Hotpoint HSFE 1B19 S UK N Manual

Hotpoint Opvaskemaskine HSFE 1B19 S UK N

Læs gratis den danske manual til Hotpoint HSFE 1B19 S UK N (8 sider) i kategorien Opvaskemaskine. Denne vejledning er vurderet som hjælpsom af 31 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 16 anmeldelser. Har du et spørgsmål om Hotpoint HSFE 1B19 S UK N, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/8
EN
1
Before using the appliance carefully read Safety Instructions guide.
APPLIANCE
1. Upper rack
2. Foldable aps
3. Upper rack height adjuster
4. Upper spray arm
5. Lower rack
6. Cutlery basket
7. Lower spray arm
8. Filter Assembly
9. Salt reservoir
10. Detergent and Rinse Aid dispensers
11. Rating plate
12. Control panel
0000 000 00000
Service:
1
2
3
4
5
6
7
9
8
1011
12
1 2 3 4 56 7 8
DAILY REFERENCE
GUIDE
CONTROL PANEL
THANK YOU FOR BUYING A HOTPOINT PRODUCT.
In order to receive a more complete assistance, please
register your appliance on: www.hotpoint.com/register
You can download the Safety Instructions and the User
Manual, by visiting our website docs.hotpoint.eu and
following the Instructions on the back of this booklet.
PRODUCT DESCRIPTION
1. On-O/Reset button with indicator light
2. Tablet (Tab) button with indicator light
3. Salt rell indicator light
4. Rinse Aid rell indicator light
5. Program selection knob
6. Delay indicator light
7. Delay button with indicator light
8. Start/Pause button with indicator light / Drain out
2
FIRST TIME USE
SALT, RINSE AID AND DETERGENT
ADVICE REGARDING THE FIRST TIME USE
After installation, remove the stoppers from the racks and the retaining
elastic elements from the upper rack.
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes
and on the machine’s functional components.
• It is mandatory that THE SALT RESERVOIR NEVER BE EMPTY.
• It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher
(see PRODUCT DESCRIPTION) and must be lled when the SALT REFILL
indicator light in the control panel is lit .
1. Remove the lower rack and unscrew the
reservoir cap (anticlockwise).
2. Only the rst time you do this: ll the salt
reservoir with water.
3. Position the funnel (see gure) and ll the salt
reservoir right up to its edge (approximately
1 kg); it is not unusual for a little water to leak
out.
4. Remove the funnel and wipe any salt residue
away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can
get into the container during the wash program (this could damage
the water softener beyond repair).
Whenever you need to add salt, it is mandatory to complete
the procedure before the beginning of the washing cycle to avoid
corrosion.
SETTING THE WATER HARDNESS
To allow the water softener to work in a perfect way, it is essential that
the water hardness setting is based on the actual water hardness in your
house. This information can be obtained from your local water supplier.
The factory sets the default value for the water hardness:
• Switch on the appliance by pressing the button.ON/OFF
• Switch o the appliance by pressing the button.ON/OFF
• Hold down button START/Pause for 5 seconds.
• Switch on the appliance by pressing the button.ON/OFF
• The ON/OFF LED light will ash as many times as the level that was set.
• Set the desired water hardness level using the PROGRAM SELECTION
knob (see WATER HARDNESS TABLE).
• Switch o the appliance by pressing the button.ON/OFF
Setting is complete!
As soon as this procedure is complete, run a program without loading.
Only use salt that has been specically designed for dishwashers.
After the salt has been poured into the machine, the SALT REFILL
indicator light switches o.
If the salt container is not lled, the water softener and the heating
element may be damaged as a result of limescale accumulation.
Using of Salt is recommended with any type of dishwasher
detergent.
Water Hardness Table
Level °dH
German degrees
°fH
French degrees
°Clark
English degrees
1 Soft 0 - 6 0 - 10 0 - 7
2 Medium 7 - 11 11 - 20 8 - 14
3 Average 12 - 16 21 - 29 15 - 20
4 Hard 17 - 34 30 - 60 21 - 42
5 Very hard 35 - 50 61 - 90 43 - 62
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse aid dispenser should A
be lled when the indicator light in the control RINSE AID REFILL
panel is lit.
1. Open the dispenser by pressing and pulling up the tab on the lid.B
2. Pour in the rinse aid (max.110 ml), making sure it does not overow
from the dispenser. If this happens, clean the spill immediately with
a dry cloth.
3. Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the appliance tub.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satised with the drying results, you can
adjust the quantity of rinse aid used.
• Switch the dishwasher on using the button.ON/OFF
• Switch it o using the button.ON/OFF
• Press button START/Pause three times.
• Switch it on using the button.ON/OFF
• The START LED light will ash as many times as the level that was set.
• Set the level of rinse aid quantity to be supplied using the PROGRAM
SELECTION knob (see PROGRAMS TABLE).
• Switch it o using the buttonON/OFF
Setting is complete!
If the rinse aid level is set to 1 (ECO), no rinse aid will be supplied.
A maximum of 5 levels can be set according to the dishwasher model.
The factory setting is specic to the model, please follow instruction
above to check this for your machine
• If you see bluish streaks on the dishes, set a low number (2-3).
• If there are drops of water or limescale marks on the dishes, set a mid-
range number (4-5).
FILLING THE DETERGENT DISPENSER
To open the detergent dispenser use the opening device C.
Introduce the detergent into the dry dispenser D only. Place
the amount of detergent for pre-washing directly inside the tub.
1. When measuring out the detergent
refer to the mentioned earlier
information to add the proper
quantity. Inside the dispenser
D there are indications to help
the detergent dosing.
2. Remove detergent residues from
the edges of the dispenser and close
the cover until it clicks.
3. Close the lid of the detergent
dispenser by pulling it up until
the closing device is secured
in place.
The detergent dispenser automatically opens up at the right time
according to the program.
If all-in-one detergents are used, we recommend using the TABLET
button, because it adjusts the program so that the best washing and
drying results are always achieved.
Usage of detergent not designed for dishwashers may cause
malfunction or damage to the appliance.
A
B
C
D

Produkt Specifikationer

Mærke: Hotpoint
Kategori: Opvaskemaskine
Model: HSFE 1B19 S UK N

Har du brug for hjælp?

Hvis du har brug for hjælp til Hotpoint HSFE 1B19 S UK N stil et spørgsmål nedenfor, og andre brugere vil svare dig


Opvaskemaskine Hotpoint Manualer

Hotpoint

Hotpoint H8F HP51BS UK Manual

25 Juli 2025
Hotpoint

Hotpoint H8F HP51X UK Manual

25 Juli 2025
Hotpoint

Hotpoint HA7IA15B2M6LS0 Manual

16 Juli 2025
Hotpoint

Hotpoint HA6IB16B2M6LS0 Manual

16 Juli 2025
Hotpoint

Hotpoint HA6IC16B4M6H0 Manual

16 Juli 2025
Hotpoint

Hotpoint HA2IE10CS80 Manual

15 Juli 2025
Hotpoint

Hotpoint HSIC 3M27 C S Manual

15 Juli 2025
Hotpoint

Hotpoint HA4ID11CS80 Manual

20 Juni 2025
Hotpoint

Hotpoint HA6IB16B2M6L0 Manual

19 Juni 2025
Hotpoint

Hotpoint HA6IA14BN7A0 Manual

18 Juni 2025

Opvaskemaskine Manualer

Nyeste Opvaskemaskine Manualer

BEKO

BEKO BDFS16030W Manual

30 Juli 2025
BEKO

BEKO BDFN36540PA Manual

30 Juli 2025
BEKO

BEKO BDFN15440B Manual

30 Juli 2025
Fisher & Paykel

Fisher & Paykel DW60U4EI3 Manual

30 Juli 2025
BEKO

BEKO BDFN26451W Manual

30 Juli 2025
BEKO

BEKO BDFN15440G Manual

30 Juli 2025
Haier

Haier XF 4A4M0W-80 Manual

30 Juli 2025
BEKO

BEKO BDFN15440W Manual

30 Juli 2025
Kernau

Kernau KDI 6753 Manual

29 Juli 2025
Candy

Candy CH 3E7F0S Manual

29 Juli 2025