Hughes & Kettner MSM-1 Manual


Læs gratis den danske manual til Hughes & Kettner MSM-1 (10 sider) i kategorien Netværkskort/adapter. Denne vejledning er vurderet som hjælpsom af 46 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 23.5 anmeldelser. Har du et spørgsmål om Hughes & Kettner MSM-1, eller vil du spørge andre brugere om produktet?

Side 1/10
Hughes & Kettner MSM-1 User Manual
Note: These instructions were written specifically for the Hughes & Kettner ATTAX preamp, but they apply
equally to the MIDI-upgradeable amps from Hughes & Kettner: the TriAmp head and combo, the TUBE 50
head/combo and TUBE 100 head, the ATTAX 100 and ATTAX 200 heads and combo amps, and the
BassBase 600 head. More follow this document.general installation instructions
Installation
1. Connections and Control Features
2. MIDI Functions
3. Standard Setup and Cable Connections
4. Short Instructions
Operation
1. Selecting MIDI Channels and the Omni Mode
2. Storing Your Presets
3. Activating Stored Presets via MIDI
Additional MIDI Setups
Troubleshooting
INSTALLATION PROCEDURE: MSM-1 into the ATTAX PREAMP
The ATTAX and the MSM-1 MIDI SWITCHING MODULE are electronic devices that operate on AC power. If
you are not qualified to install the MSM-1, you are risking a potentially life-threatening electric shock. Do
yourself a favor and ensure you leave the installation to an authorized dealer only, both a safety and a
warranty requirement. It takes just a few minutes, and it is well worth waiting for.
Proceed as follows:
Switch the ATTAX off.
Remove the AC mains power cord from the back of the unit.
Remove the four screws from rear panel cover plate and then remove the cover plate.
Remove the screws from the top of the chassis.
Lift the chassis cover off.
Insert the MSM-1 in the module chamber and fasten it to the chassis using the four screws. Ensure the
electronic components and the module inscriptions are facing up.
Connect the MSM-1 to the ATTAX by carefully plugging the ribbon cable’s connectors to the
appropriate socket. Note the markings on the connectors and ensure they face the grooved portion of
the socket when you plug the connectors in.
Seite
1
von
10
Hughes & Kettner MSM
1 User Manual
22.08.2007
file://C:\Dokumente und Einstellungen\RForse\Desktop\msm1manual.htm
Ensure the connector fits snugly and the connector markings match the socket’s grooved portion.
Check all connections carefully. Then:
Replace and fasten the chassis cover.
Plug in the AC mains cable. Switch on the power.
Press all front panel buttons, one after the other, to make sure the ATTAX functions properly.
The ATTAX should respond to each button as it did before you installed the module (refer to the
ATTAX manual).
Follow the steps described in to ensure that the MSM-1 functions properly. Short Instructions
CONNECTIONS AND CONTROL FEATURES
1. MIDI IN JACK
The MIDI IN jack is designed to receive MIDI data. Any device capable of generating MIDI data can be
connected here via its MIDI OUT jack. In most cases, a MIDI FOOT CONTROLLER or MIDI EFFECTS UNIT
is the device you will use.
2 MIDI THRU JACK
The MIDI THRU jack is used if you want to relay incoming MIDI messages to an additional MIDI device, e.g.
an effects processor. Simply connect the device’s MIDI IN to the MSM-1 's MIDI THRU. This enables you to
address the ATTAX and one or more additional devices via a single MIDI command.
3 MIDI RECEIVE CHANNEL SWITCH
This five-way DIP switch determines on which MIDI channels the MSM-1 receives MIDI messages. You can
select a single CHANNEL (1 through 16), or all MIDI CHANNELS at once.
MIDI LEARN BUTTON (front panel)
Seite 2 von 10Hughes & Kettner MSM-1 User Manual
22.08.2007
file://C:\Dokumente und Einstellungen\RForse\Desktop\msm1manual.htm


Produkt Specifikationer

Mærke: Hughes & Kettner
Kategori: Netværkskort/adapter
Model: MSM-1

Har du brug for hjælp?

Hvis du har brug for hjælp til Hughes & Kettner MSM-1 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Netværkskort/adapter Hughes & Kettner Manualer

Netværkskort/adapter Manualer

Nyeste Netværkskort/adapter Manualer