Honeywell CT30A1005 Manual

Honeywell Termostat CT30A1005

Læs gratis den danske manual til Honeywell CT30A1005 (16 sider) i kategorien Termostat. Denne vejledning er vurderet som hjælpsom af 15 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 8 anmeldelser. Har du et spørgsmål om Honeywell CT30A1005, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/16
Owner’s Manual
English: Page 1
Mode d’emploi
Français : Page 6
Manual de Uso
Español: Página 11
CT30 Series
Low-Voltage Thermostat
M37781
69-2338EFS-04
M23786
MERCURY NOTICE
If your old thermostat contains
mercury, contact your local waste
management authority for proper
disposal instructions.
TURN OFF POWER at heating/cooling system (or fuse/circuit-breaker panel).
Remove cover and thermostat, but leave wallplate with wires attached.
Is there a sealed tube containing mercury?
If so, see mercury notice below.
Leave wallplate in place.
Old thermostat
Cover
Getting started
Remove your old thermostat
Check package contents:
• Thermostat
• Coverplate
• Wall anchors & screws (2 each)
• Caution card
• Wire labels
Before you begin, make sure you have:
• No. 2 Phillips & small pocket screwdrivers
• Hammer
• Level (optional)
• Pencil
• Drill and bit (3/16” for drywall, 7/32” for
plaster)
CT30 Series • Owner's Manual
69-2338EFS—04 2
0
0
0
M23787
Wrap supplied labels securely around each wire. Do not let wires fall into wall opening!
IGNORE WIRE COLORS: Use only letter
designations to identify wire types.
For CT31: If your old thermostat
has 5 or more wires (not counting
terminals C or C1), you may have
purchased the wrong replacement
thermostat. Stop now and call
1-800-468-1502 for advice.
1. Pull wires
through base
(CT31 only).
2. Level base if
desired.
3. Mark positions
of both screw
holes.
For CT30/CT33: If your old
thermostat has 3 or more wires
(not counting terminals C or C1),
you may have purchased the wrong
replacement thermostat. Stop
now and call 1-800-468-1502 for
advice.
Use a screwdriver to disconnect wires one by one. As you disconnect each wire, wrap it with
the label matching the letter on your old thermostat. (Adhesive labels are supplied in your
thermostat package.)
Remove the old wallplate only after all wires are labeled. Be careful not to let loose wires fall into
the wall opening.
Label wires and remove old wallplate
Mark mounting position
CT30/CT33 CT31

Produkt Specifikationer

Mærke: Honeywell
Kategori: Termostat
Model: CT30A1005

Har du brug for hjælp?

Hvis du har brug for hjælp til Honeywell CT30A1005 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Termostat Honeywell Manualer

Honeywell

Honeywell RTH9580WF1005 Manual

14 August 2025
Honeywell

Honeywell YCT30A1003 Manual

14 August 2025
Honeywell

Honeywell RTHL3550D1006 Manual

14 August 2025
Honeywell

Honeywell YCT87K1003 Manual

14 August 2025
Honeywell

Honeywell CT30A1005 Manual

14 August 2025
Honeywell

Honeywell RTH6450D Manual

14 August 2025
Honeywell

Honeywell CT62B1015/U Manual

14 August 2025
Honeywell

Honeywell RTH2310B1002/A Manual

13 August 2025
Honeywell

Honeywell CT53K1006/E Manual

13 August 2025
Honeywell

Honeywell CT87N1001/E1 Manual

13 August 2025

Termostat Manualer

Nyeste Termostat Manualer

Delta Dore

Delta Dore Tybox 137 Manual

17 Oktober 2025
Delta Dore

Delta Dore RF 6600 FP Manual

17 Oktober 2025
Emos

Emos P56A01 Manual

15 Oktober 2025
Fantini Cosmi

Fantini Cosmi C830RL Manual

14 Oktober 2025
UPM

UPM HTM311A Manual

12 Oktober 2025
Bticino

Bticino NT4451 Manual

8 Oktober 2025
Bticino

Bticino HS4451 Manual

7 Oktober 2025
Bticino

Bticino N4451 Manual

7 Oktober 2025
Bticino

Bticino L4451 Manual

7 Oktober 2025
Bticino

Bticino AM5721 Manual

6 Oktober 2025