Honeywell RCHT8600ZW1003/U Manual

Honeywell Termostat RCHT8600ZW1003/U

Læs gratis den danske manual til Honeywell RCHT8600ZW1003/U (60 sider) i kategorien Termostat. Denne vejledning er vurderet som hjælpsom af 57 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 29 anmeldelser. Har du et spørgsmål om Honeywell RCHT8600ZW1003/U, eller vil du spørge andre brugere om produktet?

Side 1/60
RCHT8600 Series Z-Wave
Programmable Thermostat
Quick Installation Guide
Tools you will need Tools you may need
Wire stripper
Needle-nose pliers Drill and drill bit
Included in your box
Small flat head scr
ewdriver
Phillips scr
ewdriver
Pencil
Level
Screws and
anchors
UWP™
Mounting
System
(UWP)
RCHT8600
Thermostat
Quick Install
Guide
2
Quick Installation Guide
Removing your old thermostat
2 Check that your system is off.
Change the temperature on your
old thermostat. If you don’t hear the
system turn on within 5 minutes, the
power is off.
Note: If you have a digital
thermostat that has a blank display,
skip this step
1 Turn power OFF.
To protect yourself and your
equipment, Turn off the power at the
breaker box or switch that controls
your heating/cooling system.
3 Remove the old thermostat’s
faceplate.
On most thermostats, you can take
off the faceplate by grasping and
gently pulling. Some thermostats
may have screws, buttons, or clasps.
Do not remove any wires from your
thermostat at this time!
75
OFF
OFF
ON
Breaker box
Switch
4 Make sure there are no 120/240V
wires.
Do you have thick black wires with
wire nuts?
Is your thermostat 120V or higher?
If you answered yes to either of
these questions, you have a line
voltage system and the thermostat
will not work.
If you are unsure visit:
honeywellhome.com/support
Wire nut
Thick black wire


Produkt Specifikationer

Mærke: Honeywell
Kategori: Termostat
Model: RCHT8600ZW1003/U

Har du brug for hjælp?

Hvis du har brug for hjælp til Honeywell RCHT8600ZW1003/U stil et spørgsmål nedenfor, og andre brugere vil svare dig