the bus- cable.

Installing the cover

Place the cover carefully over the installed device.

Screw on the cover

Maintaining the cover

1. Clean the cover from time to time, so that the measured values during

brightness measurement are not corrupted by

dirt deposits.

Use a moist

cloth for this.

Brightness and temperature sensor 7549 20 01

Operating voltage bus voltage

Bus coupling unit integrated

Temperature measuring range – 25 °C to +55 °C

Tolerance ± 5 % resp. ± 1 degree

Brightness measuring range 1 to 100 000 Lux

Tolerance Lux± 20 % min. ± 1

Power consumption

< 150 mW

Degree of protection built- in IP 54

with vertical installation with

attached cover

We reserve the right to realise technical and formal changes to the product

in the interest of technical progress.

Our products are under guarantee within the scope of the statutory provisions.

If you have a warranty claim, please contact the point of sale or ship the

device postage free with a description of the fault to our Service -

Center.

Berker GmbH & Co. KG

Abt. Service-Center

Hubertusstraße 17

D- -57482 Wenden Ottfingen

Phone: 0 23 55 / 90 5-0

Fax: 0 23 55 / 90 5- 111

6. B

us connection

Entry of the physical address

Measurement ranges

Selecting the installation location

Installation of the sensor

Installing and maintaining the cover

Technical data

10.

Warranty

310 965 02

Operating instructions

Safety

Use

Produkt Specifikationer

Mærke:	Hager
Kategori:	Ikke kategoriseret
Model:	75492002

Har du brug for hjælp?

Hvis du har brug for hjælp til Hager 75492002 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Hager Manualer

Hager WXF228 Manual

10 August 2025

Hager UKM340480 Manual

10 August 2025

Hager TRC301B Manual

10 August 2025

Hager GS20109011 Manual

10 August 2025

Hager AKB42000402 Manual

10 August 2025

Hager WXT312 Manual

10 August 2025

Hager BKSAN065110 Manual

10 August 2025

Hager VR10127011 Manual

10 August 2025

Hager UKM240280 Manual

10 August 2025

Hager ESR3336029 Manual

10 August 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Waterstone 7800 Manual

11 December 2025

Kwikset 258 Manual

11 December 2025

Schlage F170 Manual

11 December 2025

Moen Align 7565EV Manual

11 December 2025

Energy Sistem ESG M3 Neon Manual

11 December 2025

ALNO MC10244 Manual

11 December 2025

JET TAK-ZX Manual

11 December 2025

Crosley Nashville CF1165 Manual

11 December 2025

Waterstone 1455 Manual

11 December 2025

Laica NE2015 Manual

11 December 2025