Hooker 5820-75411-84 Manual

Hooker Stol 5820-75411-84

Læs gratis den danske manual til Hooker 5820-75411-84 (2 sider) i kategorien Stol. Denne vejledning er vurderet som hjælpsom af 18 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 9.5 anmeldelser. Har du et spørgsmål om Hooker 5820-75411-84, eller vil du spørge andre brugere om produktet?

Side 1/2
1/2
ASSEMBLY INSTRUCTION
Item#: 5820- 11-84 754 Upholstered Back Arm Chair
** Please make sure you have all parts indicated below prior to assembly.
Assembly Steps:
There are two K/D chairs in one box. Please follow numbers on one chair and letters on the other chair
during assembly.
1. Place chair back on a clean surface.
2. Attach seat frame (L) chair back (J) by using bolt (E), lock washer (B) , at washer (C) at the to
center location T , tighten seat frame (L) to chair back (J) and tighten by Allen Wrench(D). hen by
using bolts (A lock washers at washers (C) and secured by using wrench (D) ), (B), allen at
corners (See diagram 1).
3. Attach front legs (I) seat frame ) by using bolts (A), lock washers (B) ,at washers (C) to (L and
tighten by wrench (D) at corners (See diagram 1). allen
4. After all bolts are attach upright. ed and hand tightened, turn the chair
5. Make sure the chair is level and then tighten all bolts completely using wrench (D). by allen
Diagram 1
2/2
PLEASE READ THESE INSTRUCTIONS PRIOR TO ASSEMBLING THE
CHAIRS
CHAIR LEVELING INSTRUCTION SUPPLEMENT
Chair leveling procedures:
To make the assembly process easy and ecient, please read the entire instruction sheet prior to
assemb of the chair. Make sure all hardware listed is included. To properly assemble the chair, none of ling
the bolts should be fully tightened until all components are attached to the chair. This will allow an
opportunity to level the chair and prevent any unnecessary “rocking”.
1. Place the loosely assembled chair on a hard at surface.
2. Apply gentle downward pressure on the seat. This step eliminates rocking and ensures the chair to
be level.
3. Once the chair is level, tighten all bolts and nuts.
Note:
Most oors have slight irregularities that can aect chair leveling. If your chair is uneven when placed
in its desired location, perform the following steps:
1. Loosen front legs to nger tight.
2. Extend both front legs ward to their fullest length. up
3. Gently push downward on the front edge of the seat until all four legs rest on the oor.
4. -tighten all bolts and nuts. Re
Cleaning Instruction: Clean nished parts with a damp cloth using a mild dishwashing liquid and water solution.
Polish the nish with soft cloth and an industry recognized furniture polish.


Produkt Specifikationer

Mærke: Hooker
Kategori: Stol
Model: 5820-75411-84

Har du brug for hjælp?

Hvis du har brug for hjælp til Hooker 5820-75411-84 stil et spørgsmål nedenfor, og andre brugere vil svare dig