CSR- Multi-Target Radar IM
Quick Installation and Debugging Procedure
Introduction
The installation and debugging introduction contains the following functions 1 the project installation :( )
personnel can nish the installation of CSR-IM multi-target radar quickly and exactly according to this
introduction. 2 debugging radar by upper computer software, setting up the basic installation and ( ) and
function parameters of radar. 3 installing and adjusting the deection angle and declination angle of ( )
radar according to the value suggested by upper computer.( )4 calibrating the installation deection angle
of radar by the function of one key calibration of upper computer. 5 estimating whether the radar is ( )
running well and calibrated correctly through observing the simulation display of monitoring vehicle by
upper computer software. 6 In the ( ) end, assure to achieve the exact lane judgment ,vehicle snapshot and
vehicle speed information of the vehicles in the monitoring lanes, when the radar triggers the snapshot of
camera in normal scene.
Specication
Antenna:Planar-type microstrip patch array antenna
Operation frequency:24.15GHz
Frequency deviation error ±45 MHz :≤
Emission power about 10 :mW
Operating temperature 70:-40℃~+ ℃
Operating humidity 5%RH 95%RH : ~
Speed measurement range 2 280 km/h :( ~ )
Speed measurement accuracy:±2 km/h
Response time 26ms :
Rated voltage 12V DC :
Rated current 0.5A :
Main installation and debugging procedure
1. Connection of radar and upper computer: achieve the connection of radar and upper computer
correctly, assure the communication running well. and
2. Project installation: install the radar on the portal frame correctly, with proper height, pivoting angle
and declination angle.
3. Radar debugging: set installation parameter of the radar, set function parameter of the radar and make
the calibration and installation debugging of radar.
4. Connecting radar to camera and snapshot: connect radar to camera, then snapshot after the debugging
of the radar.