Hotpoint H8F HP51BS UK Manual

Hotpoint Opvaskemaskine H8F HP51BS UK

Læs gratis den danske manual til Hotpoint H8F HP51BS UK (8 sider) i kategorien Opvaskemaskine. Denne vejledning er vurderet som hjælpsom af 13 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 7 anmeldelser. Har du et spørgsmål om Hotpoint H8F HP51BS UK, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/8
EN
Daily Reference Guide
1
THANK YOU FOR BUYING AHOTPOINT PRODUCT.
In order to receive amore complete assistance, please
register your appliance on: www.hotpoint.eu/register
PLEASE SCAN THE
QR CODE ON YOUR
ORDER TO HAVE
MORE DETAILED
Before using the appliance carefully read Safety and Installation Instructions.
After installation, please remember to remove all transport protection parts from
the dishwasher.
APPLIANCE
PRODUCT DESCRIPTION
CONTROL PANEL
1. ON-OFF/Reset button
with indicator light
2. PREVIOUS program button
3. NEXT program button
4. FAVOURITE program button with indicator light
5. Salt reservoir empty indicator light
6. Rinse Aid reservoir empty indicator light
7. DESCALE indicator light
8. Closed Water Tap indicator light
9. Key lock indicator light
10. Program number remaining time and indicator
11. Display
12. 3D Zone Wash option button with indicator light
13. Half Load option Settings button with indicator light/ - 3 sec. press
14. Extra Dry Option button with indicator light - 3 sec. press/ Keylock
15. Delay option button with indicator light
16. START/Pause button with indicator light
The control panel of this dishwasher activates pushing by ON/OFF button.
For energy saving the control panel deactivates automatically after 10 minutes if no cycle has started.
1 2 3 4
12 13
14
15
16
11
5 6 7 8 9 10
1. ActiveDry
2. Top rack
3. Foldable aps
4. Upper rack
5. Upper rack height adjuster
6. Upper sprayer arm
7. Lower rack
8. Cutlery basket
9. 3D Zone Wash
10. Lower sprayer arm
11. Filter Assembly
12. Salt reservoir
13. Detergent and Rinse Aid dispensers
14. Rating plate
15. Control panel
1
2
3
4
5
6
7
8
9
10
11
12
13
1414
15
EN
Daily Reference Guide
2
ADVICE REGARDING THE FIRST TIME USE
After installation, remove the stoppers from the racks and the retaining
elastic elements from the upper rack.
SETTING MENU
1. Switch on the appliance by pressing the button.ON-OFF
2. Hold the Settings (Half Load ) button for 3 seconds, until you hear
a beep and the display shows „SEt”.
3. After one second the rst available setting (letter „ ”) will be displayed.
4. Press PREVIOUS /NEXT to scroll through the list of available settings
(see table below), then press START/Pause to view and change the
value of the currently selected setting.
5. Press PREVIOUS /NEXT to change the value, then press START/Pause
to save the new value and return to the main menu.
6. To change another setting, repeat points 4 and 5.
7. Press or wait 30 seconds to exit the menu.ON-OFF
LETTER
SETTING
VALUES
(Default - )*in bold
Cycle Counter - number of washing cycles
carried out by the dishwasher.
Eg. 25 cycles: 25;
Eg. 13.947 cycles:
13_947
(scrolling
for 3 times)
Water Hardness Level
(see “SETTING THE WATER HARDNESS” and “WA-
TER HARDNESS TABLE”)
1 | 2 | | 4 | 53
Rinse Aid Level
(see “ADJUSTING THE DOSAGE OF RINSE AID”)
0 | 1 | 2 | 3 | 4 | 5
ActiveDry (see “OPTIONS AND FUNCTIONS”)
“1” = On, “0” = O
1 | 0
Sound
“1” = On, “0” = O
1 | 0
Factory Settings - START/Pausepress to re-
store to the factory default all the values of the
settings included in the settings menu.
-
*) The default value does not apply to the Cycle Counter.
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on
the dishes and on the machine’s functional components.
The salt reservoir is located in the lower part of the dish-
washer (under the lower rack on the left side).
• It is mandatory that the salt reservoir never be empty.
• It is important to set the water hardness.
• Salt must be lled when the SALT REFILL indicator light on the control
panel is lit.
1. Remove the lower rack and unscrew the reservoir cap (anticlockwise).
2. Position the funnel (see gure) and ll the salt reservoir right up to its
edge (approximately 0,5 kg); it is not unusual for alittle water to leak out.
3. Only the rst time you do this: ll the salt reservoir with water.
4. Remove the funnel and wipe any salt residue away from the opening.
Make sure the cap is screwed on tightly so that no detergent can get into
the container during the wash program (this could damage the water sof-
tener beyond repair).
Whenever you need to add salt, it is mandatory to complete the pro-
cedure before the beginning of the washing cycle to avoid corrosion.
Residual saline solution or grains of salt can lead to corrosion, irrep-
arably damaging the stainless steel components.
The guarantee is not applicable if faults are caused by such circumstances.
If the salt container is not lled, the water softener and the heating
element may be damaged as a result of limescale accumulation.
Using of Salt is recommended with any type of dishwasher detergent.
SETTING THE WATER HARDNESS
To allow the water softener to work in a perfect way, it is essential that the
water hardness setting is based on the actual water hardness in your house.
This information can be obtained from your local water supplier. The facto-
ry setting is “ See „WATER HARDNESS TABLE”. 3”.
Water Hardness Table
Level
°dH
German degrees
°fH
French degrees
°Clark
English degrees
1 (Soft) 0 - 6 0 - 10 0 - 7
2 (Medium) 7 - 11 11 - 20 8 - 14
3 (Average) 12 - 16 21 - 29 15 - 20
4 (Hard) 17 - 34 30 - 60 21 - 42
5 (Very hard) 35 - 50 61 - 90 43 - 62
To change, follow instructions in section “SETTING MENU”.
Only use salt that has been specically designed for dishwashers.
After the salt has been poured into the machine, the SALT REFILL indicator
light switches o.
If the salt container is not lled, the water softener and the heating
element may be damaged as a result of limescale accumulation.
Using of Salt is recommended with any type of dishwasher detergent.
WATER SOFTENING SYSTEM
Water softener automatically reduces water hardness, consequently pre-
venting scale buildup on the heater, contributing also to better cleaning ef-
ciency. This system regenerates itself with salt, therefore it is required
to rell the salt container when empty.
The frequency of regeneration depends on the water hardness level setting
- regeneration takes place once per Eco cycles with the water hardness 4-6
level set to . The regeneration process occurs at the beginning of the cycle 3
with additional fresh water.
• Single regeneration consumes ~3 L of water;
• Takes up to 5 additional minutes for the cycle;
• Consumes below 0.005kWh of energy.
A
B
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse aid dis-
penser Ashould be lled when the RINSE AID REFILL
indicator light in the control panel is lit.
1. Open the dispenser by pressing and pulling up B
the tab on the lid.
2. Pour in the rinse aid (max. 110 ml), making sure it
does not overow from the dispenser. If this hap-
pens, clean the spill immediately with adry cloth.
3. Press the lid down until you hear aclick to close it.
NEVER pour the rinse aid directly into the appli-
ance tub.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satised with the drying results, you can adjust
the quantity of rinse aid used.
To change, follow the instructions in the section “SETTING MENU”.
If the rinse aid level is set to ZERO, no rinse aid will be supplied. The LOW
RINSE AID indicator light will not be lit if you run out of rinse aid.
A maximum of levels can be set according to the dishwasher model. 6
• If you see bluish streaks on the dishes, set a low number (0-3).
• If there are drops of water or limescale marks on the dishes, set a mid-
range number (4-5).
FILLING THE DETERGENT DISPENSER
Only use detergent which has been specically designed for dishwashers.
DO NOT USE washing up liquid.
Using excessive detergent may result in foam residues remaining in
the machine after the cycle has ended.
Usage of detergent not designed for dishwashers may cause malfunc-
tion or damage to the appliance.
To achieve the best washing and drying results, the combined use of
detergent, rinse aid liquid and rened salt is required.
We recommend using detergents that do not contain phosphates or
chlorine, as these products are harmful to the environment.
Good washing results also depend on the correct amount of detergent
being used.
Exceeding the stated amount does not result in a more eective wash
and increases environmental pollution.
25 ml
35 ml
The amount can be adjusted to the soil lev-
el. In the case of normally soiled items, use
approximately either 35g (powder deter-
gent) or 35ml (liquid detergent) and addi-
tional tea spoon of detergent directly in-
side the tub. If tablets are used, one tablet
will be enough.
If the crockery is only lightly soiled or if
it has been rinsed with water before be-
ing placed in the dishwasher, reduce the
amount of detergent used accordingly (minimum 25 g/ml) e.g. skip the
powder/gel putted inside the tub.
For good washing results also follow the instructions shown on the
detergent box.
For further questions please ask the detergent producers.
FIRST TIME USE

Produkt Specifikationer

Mærke: Hotpoint
Kategori: Opvaskemaskine
Model: H8F HP51BS UK

Har du brug for hjælp?

Hvis du har brug for hjælp til Hotpoint H8F HP51BS UK stil et spørgsmål nedenfor, og andre brugere vil svare dig


Opvaskemaskine Hotpoint Manualer

Hotpoint

Hotpoint HI 3010 Manual

2 August 2025
Hotpoint

Hotpoint HSIO 3O23 WFE dishwasher Manual

2 August 2025
Hotpoint

Hotpoint HIC 3O33 WLEG Manual

1 August 2025
Hotpoint

Hotpoint HFC 2B19 X Manual

1 August 2025
Hotpoint

Hotpoint HIC 3C41 CW Manual

1 August 2025
Hotpoint

Hotpoint HFC 3C32 WX Manual

1 August 2025
Hotpoint

Hotpoint HIC 3C34 Manual

1 August 2025
Hotpoint

Hotpoint HSIC 3T127 C Manual

1 August 2025
Hotpoint

Hotpoint HBC 3C41 W Manual

1 August 2025
Hotpoint

Hotpoint ELTB 4B019 EU Manual

1 August 2025

Opvaskemaskine Manualer

Nyeste Opvaskemaskine Manualer

Neff

Neff S145HTS01G Manual

12 September 2025
Whirlpool

Whirlpool ADP 4736 IX Manual

12 September 2025
Barazza

Barazza 1LVE6I Manual

12 September 2025
Robinhood

Robinhood DWM12P6FSS Manual

12 September 2025
Siemens

Siemens SK25210EU Manual

12 September 2025
Fagor

Fagor 4LVF-435AD Manual

12 September 2025
Siemens

Siemens SN46M293SK Manual

11 September 2025
Gorenje

Gorenje GV693A60UVAD Manual

11 September 2025
Bosch

Bosch SMS40E38EU Manual

11 September 2025
Hoonved

Hoonved C 60 D E Manual

10 September 2025