Heatit Z-Repeater Manual

Heatit Wifi repeater Z-Repeater

Læs gratis den danske manual til Heatit Z-Repeater (2 sider) i kategorien Wifi repeater. Denne vejledning er vurderet som hjælpsom af 73 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 37 anmeldelser. Har du et spørgsmål om Heatit Z-Repeater, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

INTRODUCTION

The Heatit Z-Repeater Dual USB 2A is a multifunctional AC Z-Wave

range extender with two USB power adapters that allow you to

charge two devices at the same time. Ideal for extending the

Z-Wave signal to areas with blind spots - a solution for anyone

experiencing poor wireless connectivity.

With the rechargeable backup batteries, the device will still be

able to operate for up to 6 hours after a power failure. Important

battery-operated units such as door locks, smoke detectors and

burglary alarms will still work during a blackout.

ADD/REMOVE

The primary controller/gateway has a mode for adding or

removing devices. Please refer to your primary controller manual

on how to set the primary controller in add/remove mode.

The device may only be added or removed from the network if

the primary controller is in add/remove mode. When the device

is removed from the network, it will revert to factory settings.

1. Connect the Heatit Z-Repeater into a power socket.

2. Set the primary controller in add/remove mode (security/

non-security).

3. Within 1,5 seconds press the function button 3 times.

The Heatit Z-Repeater is now successfully added/removed.

Heatit Controls AB can not be held liable for typographical errors, other errors or

omittances in our information. Product specifications may change without further notice.

All electrical installations must be carried out by a licensed electrician. The product must

be installed in accordance with national building codes and our installers manual.

Protocol Z-Wave, 868,4MHz

Chip Z-Wave 500 chip

Rated voltage 240V AC, 50 / 60Hz

Output eect 10W (5V DC 2A)

Battery capacity 200mAh rechargeable batteries

Battery life Maintains mesh network for up to 6 hours in

case of power failure

Ambient temperature 0°C to 45°C

Humidity Max. 85% RH

Plug type Type F (Schuko)

Range RF Min. 40 meters

Size (LxWxH) 66 x 55 x 55mm

Approvals Z-Wave Plus

TECHNICAL DATA

Heatit Controls AB l Läkarvägen 4, 454 31 BRASTAD, SWEDEN

Phone: +47 61 18 77 77 l post@heatit.com – www.heatit.com

Read the full manual at:

manuals.heatit.com

HEATIT Z-REPEATER

Quick Guide

Ver 2020-A

Function

button

Produkt Specifikationer

Mærke:	Heatit
Kategori:	Wifi repeater
Model:	Z-Repeater
Kode for international beskyttelse (IP):	IP20
Vekselstrømsindgangsspænding:	230 V
Vekselstrømsindgangsfrekvens:	50 - 60 Hz
Bredde:	55 mm
Dybde:	66 mm
Højde:	55 mm
Produktfarve:	Hvid
Produkttype:	Netværksgentager
USB-port:	Ja
Relativ luftfugtighed ved drift (H-H):	0 - 85 %
Antal USB 2.0-porte:	2
Driftstemperatur (T-T):	5 - 40 °C
Certificering:	CE
Strømkilde type:	Vekselstrøm
Harmoniseret systemkode (HS):	85176990
Frekvensbånd:	0.868 GHz
Maksimal dataoverførselshastighed:	- Mbit/s
Strømstiktype:	Type F (CEE 7/4)
Indendørs rækkevide:	40m