Hooker 5107-75310 Manual

Hooker Stol 5107-75310

Læs gratis den danske manual til Hooker 5107-75310 (2 sider) i kategorien Stol. Denne vejledning er vurderet som hjælpsom af 13 personer og har en gennemsnitlig bedømmelse på 3.5 stjerner ud af 7 anmeldelser. Har du et spørgsmål om Hooker 5107-75310, eller vil du spørge andre brugere om produktet?

Side 1/2
1/2
ASSEMBLY INSTRUCTION
Item#: 5107-75310 Ladderback Side Chair-2 per carton
** Please make sure you have all parts indicated below prior to assembly.
Diagram 1 Diagram 2
Assembly Steps:
There are two K/D chairs in one box. Please follow numbers on one chair and letters on another chair during
assembly.
2. Attach back rail of the seat frame (F) to back frame (E) by aligning the holes in center of seat frame and
back frame, then secure with bolt (C) ,lock washer(B) ,at washer(A).
3. Tighten rear corner blocks of seat frame (F) to back legs of frame (E) using bolts (C), lock washers(B) ,at
washers(C). (See diagram 1)
4. Assemble front corner blocks of seat frame (F) with front legs using bolts (C), lock washers (B), at
washers (A). Hand tighten these bolts. (See diagram 2)
5. After all bolts are attaching and hand tightened, turn the chair upright.
6. Level the chair following the chair leveling instructionas below.
2/2
7. Make sure the chair is level and then tighten all bolts completely by using the allen wrench(D).
PLEASE READ THESE INSTRUCTIONS PRIOR TO ASSEMBLING THE
CHAIRS
CHAIR LEVELING INSTRUCTION SUPPLEMENT
Chair leveling procedures:
To make the assembly process easy and ecient, please read the entire instruction sheet prior
to assemb of the chair. Make sure all hardware listed is included. To properly assemble the chair,ling
none of the bolts should be fully tightened until all components are attached to the chair. This will allow an
opportunity to level the chair and prevent any unnecessary rocking.
1. Place the loosely assembled chair on a hard at surface.
2. Apply gentle downward pressure on the seat. This step eliminates rocking and
ensures the chair will be level.
3. Once the chair is level, tighten all bolts and nuts.
Note:
Most oors have slight irregularities that can aect chair leveling. If your chair is
uneven when placed in its desired location, perform the following steps:
1. Loosen front legs to nger tight.
2. Extend both front legs upward to their fullest length.
3. Gently push downward on the front edge of the seat until all four legs rest on the oor.
4. Re-tighten all bolts and nuts.
Cleaning Instruction: Clean nished parts with a damp cloth using a mild dishwashing liquid and water solution.
Polish the nish with soft cloth and an industry recognized furniture polish.


Produkt Specifikationer

Mærke: Hooker
Kategori: Stol
Model: 5107-75310

Har du brug for hjælp?

Hvis du har brug for hjælp til Hooker 5107-75310 stil et spørgsmål nedenfor, og andre brugere vil svare dig