NORTH AMERICAN SAFETY INSTRUCTIONS
WARNING: This steam wallpaper stripping machine must be grounded.
This steam wallpaper stripping machine shall be grounded while in use to protect the operator
from electric shock. The machine is provided with a three-conductor cord and a moulded three-
contact grounding type attachment plug to fit the proper grounding type receptacle. The Green
(or Green and Yellow) conductor in the cord is the grounding wire. Never connect this wire to
other than the grounding pin of the attachment plug.
This steam wallpaper stripping machine is provided with an attachment plug as shown in sketch
A. It is intended for use on a nominal 120 volt circuit. If a properly grounded receptacle as shown
in sketch A is not available, an adaptor as shown in sketch 'C' should be installed as shown in
sketch B if the outlet box that houses the receptacle is grounded. Be sure to fasten the grounding
tab with a metal faceplate screw.
WARNING: Steam under pressure and hot surfaces.
DO NOT remove or tamper with the steam cap when in operation. If a fault occurs allow steam
stripper to cool for a minimum of 2 minutes. Follow instructions detailed in this manual for fitting
and removing the steam cap.
ATTACHMENT PLUG SKETCH ‘C’
METAL
SCREW
COVER OF GROUNDED
OUTLET BOX SKETCH ‘B’
ADAPTER
GROUNDING
MEANSCOVER OF GROUNDED
OUTLET BOX SKETCH ‘A’
GROUNDING PIN
This manual covers machines starting from the following serial numbers;
(220/240 Volt) (excluding North America)84264
84258 (110/120 Volt) (excluding North America)
75154 (110/120 Volt) (North America)